Search

This paper discusses the major issues that exist in the single-stage ac/dc converters with power factor correction (PFC) and presents a novel converter based on a quasi-active PFC scheme. Two additional windings wound in the transformer of a conventional dc/dc flyback converter are used to drive and achieve continuous current mode operation of an input inductor. In addition, direct energy transfer paths are provided through the additional windings to improve the conversion efficiency and to reduce the dc bus capacitor voltage below 450 V for universal line applications. The proposed converter can be easily designed to comply with IEC 61000-3-2 Class D requirement and to achieve fast output voltage regulation. By properly tuning the converter parameters, a good tradeoff between efficiency, dc bus capacitor voltage stress, and harmonic content can be achieved. Operating principles, analysis, and experimental results of the proposed method are presented. [ABSTRACT FROM PUBLISHER]

A photovoltaic (PV)-based stand-alone power system is usually used to manage the energy supplied from several power sources such as PV solar arrays and battery and deliver a continuous power to the users in an appropriate form. Traditionally, three different dc/dc converters would have been used. To reduce the cost and improve the power density of the power system, an integrated solution of PV isolated dc/dc three-port converter (TPC) is proposed in this paper. Zero current switching can be achieved for all main diodes and MOSFETs to improve the efficiency, and a continuous input current of solar array is maintained by adding a magnetic switch derived from a fourth winding of the half-bridge transformer. Based on the energy-balancing part formed by boost, the control methods for the single module to realize maximum power point tracking (MPPT), battery charge control, and main bus regulation are proposed. The power system control method for multimodules in parallel is also derived, and the operation of the TPC power system can be transited between conductance mode and MPPT mode automatically. Finally, the experimental results verify that the proposed TPC, together with the proposed control method, meets the requirements of a high-power-density stand-alone PV-battery power system. [ABSTRACT FROM PUBLISHER]

This paper presents a new application of power and voltage balance control schemes for the cascaded H-bridge multilevel inverter (CHMI)-based solid-state transformer (SST) topology. To reduce load on the controller and simplify modulation algorithm, a master–slave control (MSC) strategy is designed for the dual active bridge (DAB) stage. The master controller executes all control and modulation calculations, and the slave controllers manage only device switching and protection. Due to the inherent power and dc-link voltage unbalance in cascaded H-bridge-based SST, this paper presents a compensation strategy based on three-phase dq decoupled current controller. An optimum zero-sequence component is injected in the modulation scheme so that the three-phase grid currents are balanced. Furthermore, to tightly regulate the output voltage of all the DAB modules to target value, a dynamic reference voltage method is also implemented. With this proposed control method, the three-phase grid currents and dc-link voltage in each module can be simultaneously balanced. Finally, simulation and experimental results are presented to validate the performance of the controller and its application to microgrid SST. [ABSTRACT FROM PUBLISHER]