Search

In this article, two compact three-phase multilevel inverters are proposed. The first proposed topology consists of three dc sources and ten power switches. The merit of the first proposed topology is reducing two switches from its structure to the conventional topologies. The second proposed topology is similar to the first one, except that one of the dc sources is replaced by a capacitor. This capacitor is balanced by an additional switch and one of the dc sources. How to apply two modulation methods for these inverters has been studied in detail. These modulation methods are level-shifted pulsewidth modulation and phase-shifted pulsewidth modulation (PS-PWM). Also, the value of the capacitor for each of the modulation methods has been calculated. Finally, the experimental results are provided to confirm the performance of the proposed topologies. [ABSTRACT FROM AUTHOR]

In this article, a new soft switching isolated push–pull dc–dc converter using a three-winding transformer is proposed. The proposed hybrid resonant and pulse width modulated converter employs a conventional push–pull structure in the primary side, a voltage doubler in the secondary side, and a bidirectional switch besides the transformer, altogether help offering a high efficiency over a wide range of input and output voltage signals with an unsophisticated fixed-frequency control mechanism. The primary-side switches are commutated under zero voltage switching with low switching current and the secondary-side diodes are commutated under zero current switching. In this article, we first present an in-depth analysis of various operation modes and design constraints. Our analysis is further complemented with a comprehensive reliability evaluation of the proposed converter under various short circuit and open circuit fault scenarios. Different from the previous research, the derated operating states of the proposed converter are detailed and characterized in the reliability evaluations. A comparison study is then provided to evaluate the performance of the proposed converter against other similar converters from the operation, components count, efficiency, and reliability perspectives. Finally, the theoretical analyses are verified via tests and experiments performed on a 280 W/34.7 kHz prototype. [ABSTRACT FROM AUTHOR]

This paper proposes a new topology for bidirectional multiinput direct dc–ac converter for clean-power-generation system, therefore, at the input port, a boost converter is used to meet the requirement of many distributed generation systems, such as photovoltaic, and fuel cell systems. The boost converter can increase the dc input voltage. This point results in a turn ratio reduction of high-frequency isolating link transformer. Furthermore, the boost inductor reduces the input current ripple, therefore, the saturation of the transformer can be avoided for higher output currents. The count of used devices has been reduced in the proposed converter. As a result, the cost, size, and the volume of the converter can be reduced. The reduced conversion steps increase the efficiency of the converter. The converter is analyzed step by step to show the principles of the operation in providing energy management based on duty-cycle variations. The system capability in different operation conditions has been simulated, and the simulation results have been compared with measurement results. Dynamic analysis and control design of the bidirectional dc–ac converter is presented based on nonlinear control by input–output feedback linearization. [ABSTRACT FROM AUTHOR]