Search

For the application of forged medium-Mn steels on flywheel rotors, the effect of annealing temperatures from 300 °C to 650 °C on the impact toughness of 0.16C-6.5Mn forged steel was investigated to demonstrate the microstructural characteristics and austenite reverse transformation determining the impact toughness. The results obtained through standard Charpy V-notch impact tests at ambient temperature show that the impact absorbed energy holds at lower than 10 J almost constantly at annealing temperatures of 300 °C to 500 °C, and a representative intergranular fracture is presented. At an annealing temperature of 600 °C, the impact absorbed energy increases to 147 J, with the ductile fracture characteristics showing plenty of fine dimples, and the high impact toughness is attributed to the high volume fraction above 30% and the moderate stability of reverted austenite. Subsequently, the annealing temperature rises higher than 600 °C, the impact absorbed energy decreases, and the fracture morphology shows brittleness characterized by more flat facets of intergranular fractures and small quasi-cleavage facets, presumably corresponding to the insufficient transformation and twinning-induced plasticity effect due to weakening the Mn partitioning from quenched martensite to reverted austenite, which results in lower austenitic stability. Furthermore, the ductile-to-brittle transition temperature (DBTT) of the 0.16C-6.5Mn forged steel annealed at 600 °C, which holds the highest impact absorbed energy, and is explored for the possibility of flywheel rotor application in a service environment. The DBTT reaches −21 °C, obtained through the Boltzmann function, and the impact absorbed energy is approximately 72 J. [ABSTRACT FROM AUTHOR]

The impact behaviors of N‐bearing QN1803 and 304 stainless steels are studied using instrumented Charpy impact test in the range of −192–100 °C. The fracture and deformation substructures are systematically investigated by scanning electron microscopy and transmission electron microscopy. The results show that QN1803 presents ductile–brittle transition temperature (DBTT) and 304 shows ductile fracture. With increasing temperature, the stacking fault energy (SFE) of QN1803 and 304 increases, but the former is always lower than the latter. QN1803 presents low impact toughness with low‐density dislocation at −192 °C. At high temperature, QN1803 and 304 show good impact toughness and the deformation substructures are dominated by high‐density dislocations and deformation twinning. [ABSTRACT FROM AUTHOR]