Search

In this article, a 2.5m five-stage inductive power transfer (IPT) system based on domino cylindrical solenoid coupler (CSC) compensated, respectively, in layers is proposed. The system is considered to be used as 220 kV post insulators application, transferring power for sensors and measuring instruments of smart grids. The distributed series compensation method is applied to double-layer CSC. Compared with the two types of parallel schemes, this method can significantly reduce the current of the main circuit. Compared with the concentrated series compensation method, this method can effectively reduce the resistance caused by the stray capacitance. The interaction between the post insulator and the magnetic coupling structure is analyzed. The circuit model of the system with constant voltage output characteristics is analyzed. A prototype with a maximum efficiency of 66.7% is built. When the power is transferred to a larger value of 77.8W, the efficiency can still reach 62%. Comparing with previous works, the wireless distance is extended while the efficiency is improved. [ABSTRACT FROM AUTHOR]

Passive diode bridge rectifier with LC filter is widely used in wireless power transfer (WPT) system due to its simple structure and uncontrolled characteristics. However, as the load resistance decreases, its input phase angle will also decrease rapidly until it shows obvious capacitive. Therefore, a novel rectifier topology with an input-series inductor (hereafter called ISIR) is proposed in this article to solve this problem. What is more, the ISIR can avoid the duty cycle loss and improve the dc–dc efficiency. First, the mechanism of ISIR is analyzed in detail combined with the operating status of topology. Then, the inductance and compensation parameters are determined based on theoretical calculation and simulation results. Finally, a prototype with a maximum load of 7 Ω is built to validate the feasibility and effectiveness of ISIR, and 88% efficiency is achieved under this condition. Compared with the traditional method, it has increased by 1.05%. The maximum efficiency of WPT system is as high as 91.14% with the proposed ISIR. [ABSTRACT FROM AUTHOR]

Inductive power transmission has been applied in industries, such as electric vehicles, consumer electronics and biomedical fields. However, there is a long-term key problem in this field that has not been solved. This is the adverse effect of the parasitic capacitance of the coil, which will cause the change of the coil inductance, the reduction of the quality factor and the reduction of efficiency. Especially in the field of long-distance wireless power transmission. The existing technologies all adopt the scheme of sacrificing volume in exchange for the quality factor of the coil. As a result, the volume of the system is very large, and the quality factor of the coil is still not high enough because the influence of parasitic capacitance has not been completely eliminated. Here, we found the solution. Connect compensation capacitors in series to the coil sections to short-circuit the parasitic capacitance and reduce its loss. The designed system has a diameter of 502 mm and a thickness of 22 mm, which can transmit 115.2 W of power within a distance of two meters with an efficiency of 29%. [ABSTRACT FROM AUTHOR]

With the increase of load resistance, the impedance angle of the rectifier with passive C filter also increases, which may have some negative effects on the characteristics of the inductive power transfer (IPT) system. This article presents an impedance analysis method for C-filter rectifiers in continuous conduction mode. The calculation formula of critical load resistance is given and the relevant values are calculated. An improved C-filter rectifier circuit is proposed to reduce the phase angle of the IPT system. A very tiny capacitance is connected in parallel at the input end of the rectifier to reduce the impedance angle as load resistance changes, with hardly increased costs. This improved method not only improves the system efficiency, but also reduces the fluctuation of output voltage or current. Simulation and experiment results verify the feasibility of the proposed topology. A 1 kW prototype with primary series, secondary series compensation topology was built. The maximum system efficiency from dc power supply to the load is 94.5%. The efficiency under rated load is as high as 93%. Compared with traditional method, it has increased by 0.6%. [ABSTRACT FROM AUTHOR]