Search

Three-phase four-wire grid-forming (GFM) inverters are promising to interface distributed energy resources into low-voltage networks. However, these inverters are prone to overcurrent under grid faults. Physically increasing the inverter current capacity is not cost-effective to cope with complicated fault conditions. In this article, an adaptive fault ride-through (FRT) scheme based on instantaneous saturators and virtual negative- and zero-sequence resistances is proposed. It features not only overcurrent limitation by modifying voltage references, but also seamless transition between normal and grid fault conditions. The proposed FRT scheme is first analyzed from different aspects, including the virtual sequence resistances, grid short-circuit ratio, fault types, and fault levels. The virtual sequence resistances are then designed to be adaptive to ensure high voltage quality at the healthy phase. The proposed FRT scheme is verified by MATLAB/Simulink simulations under asymmetrical faults. A laboratory platform with a grid-connected 3kW GFM inverter is further constructed to demonstrate its effectiveness (a video of the experimental results under three asymmetrical faults is attached). [ABSTRACT FROM AUTHOR]

Unlike a synchronous generator that could withstand a large overcurrent, an inverter-based distributed generation (DG) has low thermal inertia, and the inverter is likely damaged by overcurrents during grid faults. In this article, a new strategy, namely positive- and negative-sequence limiting with stability enhanced P-f droop control (PNSL-SEPFC), is proposed to limit the output currents and active power of droop-controlled inverters in islanded microgrids. This strategy is easy to implement in the inverter controller and does not require any fault detection. Inverter stability is analyzed mathematically, which gives guidelines to design the parameters of the PNSL-SEPFC strategy. PSCAD/EMTDC simulation based on a four-DG microgrid shows that the proposed PNSL-SEPFC can limit inverter output currents and powers with better performance under both symmetrical and asymmetrical faults. Furthermore, hardware experiments demonstrate that the proposed PNSL-SEPFC can ensure the inverters riding through grid faults safely and stably. (A video of experimental waveforms is attached.) [ABSTRACT FROM AUTHOR]

In microgrids, intermittency of renewable energy sources (RES) and uncertain state-of-charge (SoC) of energy storage systems (ESS) can cause power deficiency to some distributed generation units (DGs). In this case, DGs with power deficiency may not meet the power demand, resulting in voltage collapse or frequency divergence. Unfortunately, this is seldom considered in inverter control design in existing literature. Thus, in-depth investigation into the microgrid performance under renewable energy resource fluctuations and appropriate control methods are urgently needed. In this article, an adaptive droop and adaptive virtual impedance control strategy is proposed. Unlike conventional droop control where the droop coefficients are fixed by assuming the DGs can always meet the load demand, the droop coefficients here are adjusted according to actual solar PV power output. In this way, proper power sharing among DGs can be achieved under renewable energy variation. Furthermore, the impact of varying DG capacities on system stability is mathematically investigated. An adaptive virtual impedance is then incorporated into the adaptive droop method to deal with the system instability caused by renewable energy variations. The proposed strategy is analyzed theoretically and validated in MATLAB/Simulink simulation and laboratory experiments. The results demonstrate the advantages of the proposed method over conventional approaches under various scenarios. [ABSTRACT FROM AUTHOR]

This letter presents a novel model predictive control strategy without involving any proportional-integral-differential regulators for practical renewable energy based ac microgrids. The proposed method consists of a model predictive power control (MPPC) scheme and a model predictive voltage control (MPVC) scheme. By controlling the bidirectional buck-boost converters of the battery energy storage systems based on the MPPC algorithm, the fluctuating output from the renewable energy sources can be smoothed, while stable dc-bus voltages can be maintained as the inverters' inputs. Then, the parallel inverters are controlled by using a combination of the MPVC scheme and the droop method to ensure stable ac voltage output and proper power sharing. Compared with the traditional cascade control, the proposed method is simpler and shows better performance, which is validated in simulation on MATLAB/Simulink and on real-time laboratory platform. [ABSTRACT FROM AUTHOR]