Search

Phosphorus removal from synthetic solutions by raw and calcined powdered marble wastes (RPMW and CPMW) has been investigated in batch mode under different experimental conditions. The results showed that RPMW and CPMW have high removal efficiencies, especially in acidic media. The maximum phosphorus removal capacities were evaluated to 103.9 and 181.2 mg·g −1 at an initial pH and an aqueous concentration of 5 and 350 mg·L −1 , respectively. Phosphorus removal by RPMW occurred mainly through adsorption. However, for CPMW, phosphorus was removed not only by adsorption, but also by precipitation as calcium phosphate complexes. Specific analyses using scanning electron microscopy, energy dispersive spectroscopy, X-ray diffraction and Fourier transform infrared spectroscopy confirmed that this precipitate is most probably hydroxyapatite. On the other hand, CPMW have demonstrated an important ability in removing phosphorus from highly concentrated dairy wastewater ( C 0,P = 1000 mg·L −1 ) since only one dosage of 10 g·L −1 was enough to ensure more than 97% of phosphorus removal. [ABSTRACT FROM AUTHOR]

During the last decade, biochars have been considered as attractive and eco-friendly materials with various applications including wastewater treatment, energy production and soil amendments. However, the important nitrogen losses during biochars production using the pyrolysis process have limited their potential use in agriculture as biofertilizer. Therefore, it seems necessary to enrich these biochars with nitrogen sources before their use in agricultural soils. This paper is the first comprehensive review on the assessment of biomass type and the biochars' properties effects on N recovery efficiency from aqueous solutions as well as its release and availability for plants when applying the N-enriched chars in soils. In particular, the N recovery efficiency by raw biochars versus the type of the raw feedstock is summarized. Then, correlations between the adsorption performance and the main physico-chemical properties are established. The main mechanisms involved during ammonium (NH 4 –N) and nitrates (NO 3 –N) recovery process are thoroughly discussed. A special attention is given to the assessment of the biochars physico-chemical modification impact on their N recovery capacities improvement. After that, the application of these N-enriched biochars in agriculture and their impacts on plants growth as well as methane and nitrous oxide greenhouse gas emissions reduction are also discussed. Finally, the main future development and challenges of biochars enrichment with N from wastewaters and their valorization as biofertilizers for plants growth and greenhouse gas (GHG) emissions reduction are provided. This systematic review is intended to promote the real application of biochars for nutrients recovery from wastewaters and their reuse as eco-friendly fertilizers. [Display omitted] • Biochars have low nitrogen contents which limit their use in agriculture. • Biochars hybrid modifications allow high recovery yields of ammonium and nitrates. • N-laden biochars promote the seedling stage and the vegetative growth. • N-enriched biochars significantly reduce the N 2 O and CH 4 emissions. • N-enriched biochars promote sustainability and circular economy concepts. [ABSTRACT FROM AUTHOR]

In the present study, methylene blue (MB) removal from aqueous solutions via the photocatalytic process using TiO2 as a catalyst in the presence of external ultra-violet light (UV) was investigated. The results of adsorption in the absence of UV radiation showed that adsorption reached an equilibrium state at 60 min. The experimental kinetic data were found to be well fitted by the pseudo-second-order model. Furthermore, the isotherm study suggested that dye uptake by TiO2 is a chemisorption process with a maximum retention capacity of 34.0 mg/g. The photodegradation of MB was then assessed under various experimental conditions. The related data showed that dye mineralization decreased when dye concentrations were increased and was favored at high pH values and low salt concentrations. The simultaneous presence of organic and inorganic pollution (Zinc) was also evaluated. The effect of the molar ratio Zn2+/MB+ in the solution at different pH values and NaCl concentrations was also monitored. The corresponding experimental results showed that at low values of Zn2+ in the solution (30 mg/L), the kinetic of the MB removal became faster until reaching an optimum at Zn2+/MB+ concentrations of 60/60 mg/L; it then slowed down for higher concentrations. The solutions' carbon contents were measured during the degradation process and showed total mineralization after about 5 h for the optimal Zn2+/MB+ condition. [ABSTRACT FROM AUTHOR]

Pyrolysis is a thermochemical process that permits the conversion of biomasses into energy (bio-oil and biogas) and a solid residue called biochar. The generation of biochar from lignocellulosic materials has been, for longtime, the predominant research focus. Wastewater treatment plants produce huge amounts of sludge biomass and there exists an increasing evidence for their possible reuse as a promising pyrolysis feedstock in recent literature. Though the valorization of biochars generated from lignocellulosic biomasses has been the subject of many reviews, there exists a critical knowledge gap regarding the effect of synthesis conditions of the sludge-derived biochars (SDBs) on their efficiency in the treatment of wastewater. This review critically analyzes the available literature related to SDBs characteristics and application to adsorb inorganic and organic pollutants from effluents. The physico-chemical properties and adsorption efficiency of SDBs are mainly tuned by the nature of raw sludge, pyrolysis conditions, and pre/post-treatments. Indeed, biochars originating from digested sludge have better adsorption capacities towards nutrients and heavy metals compared to those obtained from the non-digested sludge. The nutrients recovery from urban wastewater could be significantly improved when the raw sludge is mixed with lignocellulosic biomass and Mg/Ca rich materials. On the other hand, the chemical activation of sludge at reagent/sludge ratios higher than 2:1 permits to generate SDBs with adsorption capacities comparable and even better than commercial activated carbons. Moreover, the embedment/coating of SDBs with specific nanomaterials and tailored functional groups could significantly improve the adsorption capacities of various organic toxic pollutants and at the same time enhance their chemical degradation. The effect of the nature of target pollutants (organic or inorganic) on the underlying adsorption mechanisms by SDBs was also deeply reviewed. Finally, this paper provides the main application challenges as well as insights regarding the promising future directions for SDBs research and development. • This review evaluates the use of sludge-derived biochars for wastewater treatment. • Synthesis conditions influence the adsorption properties of SDBs. • Higher removal capacities of pollutants are obtained with activated SDBs. • Significant increases of removal capacities with nanocomposite-embedded SDBs. • Adsorption mechanisms are different for organic and inorganic pollutants. [ABSTRACT FROM AUTHOR]

Different techniques including adsorption, electrocoagulation, ultrafiltration, and membrane filtration were applied to eliminate heavy metals and organic compounds. According to the experimental observations, an adsorption model was developed, considering a layer-by-layer adsorption in the larger pores of the membrane. This Special Issue includes investigations related to wastewater treatment, recovery, and reuse. IR characterizations confirmed the fixation of Zn SP 2+ sp onto the I L.C i by the creation of Zn-OH, Zn-O and Zn-O-C bonds. [Extracted from the article]

Abstract: The present study aims to develop a new potentially low-cost, sustainable treatment approach to soluble inorganic phosphorus removal from synthetic solutions and secondary wastewater effluents in which a plant waste (Posidonia oceanica fiber: POF) is used for further agronomic benefit. Dynamic flow tests using a continuous stirred tank reactor (CSTR) were carried out to study the effect of initial concentration of phosphorus, amount of adsorbent, feeding flow rate and anions competition. The experimental results showed that the removal efficiency of phosphorus from synthetic solutions is about 80% for 10gL−1 of POF. In addition, the variation of the initial concentration of phosphorus from 8 to 50mgL−1 increased the adsorption capacity from 0.99 to 3.03mgg−1. The use of secondary treated wastewater showed the presence of competition phenomenon between phosphorus and sulphate which could be overcoming with increasing the sorptive surface area and providing more adsorption sites when increasing the adsorbent dosage of POF. Compared with columns studies, this novel CSTR system showed more advantages for the removal of soluble phosphorus as a tertiary treatment of urban secondary effluents with more adsorption efficiency and capacity, in addition to the prospect use of saturated POF with nutriment as fertilizer and compost. [Copyright &y& Elsevier]

Hydrothermal carbonization (HTC) of wet solid wastes has been pointed out as an eco-friendly, flexible and highly efficient technology for the sustainable valorization of multiple sourced wastes. In this review paper, most recent studies on hydrochars (solid residue of the HTC process) production, characterization and application for wastewaters treatment was summarized and deeply discussed. The role of initial feedstock source nature and characteristics as well as the HTC experimental conditions including the temperature, the residence time and the pH media was assessed. Physical and chemical activation methods including the use of oxygen, steam, microwave, acids, alkaline, organics and salty solutions for the improvement of the physicochemical properties of the produced hydrochars are compared. The efficiency of these raw/modified hydrochars along with the involved mechanisms during organic (dyes) and mineral pollutants (heavy metals and nutrients) removal from aqueous solutions is also reviewed. Finally, this paper addresses the main challenges and also demonstrates insights on new directions for hydrochars research and development in the future. • Hydrochars showed a decrease in esters and hydroxyl groups compared to raw biomass. • Carbon content, minerals and polymeric structure influence hydrochars' adsorption capacity. • Solution temperature, pH and residence time impact hydrochar's efficiency. • Hydrochar's oxygen functional groups are reactive to heavy metals and organic molecules. • Post-activation improves significantly hydrochars' specific surface area. [ABSTRACT FROM AUTHOR]