Search

The quality of chemical analysis is an important aspect of passive sampling-based environmental assessments. The present study reports on a proficiency testing program for the chemical analysis of hydrophobic organic compounds in silicone and low-density polyethylene (LDPE) passive samplers and hydrophilic compounds in polar organic chemical integrative samplers. The median between-laboratory coefficients of variation (CVs) of hydrophobic compound concentrations in the polymer phase were 33% (silicone) and 38% (LDPE), similar to the CVs obtained in four earlier rounds of this program. The median CV over all rounds was 32%. Much higher variabilities were observed for hydrophilic compound concentrations in the sorbent: 50% for the untransformed data and a factor of 1.6 after log transformation. Limiting the data to the best performing laboratories did not result in less variability. Data quality for hydrophilic compounds was only weakly related to the use of structurally identical internal standards and was unrelated to the choice of extraction solvent and extraction time. Standard deviations of the aqueous concentration estimates for hydrophobic compound sampling by the best performing laboratories were 0.21 log units for silicone and 0.27 log units for LDPE (factors of 1.6 to 1.9). The implications are that proficiency testing programs may give more realistic estimates of uncertainties in chemical analysis than within-laboratory quality control programs and that these high uncertainties should be taken into account in environmental assessments.

The issue of microplastic (MP) litter in the aquatic environment and its capability of accumulating and/or releasing pollutants has been brought to light in recent years. Biodegradable plastics have been proposed as one of the different solutions to decrease environmental input of discarded plastics; however, their ability to accumulate and release pollutants once in the marine environment has not been assessed yet. In this study, we compare the accumulation and the release of a wide range of compounds by biodegradable (polyhydroxyalkanoates (PHA) and polybutylene succinate (PBS)) and conventional (polyethylene (PE)) MPs following exposure to natural seawater for 64 days. We quantified polycyclic aromatic hydrocarbons (PAHs), polychlorinated biphenyls (PCBs), organophosphorus flame retardants (PFRs), phthalates, and alternative plasticizers in MPs, before and after exposure. Results indicated that PBS- and PHA-MPs accumulated the largest amount of PAHs and PFRs, respectively. Leaching of PFRs and plasticizers was observed for all polymers and was approximately twofold greater for PE- when compared to PBS- and PHA-MPs. Overall, our study suggests that biodegradable MPs may release less additives and accumulate a larger amount of contaminants from seawater compared to conventional ones: these findings may have implications on the risk assessment of biodegradable polymers for marine biota; and on potential widespread adoption of these types of plastics., (© 2023. The Author(s), under exclusive licence to Springer-Verlag GmbH Germany, part of Springer Nature.)

A first test of the field capabilities of a novel in situ sampling technique combining active and passive sampling (APS) was conducted in the sea. The proof-of-concept device uses a pump to draw water into a diffusion cell where dissolved target substances are accumulated onto sorbents which are selective for different classes of contaminants (i.e., metal cations, polar and non-polar organic compounds), simultaneously. A controlled laminar flow established in the diffusion cell enables measurements of contaminant concentrations that are fully independent from the hydrodynamic conditions in the bulk solution. APS measurements were consistent with those obtained using conventional passive sampling techniques such as organic diffusive gradients in thin films (o-DGT) and silicone rubber (SR) samplers (generally < 40% difference), taking into account the prevailing hydrodynamic conditions. The use of performance reference compounds (PRC) for hydrophobic contaminants provided additional information. Field measurements of metal ions in seawater showed large variability due to issues related to the device configuration. An improved field set-up deployed in supplementary freshwater mesocosm experiments provided metal speciation data that was consistent with passive sampling measurements (DGT), taking into account the hydrodynamic conditions. Overall, the results indicate that the APS technique provides a promising approach for the determination of a wide range of contaminants simultaneously, and independently from the hydrodynamic conditions in the bulk solution., (Copyright © 2021 Elsevier Ltd. All rights reserved.)