Search

As a result of the increasing penetration of renewables in power systems, wind farms (WFs) have to satisfy the low-voltage ride-through (LVRT) requirement to stay connected to the power grid under fault conditions. This study proposes a novel method that uses the static synchronous compensator (STATCOM) to improve the LVRT capability of WFs during grid faults. The proposed method is based on the Taguchi method which involves orthogonal experiments. The allocation (locations and sizes) and fuzzy control gains of STATCOM are determined by the analysis of mean (ANOM) technique as part of the Taguchi method to achieve a robust design that is insensitive to variations of operating conditions and faults. The optimal STATCOM that is obtained by the proposed method is validated in both a single WF-infinite bus power system and the IEEE 39-bus power system. The simulation results show that the proposed method can enhance the LVRT capability of WFs. [ABSTRACT FROM AUTHOR]

The static synchronous compensator (STATCOM) has attracted considerable attention because it can stabilise severe transients that are caused by power system disturbances. This study presents a novel interval type 2 fuzzy control system (IT2‐FCS)‐based controller for the STATCOM to stabilise bus voltages that are caused by faults or forced wind farm outages in a smart grid. Two IT2‐FCSs are presented to tune increments of the proportional integral (PI) controller, which are optimised by the gradient descent method. The IT2 fuzzy rules, involving upper and lower membership functions, result in a fast and stable system response. Since many possible scenarios may arise in the power system, the Taguchi method is used to design experiments using an orthogonal array, in which all scenarios are mutually independent. A power system that consists of a wind farm and STATCOM is studied. Comparative studies show that the proposed method is superior to traditional PI and type 1 FCS methods. [ABSTRACT FROM AUTHOR]