Search

Nanoparticle shape strongly affects the thermal-hydraulic behavior of nanofluid-enhanced single-phase natural circulation loop (SPNCL) but is yet to be explored experimentally. Hence, various mono/hybrid nanofluids having dissimilar shaped nanoparticles (Al 2 O 3 +Water, Al 2 O 3 +CuO + Water, Al 2 O 3 +SiC + Water, Al 2 O 3 +MWCNT + Water) with a 0.1% volume concentration, are used in SPNCL to investigate mass flow rate (MFR), heat exchanger effectiveness (HEE) and total entropy generation rate (TEGR). The effect of power input, coolant inlet temperature and loop inclination (both counter-clockwise and clockwise) on transient and steady-state performances are presented. The result reveals that mono/hybrid nanofluid shows enhanced HEE and lower TEGR as compared to base fluids, whereas the MFR may increase or decrease since the performance of SPNCL is significantly impacted by the nanoparticle's shape. Spherical-shaped nanoparticle-dispersed nanofluids show early flow initiation and higher MFR than cylindrical-shaped nanoparticle-dispersed nanofluids. MFR and TEGR rise with higher power input, whereas HEE declines for all working fluids. MFR and TEGR increase as the coolant inlet temperature rises, whereas HEE decreases for all working fluids. The loop inclination decreases the MFR, while it increases the HEE and TEGR. The Counter-clockwise inclination of the loop shows a higher MFR than the clockwise inclination at the same angle of inclination. • Hybrid nanofluids having dissimilar shaped particles are used in natural circulation loop. • Mass flow rate, heat exchanger effectiveness and entropy generation rate are evaluated. • Effect of power input, coolant inlet temperature and loop inclination are investigated. • Spherical-shaped shows early flow initiation and higher flow rate than cylindrical-shaped. • Counter-clockwise inclination shows higher mass flow rate than the clockwise inclination. [ABSTRACT FROM AUTHOR]

It is necessary to investigate the relative effect of various phenomena before neglecting the same for simulating the single-phase natural circulation loop to obtain an acceptable prediction. Hence, the present study focuses on the validation and effect of different assumptions related to Boussinesq approximation, property variation, bend effect, heat loss, axial fluid and wall conduction on the transient and steady-state characteristics. Effect of assumptions for different working fluids (water, brines and hybrid nanofluids), and assess the effect of different heat flux distributions, like uniform, linear, non-linear, sinusoidal and Gaussian, applied to heater are also explored. Mass flow rate (predicts heat transport capability), effectiveness (predicts heat transfer ability) and entropy generation rate (predicts irreversibility) are evaluated. The results disclose that the Boussinesq approximation with constant other properties under-predicts the steady-state mass flow rate and effectiveness and over-predicts the entropy generation rate. This assumption cannot be applied for all working fluids. The fluid and solid conduction is the crucial parameter for simulating transient characteristics. Gaussian heat flux distribution shows the highest mass flow rate and non-linear increasing heat flux shows the highest effectiveness and entropy generation rate. This study will help to consider reasonable assumptions for the numerical simulation. [ABSTRACT FROM AUTHOR]