Search

Abstract: The speciation of dissolved zinc (Zn) was investigated by voltammetry in the Atlantic sector of the Southern Ocean along two transects across the major frontal systems: along the Zero Meridian and across the Drake Passage. In the Southern Ocean south of the APF we found detectable labile inorganic Zn throughout the surface waters in contrast to studies from lower latitudes. Using a combination of ASV titrations and pseudopolarography revealed the presence of significant concentration of electrochemically inert Zn ligands throughout the Southern Ocean. These ligands however were nearly always saturated due to the presence of excess concentrations of dissolved Zn that were associated with the high nutrient waters south of the Antarctic Polar Front (APF). Only in surface waters did the concentration of Zn complexing ligands exceed the dissolved Zn concentrations suggesting a biological source for these ligands. Our findings have clear implications for the biogeochemical cycling of Zn and for the interpretation of paleo records utilizing Zn in opal as a tracer of Zn speciation in the water column. [Copyright &y& Elsevier]

Abstract: The distribution of dissolved zinc (Zn) was investigated in the Atlantic sector of the Southern Ocean in the austral autumn of 2008 as part of the IPY GEOTRACES expedition ZERO & DRAKE. Research focused on transects across the major frontal systems along the Zero Meridian and across the Drake Passage. There was a strong gradient in surface zinc concentrations observed across the Antarctic Polar Front along both transects and high zinc levels were found in surface waters throughout the Southern Ocean. Vertical profiles for dissolved Zinc showed the presence of local minima and maxima in the upper 200m consistent with significant uptake by phytoplankton and release by zooplankton grazing, respectively. Highest deep water zinc concentrations were found in the centre of the Weddell Gyre associated with Central Intermediate Water (CIW), a water mass which is depleted in O2, elevated in CO2 and is regionally a CFC minimum. Our data suggests that the remineralization of sinking particles is a key control on the distribution of Zn in the Southern Ocean. Disappearance ratios of zinc to phosphate (Zn:P) in the upper water column increased southwards along both transects and based on laboratory studies they suggest slower growth rates of phytoplankton due to iron or light limitation. Zinc and silicate were strongly correlated throughout the study region but the disappearance ratio (Zn:Si) was relatively uniform overall except for the region close to the ice edge on the Zero Meridian. [Copyright &y& Elsevier]

Seventeen inorganic germanium and silicon concentration profiles collected from the Atlantic, southwest Pacific, and Southern oceans are presented. A plot of germanium concentration versus silicon concentration produced a near-linear line with a slope of 0.760 x 10-6 (±0.004) and an intercept of 1.27 (±0.24) pmol L-1 (r2 = O.993,p <0.001). When the germanium-to-silicon ratios (Ge/Si) were plotted versus depth and/or silicon concentrations, higher values are observed in surface waters (low in silicon) and decreased with depth (high in silicon). Germanium-to-silicon ratios in diatoms (0.608-1.03 x 10-6) and coupled seawater samples (0.47 1-7.46 x 10-6) collected from the Southem Ocean are also presented and show clear evidence for Ge/Si fractionation between the water and opal phases. Using a 10 box model (based on PANDORA), Ge/Si fractionation was modeled using three assumptions: (1) no fractionation, (2) fractionation using a constant distribution coefficient (KD) between the water and solid phase, and (3) fractionation simulated using Michaelis-Menten uptake kinetics for germanium and silicon via the silicon uptake system. Model runs indicated that only Ge/Si fractionation based on differences in the Michaelis-Menten uptake kinetics for germanium and silicon can adequately describe the data. The model output using this fractionation process produced a near linear line with a slope of 0.76 x 10-6 and an intercept of 0.92 (±0.28) pmol L-1, thus reflecting the oceanic data set. This result indicates that Ge/Si fractionation in the global ocean occurs as a result of subtle differences in the uptake of germanium and silicon via diatoms in surface waters. [ABSTRACT FROM AUTHOR]

Abstract: The first large-scale international intercomparison of analytical methods for the determination of dissolved iron in seawater was carried out between October 2000 and December 2002. The exercise was conducted as a rigorously “blind” comparison of 7 analytical techniques by 24 international laboratories. The comparison was based on a large volume (700 L), filtered surface seawater sample collected from the South Atlantic Ocean (the “IRONAGES” sample), which was acidified, mixed and bottled at sea. Two 1-L sample bottles were sent to each participant. Integrity and blindness were achieved by having the experiment designed and carried out by a small team, and overseen by an independent data manager. Storage, homogeneity and time-series stability experiments conducted over 2.5 years showed that inter-bottle variability of the IRONAGES sample was good (<7%), although there was a decrease in iron concentration in the bottles over time (0.8–0.5 nM) before a stable value was observed. This raises questions over the suitability of sample acidification and storage. For the complete dataset of 45 results (after excluding 3 outliers not passing the screening criteria), the mean concentration of dissolved iron in the IRONAGES sample was 0.59±0.21 nM, representing a coefficient of variation (%CV) for analytical comparability (“community precision”) of 36% (1s), a significant improvement over earlier exercises. Within-run precision (5–10%), inter-run precision (15%) and inter-bottle homogeneity (<7%) were much better than overall analytical comparability, implying the presence of: (1) random variability (inherent to all intercomparison exercises); (2) errors in quantification of the analytical blank; and (3) systematic inter-method variability, perhaps related to secondary sample treatment (e.g. measurement of different physicochemical fractions of iron present in seawater) in the community dataset. By grouping all results for the same method, analyses performed using flow injection-luminol chemiluminescence (with FeII detection after sample reduction) [Bowie, A.R., Achterberg, E.P., Mantoura, R.F.C., Worsfold, P.J., 1998. Determination of sub-nanomolar levels of iron in seawater using flow injection with chemiluminescence detection. Anal. Chim. Acta 361, 189–200] and flow injection-catalytic spectrophotometry (using the reagent DPD) [Measures, C.I., Yuan, J., Resing, J.A., 1995. Determination of iron in seawater by flow injection analysis using in-line preconcentration and spectrophotometric detection. Mar. Chem. 50, 3–12] gave significantly (P =0.05) higher dissolved iron concentrations than analyses performed using isotope dilution ICPMS [Wu, J.F., Boyle, E.A., 1998. Determination of iron in seawater by high-resolution isotope dilution inductively coupled plasma mass spectrometry after Mg(OH)2 co-precipitation. Anal. Chim. Acta 367, 183–191]. There was, however, evidence of scatter within each method group (CV up to 59%), implying that better uniformity in procedures may be required. This paper does not identify individual data and should not be viewed as an evaluation of single laboratories. Rather it summarises the status of dissolved iron analysis in seawater by the international community at the start of the 21st century, and can be used to inform future exercises including the SAFE iron intercomparison study in the North Pacific in October 2004. [Copyright &y& Elsevier]

Abstract: This study investigates the oceanic behavior of the lithogenic trace elements Al and Ti in the upper 200m of the Atlantic Ocean. The distribution of both metals in the dissolved and particulate phases was assessed along an E–W transect in the eastern tropical North Atlantic (December 2009) and along a meridional Atlantic transect (April–May 2010). The surface water concentrations of particulate and dissolved Al and Ti reflected the previously observed pattern of atmospheric inputs into the Atlantic Ocean. Subsurface minima at stations with pronounced fluorescence maxima were observed, suggesting a link between biological productivity and the removal of both dissolved and particulate Al and Ti. This may include uptake mechanisms, adsorption and aggregation processes on biogenic particle surfaces and the formation of large, fast sinking biogenic particles, e.g., fecal pellets. Residence times in the upper water column (100m) of the tropical and subtropical North Atlantic were estimated to range in the order of days to weeks in the particulate phases (Al: 3–22 days, Ti: 4–37 days) and were 0.9–3.8 years for Al and 10–31 years for Ti in the dissolved phases. Longer residence times in both phases in the South Atlantic are consistent with lower biological productivity and decreased removal rates. In the upper water column, Al was predominantly present in the dissolved form, whereas Ti mostly occurred in the particulate form. Largest deviations in the partition coefficients between the particulate and dissolved phases were found in the surface waters, together with excess dissolved Al over Ti compared to the crustal source. This likely reflects elevated dissolution of Al compared to Ti from atmospheric mineral particles. [Copyright &y& Elsevier]

A shipboard analytical intercomparison of dissolved (<0.2 μm) iron in the surface waters of the Atlantic Ocean was undertaken during October 2000. A single underway surface (1–2 m) seawater sampling and filtration protocol was used, in order to minimise differences from possible sample contamination. Over 200 samples (1/h) were collected over 12 days and analysed immediately using four different analytical methods, based on three variants of flow injection with luminol chemiluminescence (FI–CL) and cathodic stripping voltammetry (CSV). Dissolved iron concentrations varied between 0.02 and 1.61 nM during the intercomparison. On average, CSV [Electroanalysis 12 (2000) 565] measured 0.08 nM higher iron concentrations than one FI–CL method [Anal. Chim. Acta 361 (1998) 189], which measured 0.13 nM higher iron values than the other two [Anal. Chem. 65 (1993) 1524; Anal. Chim. Acta 377 (1998) 113]. Statistical analyses (paired two-tailed t-test) showed that each analytical method gave significantly different dissolved iron concentrations at the 95% confidence interval. These data however, represent a significant improvement over earlier intercomparison exercises for iron. The data have been evaluated with respect to accuracy and overall inter-laboratory replicate precision, which was generally better than the 95% confidence intervals reported for the NASS Certified Reference Materials. Systematic differences between analytical methods were probably due to the extraction of different physico-chemical forms of iron during preconcentration, either on the micro-column resin (in the FI methods) or with competing ligand equilibration (in the CSV method). Small systematic concentration differences may also have resulted from protocols used for quantification of the analytical blank and instrument calibration. [Copyright &y& Elsevier]

Atmospheric iron and underway sea-surface dissolved (<0.2 μm) iron (DFe) concentrations were investigated along a north–south transect in the eastern Atlantic Ocean (27°N/16°W–19°S/5°E). Fe concentrations in aerosols and dry deposition fluxes of soluble Fe were at least two orders of magnitude higher in the Saharan dust plume than at the equator or at the extreme south of the transect. A weaker source of atmospheric Fe was also observed in the South Atlantic, possibly originating in southern Africa via the north-easterly outflow of the Angolan plume. Estimations of total atmospheric deposition fluxes (dry plus wet) of soluble Fe suggested that wet deposition dominated in the intertropical convergence zone, due to the very high amount of precipitation and to the fact that a substantial part of Fe was delivered in dissolved form. On the other hand, dry deposition dominated in the other regions of the transect (73–97%), where rainfall rates were much lower. Underway sea-surface DFe concentrations ranged 0.02–1.1 nM. Such low values (0.02 nM) are reported for the first time in the Atlantic Ocean and may be (co)-limiting for primary production. A significant correlation (Spearman''s rho=0.862, p<0.01) was observed between mean DFe concentrations and total atmospheric deposition fluxes, confirming the importance of atmospheric deposition on the iron cycle in the Atlantic. Residence time of DFe in the surface waters relative to atmospheric inputs were estimated in the northern part of our study area (17±8 to 28±16 d). These values confirmed the rapid removal of Fe from the surface waters, possibly by colloidal aggregation. [Copyright &y& Elsevier]

Superoxide (O2(-): IUPAC name dioxide (•1-)) is an important transient reactive oxygen species (ROS) in the ocean formed as an intermediate in the redox transformation of oxygen (O2) into hydrogen peroxide (H2O2) and vice versa. This highly reactive and very short-lived radical anion can be produced both via photochemical and biological processes in the ocean. In this paper we examine the decomposition rate of O2(-) throughout the water column, using new data collected in the Eastern Tropical North Atlantic (ETNA) Ocean. For this approach we applied a semi factorial experimental design to identify and quantify the pathways of the major identified sinks in the ocean. In this work we occupied six stations, two on the West African continental shelf and four open ocean stations, including the CVOO time series site adjacent to Cape Verde. Our results indicate that, in the surface ocean impacted by Saharan aerosols and coastal sediment resuspension, the main decay pathways for superoxide are via reactions with Mn(II) and organic matter.