Search

Soil spectroscopy is a promising alternative to evaluate and monitor soil and water quality, particularly in mountainous agricultural lands characterized by intense degradation and limited soil tests reports; a few studies have evaluated the feasibility of VIS-NIR spectroscopy to predict Mehlich 3 (M3) extractable nutrients. This study aimed to (i) examine the potential of VIS-NIR spectroscopy in combination with partial least squares regression to predict M3-extractable elements (Ca, K, Mg, P, Fe, Cd, Cu, Mn, Pb, and Zn) and basic soil properties (clay, silt, sand, CaCO3, pH, and soil organic carbon-SOC), (ii) find optimal pre-processing techniques, and (iii) determine primary prediction mechanisms for spectrally featureless soil properties. Topsoil samples were collected from a representative area (114 samples from 525 ha) located in the mountainous region of NW Azerbaijan. A series of pre-processing steps and transformations were applied to the spectral data, and the models were calibrated and evaluated based on the coefficient of determination (R2), root mean square error (RMSE), and the residual prediction deviation (RPD). The leave-one-out cross-validated predictions showed that the first derivative spectra produce higher prediction accuracies (R2 = 0.51–0.91; RPD = 1.20–2.29) for most soil properties. The evaluation of the model performance with optimal pre-processing techniques revealed that both calibration and validation models produce considerable differences in RPD values associated with sample size and the random partition of the calibration or validation subsets. The prediction models were excellent or very good (RPD > 2.0) for CaCO3, SOC, sand, silt, Ca, and Pb, good or fair (1.4 < RPD < 2.0) for clay, K, Cd, pH, Fe, Mn, and Cu, and poor (1.0 < RPD < 1.4) for Mg, P, and Zn. Principal component and correlation, stepwise regression analysis, and variable importance in projection procedures allowed to elucidate the underlying prediction mechanisms. Unlike the previous studies, the spectral estimations of pH, Ca, Mg, P, Fe, Pb, and Cd concentrations were linked to their correlation with CaCO3 rather than soil organic matter, whereas Mg and P concentrations were also connected to Fe-oxides. Soil particle sizes contributed to predicting K concentration but confounded the prediction of P and Zn concentration. The weaker correlations of Mn, Cu or Zn with CaCO3, particle sizes, SOC, Fe, and spectral data yielded to their lower prediction accuracy. The major prediction mechanisms for M3-extractable elements relied on their relations with CaCO3, pH, clay content and mineralogy, and exchangeable cations in the context of their association with land use. The results can be used in mountain lands to evaluate and control the effect of management on soil quality indices and land degradation neutrality. Further studies are needed to develop most advantageous sampling schemes and modeling. [ABSTRACT FROM AUTHOR]

This study aimed to predict soil properties using visible–near infrared (VIS-NIR) spectroscopy combined with partial least square regression (PLSR) modeling. Special emphasis was given to evaluating effect of pre-processing methods on prediction accuracy and important wavelengths. A total of 114 samples were collected and involved in chemical and spectral analyzes. PLSR model of each soil property was calibrated for all pre-processing methods using all samples, and leave-one-out cross-validation was used to make comparisons between them. Then, PLSR model of each best pre-processing method was calibrated using a 75% of all samples and correspondingly validated with the remaining a 25%. Model accuracy was evaluated based on coefficient of determination (R2), root mean-squared errors (RMSE), and residual prediction deviations (RPD). The high correlation coefficients were found between the tested soil properties and reflectance spectra. The pre-processing methods considerably improved prediction accuracy and filtering methods outperformed linearization methods, and the latter outperformed normalization methods. The performance of cross-validation, calibration and independent validation was similar. An excellent prediction (RPD>2.5) model was obtained for soil organic carbon (SOC) and calcium-carbonate (CaCO3), good quantitative (2.0< RPD<2.5) prediction for sand, silt, and clay, fair prediction (1.4< RPD<1.8) for pH, and poor prediction (1.0< RPD<1.4) for hygroscopic water content (WC). Important wavelengths varied depending on soil property, but some wavelengths were common. This study can be a precursor to building a pioneering soil spectral database, calibrating satellite data, and hyperspectral image mapping of soils as well as digital soil mapping, environmental, and erosion modeling in the Caucasus Mountains. [ABSTRACT FROM AUTHOR]