Search

Air-booster vacuum preloading (AVP) without sand blanket and surcharge vacuum preloading (SVP) methods were used to treat two adjacent areas in a foundation reinforcement project on Donghai Island, Zhanjiang City, Guangdong Province, China. In this study, engineering characteristics of the AVP foundation were obtained through analyzing monitoring data. Results showed that the AVP method obtained superior foundation consolidation results compared to SVP method. This study proposed a new simplified mechanical model for AVP, with a single PVD (prefabricated vertical drain) centered and the air-booster pipes symmetrically distributed around the PVD, applied equivalent air-booster pressure to the drainage boundary. Furthermore, this study established a mathematical analytical model for predicting consolidation settlement based on the proposed simplified model. By comparing the theoretical settlement value with the measured value, this paper verifies the rationality of the analytical solution. Finally, this study analyzed the effects of well resistance, smearing effect, compression index, and permeability index ratio on consolidation characteristics. Land reclamation projects will generate a large amount of dredged ultrasoft soil foundation. The AVP method can achieve superior foundation treatment effects by injecting gas into soil mass through air-booster pipes. The results of this case study demonstrate that the AVP method has substantial advantages compared to the conventional vacuum preloading method. The AVP method can increase foundation settlement, shorten the time for foundation treatment construction, and improve the foundation reinforcement effect. In addition, the AVP method can alleviate PVD clogging and maintain soil permeability, while simultaneously avoiding the excessive use of dredging sand. Therefore, the AVP method can lead to potential economic benefits and protect the natural environment, and it is a method worth considering. Moreover, the mathematical model for predicting consolidation settlement of the AVP method was proposed based on new mechanical assumptions, which can be applied as a reference for settlement prediction in relevant engineering, and the rationality has been verified through comparison with measured settlement results. [ABSTRACT FROM AUTHOR]

This paper describes a full-scale test on a very soft clay ground around 70,000 m2, which is conducted in Huizhou of Guangdong Province, China, to present a new method of vacuum preloading method. A novel moisture separator was developed, which can automatically regulate the vacuum pressure variation by changing the volume of the gas inside it. A large quantity of water drained by the proposed moisture separators can be directly used as a surcharge loading, which would shorten the ground improvement time and save costs as well. Three levels of silt-prevention prefabricated vertical drains were used in the treating process to accelerate the consolidation. In addition, the vacuum preloading method also included an effective radial drainage device which would strengthen the dredged soft clay fill in a deep layer. In the in situ test, tens of piezometers and settlement plates were installed to measure the variations of excess pore water pressures and settlement of two stages of observation points at different positions in the ground. The results show that the largest average consolidation settlement was 314.1 cm and made a saving of more than 66% in power consumption compared with traditional method. It demonstrates that this adopted method is an efficient, cost-effective, and environmentally friendly method for improving sites with low bearing capacity and high compressibility soils. [ABSTRACT FROM PUBLISHER]