Search

Photodynamic therapy (PDT) is an effective local treatment modality as a cancer-specific laser ablation in malignancy of some organs including digestive tracts or bile duct. In Japan, PDT has been applied at the early period after the first clinical induction in 1980's. Although the useful efficacy was clarified, PDT has not been fully applied because of the phototoxicity of the porfimer sodium. The next generated talaporfin-sodium was used for PDT, in which phototoxicity was reduced and, however, the clinical efficacy for digestive tract malignancy has not yet been clarified. By proceeding the experimental and clinical trials, it is necessary to clarify the evidence of efficacy as a local powerful treatment with the conventional surgery, brachiotherapy and chemotherapy in the future step. [ABSTRACT FROM AUTHOR]

This study presents the first investigation of concentrations and congener group patterns of atmospheric short-chain chlorinated paraffins (SCCPs) throughout East Asia. Based on an absorption rate calibration experiment, a spatial survey of SCCPs was performed using passive air samplers in China, Japan, and South Korea during two separate periods in 2008. The atmospheric concentrations of SCCPs in China were clearly greater than those in Japan and South Korea, both of which exceed the levels determined for other regions of the world. C10 components were the most abundant type of SCCPs in China, whereas C11 components were dominant in Japan and South Korea. With respect to the total chlorine content, Cl6 and Cl5 were the predominant compounds in China and Japan; however, Cl6 and Cl7 were predominant in South Korea. A similar pattern was also found for remote sites within China, Japan, and South Korea, respectively. Together with the back-trajectories calculated for the remote sites, the results indicate that the SCCPs in the air of East Asia were mainly influenced by local sources due to their relatively low long-range atmospheric transport potential compared to other POPs. [ABSTRACT FROM AUTHOR]

In terms of resource recovery and environmental impact, melting furnace fly ash (MFA) is attracting much attention in Japan due to its high metal content. The study aims to obtain fundamental information on using a water extraction method not only to concentrate valuable rare metals but also to remove undesirable substances such as chlorine for their recovery from MFA. The composition and leaching characteristics of MFA was investigated. The results revealed that the metal content in MFA is nearly equal to raw ore quality. The content of Ag, In, Pd, Pb, and Zn is, in fact, higher than the content of raw ore. As for leaching behavior, Ag, Bi, In, Ga, Ge, Sb, Sn, and Te showed the lowest release at a neutral pH range. Pd was leached constantly regardless of pH, but its concentration was quite low. On the other hand, most of the Tl was easily leached, revealing that water extraction is not appropriate for Tl recovery from MFA. Major elements Cl, Ca, Na, and K, occupying about 70% of MFA, were mostly leached regardless of pH. Base metal elements Cu, Pb, and Zn showed minimum solubility at a neutral pH. The leaching ratio of target rare metal elements and base metal elements suggests that the optimal pH for water extraction is 8–10, at which the leaching concentration is minimized. The water extraction process removed most of the Cl, Ca, Na, and K, and the concentration of rare metals and base metals increased by four or five times. [Copyright &y& Elsevier]

Fresh and weathered granite from drill cores in Tono, Gifu, Japan, was examined to understand weathering products and the mechanisms of chlorite and biotite weathering under low PO2 conditions. A fresh sample from 365 m depth, a slightly weathered light-green sample from 367 m depth, and a nearly fresh sample from 369 m depth (but with brown stains on fractures), were investigated. The XRD, SEM, EMPA, and TEM analysis of green grains present within chlorite, biotite, and plagioclase grains and in veins was found to be Fe2+-rich corrensite [about 40 wt% FeO with Fe/(Fe + Mg) = 0.94]. The corrensite is interpreted to have formed from chlorite and biotite via a dissolution-precipitation mechanism. The <2 μm fraction of the weathered sample had an Fe2+/ΣFe value of 0.69, which, when combined with the presence of amorphous Fe3+ (hydr)oxides confirmed by TEM, indicates that the Fe2+/ΣFe value of corrensite is >0.69. These results indicate that on dissolution of chlorite and biotite, Fe2+ was transported as Fe2+ and precipitated as Fe2+-rich corrensite and a part of the dissolved Fe2+ was oxidized to amorphous Fe3+ (hydr)oxides under low PO2 conditions. The formation of Fe2+-rich corrensite and that of Fe2+-rich smectite or vermiculite in the laboratory at 1 atm of PCO2 and ≤3 × 10-5 atm of PO2 (Murakami et al. 2004) suggest that a possible Fe2+-bearing product during Precambrian weathering is Fe2+-rich sheet silicates but not siderite. [ABSTRACT FROM AUTHOR]

Identification of pollution sources and estimation of their contribution to dioxin pollution are important for taking better countermeasures against such sources. The information based on seventeen 2,3,7,8-chlorine-substituted congeners and 10 homologues is usually not sufficient for source identification. The usefulness of detailed congener-specific information of tetra- to octachlorinated polychlorinated dibenzo-p-dioxins and polychlorinated dibenzofurans was examined by principal component analysis and compared with conventional dioxin information. It was revealed that congener-specific information was far more effective for source identification than conventional information. For source apportioning, it was shown that multiple regression analysis with detailed source congener profiles could be carried out successfully when calculations were performed for individual homologues. This was because of the large variation in homologue composition in source dioxin profiles in addition to the difference in environmental behavior among the homologues.The newly proposed methods for statistical analysis were applied to the estimation of dioxin mass balance in Tokyo Bay basin. It was found that Tokyo Bay sediment core contained dioxins from three major sources: combustion, pentachlorophenol (PCP), and chloronitrophen (CNP). PCP and CNP contained large amounts of dioxin as impurity and were used extensively as paddy field herbicides in Japan in the past. The total dioxin load from the two herbicides to the basin during the past 45 years (1951–1995) was estimated to be five times larger than that from combustion source in terms of toxic equivalents (WHO-TEQ). However, in the surface sediment of the bay, the contribution from the herbicides was nearly equal to that from combustion. The herbicide contribution peaked during the 1960s and 1970s and gradually decreased thereafter. [Copyright &y& Elsevier]

Six isolates of novel marine myxobacteria, designated strains SHK-1T, SMK-1-1, SMK-1-3, SMK-10, SKK-2, and SMP-6, were obtained from various coastal samples (mud, sands and algae) collected around Japan. All of the isolates had Gram-negative rod-shaped cells, motile by gliding and grew aerobically. They showed bacteriolytic action, fruiting body formation, and NaCl requirement for growth with an optimum concentration of 1.0-2.0% (w/v). In addition, divalent cationic components of seawater, such as Mg2+ or Ca2+, were also needed for growth. The major respiratory quinone was MK-7. The G+C content of genomic DNA ranged from 65.6 to 67.4 mol% (by HPLC). The isolates shared almost identical 16S rDNA sequences, and clustered with a recently described marine myxobacterium, Plesiocystis pacifica, as their closest relative on a phylogenetic tree (95.9-96.0% similarity). Physiological and chemotaxonomic differences between the new strains and strains of the genus Plesiocystis justify the proposal of a new genus. Therefore, we propose to classify the six isolates into a new taxon of marine myxobacteria with the name, Enhygromyxa salina gen. nov., sp. nov. The type strain is SHK-1T (JCM 11769T = DSM 15217T = AJ 110011T). [ABSTRACT FROM AUTHOR]