Search

The failure mode of concrete columns in subway stations during seismic events can be affected by the dynamic fluctuation of the axial forces. This study conducted quasi-static tests with bidirectional loading on three scaled rectangular columns to investigate the influence of highly variable axial compression ratio (ACR). A detailed analysis was conducted of the impact of the highly variable ACR on the column failure mode, reinforcement strains, and hysteretic behavior, and the repairability assessment was discussed. Numerical analysis of the effect of ACR variations was carried out based on the experimental results. In these experiments, the failure modes of central columns in Dakai Station, Japan, during the Kobe earthquake were reproduced, and three columns exhibited compressive-bending-shear damage and compressive-bending damage. As the ACR varied up to three cycles during one horizontal loading cycle, the hysteresis curve of the columns exhibited notable asymmetry. Furthermore, with a large variation of ACR amplitude, the stirrups of the column were fractured due to excessive shear effects. The bearing capacity, energy dissipation, and stiffness degradation of the columns were significantly adversely affected. A reparability assessment of the columns, based on the distribution of reinforcement strains, residual displacements, and concrete damage, is proposed. The effects of varying frequency and amplitude of different vertical ACRs on the hysteretic behavior of columns were analyzed numerically. [ABSTRACT FROM AUTHOR]

In the summer of 2009, a full-scale midrise wood-frame building was tested under a series of simulated earthquakes on the world's largest shake table in Miki City, Japan. The objective of this series of tests was to validate a performance-based seismic design approach by qualitatively and quantitatively examining the building's seismic performance in terms of response kinematics and observed damage. This paper presents the results of detailed damage inspections following each test in a series of five shake table tests, and explains their qualitative synthesis to provide design method validation. The seismic test program had two phases. Phase I was the testing of a seven-story mixed-use building with the first story consisting of a steel special moment frame (SMF) and stories 2-7 made of light-frame wood. In Phase II, the SMF was heavily braced such that it effectively became an extension of the shake table and testing was conducted on only stories 2-7, making the building a six-story light-frame multifamily residential building instead of a mixed-use building. All earthquake motions were scalings of the 1994 Northridge earthquake at the Canoga Park recording station with seismic intensities ranging from peak ground accelerations of 0.22 to 0.88 g. The building performed quite well during all earthquakes with damage only to the gypsum wall board (drywall), no sill plate splitting, no nails withdrawing or pulling through the sheathing, no edge tearing of the sheathing, no visible stud splitting around tie-down rods, and reasonable floor accelerations. On the basis of damage inspection, it was concluded that it is possible to design this type of building and keep the damage to a manageable level during major earthquakes by utilizing the new design approach. [ABSTRACT FROM AUTHOR]