Search

The outflow of warm, salty, and dense water from the Red Sea into the western Gulf of Aden is numerically simulated using the Hybrid Coordinate Ocean Model (HYCOM). The pathways of the modeled overflow, temperature, salinity, velocity profiles from stations and across sections, and transport estimates are compared to those observed during the 2001 Red Sea Outflow Experiment. As in nature, the simulated outflow is funneled into two narrow channels along the seafloor. The results from the three-dimensional simulations show a favorable agreement with the observed temperature and salinity profiles along the channels. The volume transport of the modeled overflow increases with the increasing distance from the southern exit of the Bab el Mandeb Strait due to entrainment of ambient fluid, such that the modeled transport shows a reasonable agreement with that estimated from the observations. The initial propagation speed of the outflow is found to be smaller than the estimated interfacial wave speed. The slow propagation is shown to result from the roughness of the bottom topography characterized by a number of depressions that take time to be filled with outflow water. Sensitivities of the results to the horizontal grid spacing, different entrainment parameterizations, and forcing at the source location are investigated. Because of the narrow widths of the approximately 5 km of the outflow channels, a horizontal grid spacing of 1 km or less is required for model simulations to achieve a reasonable agreement with the observations. Comparison of two entrainment parameterizations, namely, TPX and K-profile parameterization (KPP), show that similar results are obtained at 1-km resolution. Overall, the simulation of the Red Sea outflow appears to be more strongly affected by the details of bottom topography and grid spacing needed to adequately resolve them than by parameterizations of diapycnal mixing. [ABSTRACT FROM AUTHOR]

When the salty and heavy water of the Red Sea exits from the Strait of Bab el Mandeb, it continues downslope into the Gulf of Aden mainly along two channels. The 130-km-long “Northern Channel” (NC) is topographically confined and is typically only 5 km wide. In it, the Red Sea plume shows unanticipated patterns of vertical structure, turbulent mixing, and entrainment. Above the seafloor a 25–120-m-thick weakly stratified layer shows little dilution along the channel. Hence this bottom layer undergoes only weak entrainment. In contrast, a 35–285-m-thick interfacial layer shows stronger entrainment and is shown in a companion paper to undergo vigorous turbulent mixing. It is thus the interface that exhibits the bulk of entrainment of the Red Sea plume in the NC. The interfacial layer also carries most of the overall plume transport, increasingly so with downstream distance. The “Southern Channel” (SC) is wider than the NC and is accessed from the latter by a sill about 33 m above the floor of the NC. Entrainment into the bottom layer of the SC is diagnosed to be strong near the entry into the SC such that the near-bottom density and salinity are smaller in the SC than in the NC at the same distance from Bab el Mandeb. In comparison with winter conditions, the authors encountered weaker outflow with shallower equilibration depths during the summer cruise. Bulk Froude numbers computed for the whole plume varied within the range 0.2–1. Local maxima occurred in relatively steep channel sections and coincided with locations of significant entrainment. [ABSTRACT FROM AUTHOR]

Given the motivation that overflow processes, which supply source waters for most of the deep and intermediate water masses in the ocean, pose significant numerical and dynamical challenges for ocean general circulation models, an intercomparison study is conducted between field data collected in the Red Sea overflow and a high-resolution, nonhydrostatic process model. The investigation is focused on the part of the outflow that flows along a long narrow channel, referred to as the “northern channel,” that naturally restricts motion in the lateral direction such that the use of a two-dimensional model provides a reasonable approximation to the dynamics. This channel carries about two-thirds of the total Red Sea overflow transport, after the overflow splits into two branches in the western Gulf of Aden. The evolution of the overflow in the numerical simulations can be characterized in two phases: the first phase is highly time dependent, during which the density front associated with the overflow propagates along the channel. The second phase corresponds to that of a statistically steady state. The primary accomplishment of this study is that the model adequately captures the general characteristics of the system: (i) the gradual thickening of the overflow with downstream distance, (ii) the advection of high salinity and temperature signals at the bottom along the channel with little dilution, and (iii) ambient water masses sandwiched between the overflow and surface mixed layer. To quantify mixing of the overflow with the ambient water masses, an entrainment parameter is determined from the transport increase along the slope and is expressed explicitly as a function of mean slope angle. Bulk Richardson numbers are estimated both from data and model and are related to the entrainment parameter. The range of entrainment parameter and its functional dependence on bulk Richardson number in this study are found to be in reasonable agreement with those reported from various laboratory experiments and that based on measurements of the Mediterranean overflow. The results reveal a complex dynamical interaction between shear-induced mixing and internal waves and illustrate the high computational and modeling requirements for numerical simulation of overflows to capture (at least in part) turbulent transports explicitly. [ABSTRACT FROM AUTHOR]