Search

Internal gravity waves, the subsurface analogue of the familiar surface gravity waves that break on beaches, are ubiquitous in the ocean. Because of their strong vertical and horizontal currents, and the turbulent mixing caused by their breaking, they affect a panoply of ocean processes, such as the supply of nutrients for photosynthesis, sediment and pollutant transport and acoustic transmission; they also pose hazards for man-made structures in the ocean. Generated primarily by the wind and the tides, internal waves can travel thousands of kilometres from their sources before breaking, making it challenging to observe them and to include them in numerical climate models, which are sensitive to their effects. For over a decade, studies have targeted the South China Sea, where the oceans' most powerful known internal waves are generated in the Luzon Strait and steepen dramatically as they propagate west. Confusion has persisted regarding their mechanism of generation, variability and energy budget, however, owing to the lack of in situ data from the Luzon Strait, where extreme flow conditions make measurements difficult. Here we use new observations and numerical models to (1) show that the waves begin as sinusoidal disturbances rather than arising from sharp hydraulic phenomena, (2) reveal the existence of >200-metre-high breaking internal waves in the region of generation that give rise to turbulence levels >10,000 times that in the open ocean, (3) determine that the Kuroshio western boundary current noticeably refracts the internal wave field emanating from the Luzon Strait, and (4) demonstrate a factor-of-two agreement between modelled and observed energy fluxes, which allows us to produce an observationally supported energy budget of the region. Together, these findings give a cradle-to-grave picture of internal waves on a basin scale, which will support further improvements of their representation in numerical climate predictions. [ABSTRACT FROM AUTHOR]

The three-dimensional (3D) double-ridge internal tide interference in the Luzon Strait in the South China Sea is examined by comparing 3D and two-dimensional (2D) realistic simulations. Both the 3D simulations and observations indicate the presence of 3D first-mode (semi)diurnal standing waves in the 3.6-km-deep trench in the strait. As in an earlier 2D study, barotropic-to-baroclinic energy conversion, flux divergence, and dissipation are greatly enhanced when semidiurnal tides dominate relative to periods dominated by diurnal tides. The resonance in the 3D simulation is several times stronger than in the 2D simulations for the central strait. Idealized experiments indicate that, in addition to ridge height, the resonance is only a function of separation distance and not of the along-ridge length; that is, the enhanced resonance in 3D is not caused by 3D standing waves or basin modes. Instead, the difference in resonance between the 2D and 3D simulations is attributed to the topographic blocking of the barotropic flow by the 3D ridges, affecting wave generation, and a more constructive phasing between the remotely generated internal waves, arriving under oblique angles, and the barotropic tide. Most of the resonance occurs for the first mode. The contribution of the higher modes is reduced because of 3D radiation, multiple generation sites, scattering, and a rapid decay in amplitude away from the ridge. [ABSTRACT FROM AUTHOR]

A strong internal tide is generated in the Luzon Strait that radiates westward to impact the continental shelf of the South China Sea. Mooring data in 1500-m depth on the continental slope show a fortnightly averaged incoming tidal flux of 12 kW m−−1, and a mooring on a broad plateau on the slope finds a similar flux as an upper bound. Of this, 5.5 kW m−−1 is in the diurnal tide and 3.5 kW m−−1 is in the semidiurnal tide, with the remainder in higher-frequency motions. Turbulence dissipation may be as high as 3 kW m−−1. Local generation is estimated from a linear model to be less than 1 kW m−−1. The continental slope is supercritical with respect to the diurnal tide, implying that there may be significant back reflection into the basin. Comparing the low-mode energy of a horizontal standing wave at the mooring to the energy flux indicates that perhaps one-third of the incoming diurnal tidal energy is reflected. Conversely, the slope is subcritical with respect to the semidiurnal tide, and the observed reflection is very weak. A surprising observation is that, despite significant diurnal vertical-mode-2 incident energy flux, this energy did not reflect; most of the reflection was in mode 1. The observations are consistent with a linear scattering model for supercritical topography. Large fractions of incoming energy can reflect depending on both the geometry of the shelfbreak and the phase between the modal components of the incoming flux. If the incident mode-1 and mode-2 waves are in phase at the shelf break, there is substantial transmission onto the shelf; if they are out of phase, there is almost 100%% reflection. The observations of the diurnal tide at the site are consistent with the first case: weak reflection, with most of it in mode 1 and almost no reflection in mode 2. The sensitivity of the reflection on the phase between incident components significantly complicates the prediction of reflections from continental shelves. Finally, a somewhat incidental observation is that the shape of the continental slope has large regions that are near critical to the dominant diurnal tide. This implicates the internal tide in shaping of the continental slope. [ABSTRACT FROM AUTHOR]

In the South China Sea (SCS), 14 nonlinear internal waves are detected as they transit a synchronous array of 10 moorings spanning the waves’ generation site at Luzon Strait, through the deep basin, and onto the upper continental slope 560 km to the west. Their arrival time, speed, width, energy, amplitude, and number of trailing waves are monitored. Waves occur twice daily in a particular pattern where larger, narrower “A” waves alternate with wider, smaller “B” waves. Waves begin as broad internal tides close to Luzon Strait’s two ridges, steepening to O(3–10 km) wide in the deep basin and O(200–300 m) on the upper slope. Nearly all waves eventually develop wave trains, with larger–steeper waves developing them earlier and in greater numbers. The B waves in the deep basin begin at a mean speed of ≈5% greater than the linear mode-1 phase speed for semidiurnal internal waves (computed using climatological and in situ stratification). The A waves travel ≈5%–10% faster than B waves until they reach the continental slope, presumably because of their greater amplitude. On the upper continental slope, all waves speed up relative to linear values, but B waves now travel 8%–12% faster than A waves, in spite of being smaller. Solutions of the Taylor–Goldstein equation with observed currents demonstrate that the B waves’ faster speed is a result of modulation of the background currents by an energetic diurnal internal tide on the upper slope. Attempts to ascertain the phase of the barotropic tide at which the waves were generated yielded inconsistent results, possibly partly because of contamination at the easternmost mooring by eastward signals generated at Luzon Strait’s western ridge. These results present a coherent picture of the transbasin evolution of the waves but underscore the need to better understand their generation, the nature of their nonlinearity, and propagation through a time-variable background flow, which includes the internal tides. [ABSTRACT FROM AUTHOR]