Search

Purpose: The aim of this prospective clinical trial was to compare the three-dimensional marginal bone level, implant stability, and peri-implant health of two types of submerged dental implants that were restored with matching or platform-switched abutments. Materials and Methods: Twenty-five subjects were recruited (test group: 43 implants with internal conical connection and back-tapered collar carrying a platform-switched abutment; control group: 50 implants carrying a matched-platform abutment). Implant uncovering and conventional loading were performed after 3 months of healing, and the total observation time was 15 months. Marginal bone levels, resonance frequency analysis, insertion torque, and peri-implant health indices were recorded and analyzed statistically. Results: The cumulative implant survival rate was 100%. At the second-stage surgery, bone levels were similar between groups. One year after loading, mean crestal bone loss was 0.35 ± 0.13 mm for test implants and 0.83 ± 0.16 mm for control implants, a significant difference. Primary stability was significantly higher in the test group than in the control group, but this difference disappeared after 3 months of healing prior to loading. Between-group differences for periimplant health indices were negligible. Conclusions: Both implant systems had the same survival rates. Implants with a built-in platform switch and conical connection with back-tapered collar design achieved higher primary stability at insertion and less bone resorption after 15 months [ABSTRACT FROM AUTHOR]

Identifying controls on the permeability of fluid‐conductive fractures is critical in tight reservoirs, but this is challenging in tectonically complex regions such as foothills belts where there may have been multiple stages of deformation and fracturing. Fracture permeability depends on fracture aperture and connectivity, both of which are affected by tectonism and cementation. Among the many factors that control the cementation history, oil charging may play an important role. Important challenges in studies of fractured reservoirs in tectonically complex regions include determining the timing (and intensity) of fracturing events relative to that of the oil charge, verifying the presence of matrix storage, and establishing the fracture cementation history. This paper reports on a comparative fracture study of four small‐scale oilfields in the west Adıyaman Basin, located within the foothills belt of the Tauride suture zone in SE Turkey. Here the tight reservoir carbonates of the Sayındere Formation (Campanian) were subjected to repeated phases of structural deformation. Major deformation phases took place in Campanian and Maastrichtian times, before oil charging into the reservoir began in the Eocene; and in the Late Eocene – Oligocene and Late Miocene, after the oil charge. Fractures that were generated before oil emplacement appear to have been cemented or partially cemented by calcite as indicated by cross‐cutting cemented fractures on borehole images. Partially‐cemented fractures in cores are oil‐stained with cement‐lined walls, suggesting cementation began before oil emplacement but was not completed. Image logs and cores also show the presence of clean, open fractures with no cement present on the walls. These open fractures cut across the cemented or partially‐cemented fractures, and are in general related to Late Miocene compressional folding. Open fracture density is correlated to Late Miocene fold curvature and asymmetry in the four oilfields studied. Of these fields, the Șambayat structure is the tightest and most asymmetric anticline and hence has the maximum open fracture density; this field also has the highest oil potential. Although the available data is not sufficient to evaluate the effects of oil charging on fracture cementation definitively, the observations are consistent with a model that oil charge into the fractured Sayındere Formation carbonates inhibited or slowed calcite cementation. Hence fracturing of a carbonate reservoir after oil emplacement may significantly enhance the fracture permeability, and may even render a tight reservoir prospective. [ABSTRACT FROM AUTHOR]

Purpose. Bone atrophy after tooth loss may leave insufficient bone for implant placement. We compared volumetric changes after autogenous ramus block bone grafting (RBG) or guided bone regeneration (GBR) in horizontally deficient maxilla before implant placement. Materials and Methods. In this retrospective study, volumetric changes at RBG or GBR graft sites were evaluated using cone-beam computed tomography. The primary outcome variable was the volumetric resorption rate. Secondary outcomes were bone gain, graft success, and implant insertion torque. Results. Twenty-four patients (28 grafted sites) were included (GBR, 15; RBG, 13). One patient (RBG) suffered mucosal dehiscence at the recipient site 6 weeks after surgery, which healed spontaneously. Mean volume reduction in the GBR and RBG groups was 12.48 ± 2.67% and 7.20 ± 1.40%, respectively. GBR resulted in significantly more bone resorption than RBG (P<0.001). Mean horizontal bone gain and width after healing were significantly greater in the GBR than in the RBG group (P=0.002 and 0.005, resp.). Implant torque was similar between groups (P>0.05). Conclusions. Both RBG and GBR hard-tissue augmentation techniques provide adequate bone graft volume and stability for implant insertion. However, GBR causes greater resorption at maxillary augmented sites than RBG, which clinicians should consider during treatment planning. [ABSTRACT FROM AUTHOR]

Purpose. To compare marginal bone loss between subgingivally placed short-collar implants with machined collars and those with machined and laser-microtextured collars. Materials and Methods. The investigators used a retrospective study design and included patients who needed missing posterior teeth replaced with implants. Short-collar implants with identical geometries were divided into two groups: an M group, machined collar; and an L group, machined and laser-microtextured collar. Implants were evaluated according to marginal bone loss, implant success, and probing depth (PD) at 3 years of follow-up. Results. Sixty-two patients received 103 implants (56 in the M group and 47 in the L group). The cumulative survival rate was 100%. All implants showed clinically acceptable marginal bone loss, although bone resorption was lower in the L group (0.49 mm) than in the M group (1.38 mm) at 3 years (p<0.01). A significantly shallower PD was found for the implants in the L group during follow-up (p<0.01). Conclusions. Our results suggest predictable outcomes with regard to bone loss for both groups; however, bone resorption was less in the L group than in the M group before and after loading. The laser-microtextured collar implant may provide a shallower PD than the machined collar implant. [ABSTRACT FROM AUTHOR]

Introduction. The bone volume of the posterior maxilla may not be appropriate for implant placement, due to factors such as pneumatized maxillary sinus. The purpose of this study was to evaluate the percentage of graft volume reduction following sinus floor elevation (SFE), with either slow resorbable bone substitute only or a composite of slow and fast resorbable bone substitutes, using cone beam computed tomography (CBCT). Materials and Methods. In this retrospective study, CBCT scans of SFE procedures were evaluated to determine the volume of grafted sinus with either deproteinized bovine bone (DBB) or a 2 : 1 mixture of biphasic calcium sulfate (CS) and DBB, as a composite. The volumetric changes of sinus augmentations were measured 2 weeks (V-I) and 6 months (V-II) after operation. Results. Thirty-three patients were included in this study. The average percentage volume reduction was 9.39±3.01% and 17.65±4.15% for DBB and composite grafts, respectively. A significant graft volume reduction was observed between V-I and V-II for both groups (p<0.01). The DBB group exhibited significantly less volume reduction than the composite group (p<0.01). Conclusions. Augmented sinus volume may change before implant placement. DBB offers greater volume stability during healing than composite grafts. [ABSTRACT FROM AUTHOR]

Allele and genotype frequency distribution of CYP2D6*3, *4, *5, *6 and *10 variants were analyzed in blood samples of 100 unrelated healthy individuals by Real-Time PCR. The allele frequencies of CYP2D6*3(A2549del), *4(G1846A), *6(T1707del) and *10(C100T) were 1%, 10%, 2.5% and 14.5% respectively, while allele frequency of CYP2D6*5 was 3% of the subjects tested. Extensive, poor and intermediate metabolizer (EM, PM, IM) genotype frequencies were 63%, 4% and 12%, respectively. CYP2D6 gene duplication was 4%. Our results show that the frequencies of the mutated alleles of CYP2D6 in Turkish populations are similar to some European populations. 4% of Turkish people who have two nonfunctional defective allele are a high risk group and 12.5% of Turkish people who have two decreased functional defective allele or one normal and one non functional defective allele were also in the risk group. Findings of this study demonstrate the importance of genetic variation in drug intoxicants., (Copyright © 2012 Elsevier Ireland Ltd. All rights reserved.)

Aim: To investigate the distribution of 17 Y-short tandem repeat (STR) loci in the population of the Cukurova region of Turkey., Methods: In the period between 2009 and 2010, we investigated the distribution of 17 Y-STRs in a sample of 249 unrelated healthy men from the Cukurova region of Turkey. Genomic DNA was extracted with InstaGene matrix and Y-STRs were determined using the AmpFISTR Yfiler PCR amplification kit. Gene and haplotype diversity values were estimated using the Arlequin software. To compare our data to other populations, population pairwise genetic distances and associated probability values were calculated using the Y Chromosome Haplotype Reference Database Web site software., Results: At 17 Y-STR loci we detected 148 alleles. The lowest gene diversity in this region was 0.51 for DYS391 and the highest 0.95 for DYS385a/b. Haplotype diversity was 0.9997±0.0004. We compared our data with haplotype data of other Turkish populations and no significant differences were found, except with Ankara population (Φst=0.025, P=0.018). Comparisons were also made with the neighboring populations using analysis of molecular variance of the Y-STR loci genetic structure and our population was nearest to Lenkoran-Azerbaijani (Φst=0.012, P=0.068) and Iranian Ahvaz population (Φst=0.007, P=0.173), followed by Greek (Φst=0.025, P=0.000) and Russian (Φst=0.048, P=0.000) population. Other countries like Portugal, Spain, Italy, Egypt, Israel (Palestinian Authority Area), and Taiwan showed a high genetic distance from our population., Conclusion: Our study showed that Y-STR polymorphisms were a powerful discrimination tool for routine forensic applications and could be used in genealogical investigations.

Objectives: To evaluate the long-term results and possible complications of percutaneous release in the treatment of trigger finger., Methods: We performed percutaneous pulley release with the use of a 16 gauge needle in 25 fingers of 22 patients (16 females, 6 males; mean age 54 years; range 45 to 72 years). Open exploration was added to the procedure in 10 patients to determine the efficacy and safety of the technique. The mean follow-up was 24 months (range 18 to 35 months)., Results: Triggering and pain were eliminated in all fingers postoperatively. Exploration showed that a complete anatomical release of the pulley was obtained in all fingers. Apart from some superficial abrasions, there were no tendinous injury or other complications. In one case, an unintentional skin incision occurred during manipulation of the needle., Conclusion: Due to low complication rates and ease of the procedure with a successful release, percutaneous technique proved an appropriate alternative in the treatment of trigger finger.

Population genetic studies were carried out on Caucasians from southern Turkey (n = 204 individuals) using the short tandem repeat (STR) systems HumTHO1, HumVWA and HumACTBP2. After electrophoresis in polyacrylamide gels, 6 alleles could be identified for HumTHOI, 7 alleles for VWA and 26 alleles for ACTBP2. No significant deviations from Hardy-Weinberg equilibrium could be observed.

The allele distribution of two STRs has been investigated in two populations, i.e. Turks (n = 203/200) and Germans (n = 414/402). The Turkish population showed 11 alleles in HumFES/FPS and 6 alleles in HumF13B while the German population had 9 (FES) and 8 (F13B) alleles respectively. Although the frequency profiles looked quite similar in both populations, there exist significant differences mainly due to alleles 8 and 10 (F13B) and allele 12 (FES). Four variant alleles have been sequenced and are described. Investigation of 368 (FES)/372 (F13B) meioses revealed no new mutations.