Search

Greatly enhanced atmospheric carbon dioxide (CO2) levels relative to well-mixed marine air are observed during periods of offshore winds at coastal sensor platforms in Monterey Bay, California, USA. The highest concentrations originate from urban and agricultural areas, are driven by diurnal winds, and peak in the early morning. These enhanced atmospheric levels can be detected across a ~100km wide nearshore area and represent a significant addition to total oceanic CO2 uptake. A global estimate puts the added sea-air flux of CO2 from these greatly enhanced atmospheric CO2 levels at 25 million tonnes, roughly 1% of the ocean’s annual CO2 uptake. The increased uptake over the 100 km coastal swath is of order 20%, indicating a potentially large impact on ocean acidification in productive coastal waters. [ABSTRACT FROM AUTHOR]

Dams have been a fundamental part of the U.S. national agenda over the past two hundred years. Recently, however, dam removal has emerged as a strategy for addressing aging, obsolete infrastructure and more than 1,100 dams have been removed since the 1970s. However, only 130 of these removals had any ecological or geomorphic assessments, and fewer than half of those included before- and after-removal (BAR) studies. In addition, this growing, but limited collection of dam-removal studies is limited to distinct landscape settings. We conducted a meta-analysis to compare the landscape context of existing and removed dams and assessed the biophysical responses to dam removal for 63 BAR studies. The highest concentration of removed dams was in the Northeast and Upper Midwest, and most have been removed from 3rd and 4th order streams, in low-elevation (< 500 m) and low-slope (< 5%) watersheds that have small to moderate upstream watershed areas (10–1000 km2) with a low risk of habitat degradation. Many of the BAR-studied removals also have these characteristics, suggesting that our understanding of responses to dam removals is based on a limited range of landscape settings, which limits predictive capacity in other environmental settings. Biophysical responses to dam removal varied by landscape cluster, indicating that landscape features are likely to affect biophysical responses to dam removal. However, biophysical data were not equally distributed across variables or clusters, making it difficult to determine which landscape features have the strongest effect on dam-removal response. To address the inconsistencies across dam-removal studies, we provide suggestions for prioritizing and standardizing data collection associated with dam removal activities. [ABSTRACT FROM AUTHOR]

Purpose - This paper aims to discuss rising sea levels at the global, regional, and community scale and illustrate the necessity for public comprehension and involvement. It also aims to demonstrate geographic information systems (GIS) as an efficient tool for modeling and disseminating information with the expectation that coastal communities will benefit by joining in a process to integrate this knowledge into broad-based decision making. Design/methodology/approach - GIS is capable of creating, analyzing, and displaying sea level rise scenarios enabling local officials to address the negative effects of elevated sea levels by allowing them to identify both built and biotic communities that are at risk, assess the situation, and develop mitigation strategies. The paper makes use of a case study of Daytona Beach, Florida, to examine the impacts of storm surge. Findings - A GIS model, produced for south Florida integrating land use and elevation data to illustrate locations that lie below five feet, reveals that heavily populated urban areas in Miami-Dade County could be inundated during extreme high tide and storm surge events. The GIS also indicates that much of the Florida Keys has elevations below five feet and is at risk of flooding if sea levels rise at projected rates. Originality/value - The case study of Daytona Beach, Florida, can be replicated at other coastal locations by using GIS to assimilate spatial data and generate meaningful graphic models to be interpreted by those responsible for minimizing the risks from rising sea levels. [ABSTRACT FROM AUTHOR]

Alkyl ethoxysulphates (AES) are anionic surfactants widely used in numerous commercial and industrial applications. In spite of the high AES volume consumption a few data concerning the occurrence, fate and effects of AES in marine environments are reported in literature. The objective of this study is to evaluate the biodegradability and toxicity of AES in pristine sea water. Ultimate biodegradation was studied according to the guideline 835.3160 “Biodegradability in sea water” proposed by the United States Environmental Protection Agency (USEPA). Acute toxicity of AES was studied to the microalgae Nannochloropsis gaditana, Isochrysis galbana, Chaetoceros gracilis, Dunaliella salina and Tetraselmis chuii and the invertebrate Artemia franciscana, using culture growth inhibition and death, respectively, as effect criteria. During the degradative process two different stages were observed, which were better described with the first order and logistic kinetic models, respectively. Lag times were 3.3 (stage A) and 26.5 (stage B) days whereas half-lives were 18.6 (stage A) and 49.8 (stage B) days. AES inhibited the microalgae growth, with 96-h EC50 values ranging from 4.68 g L−1 for D. salina to 24.02 mg L−1 for I. galbana. Mean 48- and 72-h LC50 values for A. franciscana were 38.30 and 23.92 mg L−1, respectively. The results indicate an extensive biodegradability of AES in sea water, although at a very slow rate. Acute toxicity was highly dependent on the species tested, being the green alga D. salina the most affected organism. The present study provides relevant data concerning the biodegradability and adverse effects of an AES surfactant on marine organisms, which are useful to establish water quality criteria in a regulatory framework. [Copyright &y& Elsevier]

This article reports the primary biodegradation kinetics of linear alkylbenzene sulphonates (LAS) in sea water from the Bay of Cadiz (South West of the Iberian Peninsula). The authors used the biodegradation test guideline proposed by the Office of Prevention, Pesticides, and Toxic Substances of the United States Environmental Protection Agency; 835. 3160 "Biodegradability in sea water" in its shake flask variant. High performance liquid chromatography (HPLC) has been employed for the analysis of the surfactant material. The surfactant shows a primary biodegradation kinetic in accordance with a logistic model, the kinetic parameters t50 and lag time were calculated by means of a easy quantitative procedure introduced. Mean values of 6. 15±0. 45 and 6. 67±0. 6 days were obtained for t50 and lag time, respectively. These results indicate that although LAS has a high primary biodegradation rate in sea water, it biodegrades slower than in similar tests conducted in river water. [ABSTRACT FROM AUTHOR]

The current U.S. Environmental Protection Agency (EPA) protocol for testing the effectiveness of dispersants for use in treating oil spills on the open water, the swirling flask test (SFT), has been found to give widely varying results in the hands of different testing laboratories. Part I addressed the sources of the ambiguities in the EPA SFT and the development of a new test referred to as the baffled flask test (BFT). In this part of the series, further experiments were conducted for estimating the repeatability of three operators in determining the effectiveness of 18 dispersants by both the EPA SFT and the BFT methods. Overall statistical analysis of the results indicated that the coefficient of variation by the BFT was only 7.8% compared to 21.9% for the EPA SFT. The mean percent effectiveness of the EPA SFT was only 19.7% as compared to 64.6% for the BFT. Proposed selection criteria for screening of dispersants for listing on the National Contingency Plan Product Schedule have been developed. [ABSTRACT FROM AUTHOR]

The current U.S. Environmental Protection Agency protocol for testing the effectiveness of dispersants, the swirling flask test, has been found to give widely varying results in the hands of different testing laboratories. The sources of the ambiguities in the test were determined by considering several options in a rigorous systematic fashion. Options considered were variability among three operators and the variability and limitations of three analytical instruments in establishing a calibration curve for oil/dispersant mixtures. Other options included flask type, impact of operational variables (rotational speed, mixing time, settling time, and oil:dispersant ratio), development of a revised procedure for dispersant effectiveness, reproducibility and repeatability of the revised procedure, and development of selection criteria for screening of dispersants. A redesign of the test flask, which is characterized by having baffles with a stopcock at the bottom for sample collection, was deemed necessary to accomplish reproducibility within operator and between operators. The results indicated that the baffled flask provided a total coefficient of variation (variations within operator and between operators) less than 11% compared to above 100% in some cases for the swirling flask. [ABSTRACT FROM AUTHOR]