Search

Ureteral stent encrustation significantly limits indwelling time and can lead to downstream urological problems. However, no ideal polymeric biomaterials have been shown to completely resist encrustation in long-term urine exposure. Recently, 2-hydroxyethyl methacrylate (HEMA)-coated Pellethane was reported as a promising biomaterial resistant to encrustation. This study compared HEMA-coated Pellethane to commercially available stents under two different artificial urine environments. To evaluate the degree and composition of encrustation on HEMA-coated Pellethane, Boston Scientific Tria, Bard InLay Optima, Cook Universa Hydrogel, and Cook Black Silicone stents were used at various dwelling times in two different artificial urine environments. In a batch-flow model, samples of stents were suspended in an artificial urine solution (AUS) at 37 °C. Every 24 h for 11 weeks, 50% of the AUS would be replaced with fresh components using a programmable peristaltic pump system. The stent materials were removed at suitable time intervals and air-dried for 24 h under sterile conditions before follow-up analysis. SEM was used to assess the degree of encrustation, and inductively coupled plasma mass spectrometry (ICP-MS) was employed to quantify the encrusted compositions, specifically for calcium, magnesium, and phosphorus. We measured the weight gain over time due to encrusted deposits on the stents and quantified the amount of Ca, Mg, and P deposited on each encrusted stent. After the 11 week trial, HEMA-coated Pellethane showed the most average mass change. SEM showed that HEMA-coated Pellethane was fully encrusted in just 2 weeks in the AUS environments, and ICP-MS showed that Ca is the most abundant deposit. Among all the tested stents, Black Silicone performed the best. The two AUSs were formulated to encrust more rapidly than physiological conditions. HEMA-coated Pellethane is not an ideal stent material, while silicone is a promising material for advancing ureteral stents.

Introduction: The creation of synthetic reservoirs for bladder replacement has been limited by challenges of interfacing synthetic materials and native tissue. We sought to overcome this challenge by utilizing a novel bilayer silk fibroin scaffold (BLSF) as an intermediary toward the development of an acellular prosthetic reservoir. Methods: Under institutionally approved protocols, 3D-printed reservoirs were implanted in six juvenile female pigs after cystectomy. BLSF was attached to the in situ prosthetic reservoir serving as an intermediary to native ureteral and urethral tissue anastomoses. Our first protocol allowed four pigs to be survived up to 7 days, and the second protocol allowed two pigs to be survived for up to 1 year. At the first sign of functional decline or the end of the study period, the animals were euthanized, and kidneys, ureters, prosthetic bladder, and urethra were harvested en bloc for histopathology analysis. Results: The first two pigs had anastomotic urine leaks because of design flaws resulting in early termination. The third pig had acute renal failure resulting in early termination. The artificial bladder design was modified in subsequent iterations. The fourth pig survived for 7 days and, upon autopsy, had intact urethral and ureteral anastomoses. The fifth and sixth pigs survived for 11 and 12 weeks, respectively, before they were sacrificed because of failure to thrive. One animal developed an enteric fistula. The other animal had an intact anastomosis, and the BLFS was identified at the ureteral and urethral anastomoses on histopathologic analysis. Conclusions: Replacing the porcine bladder with a prosthetic bladder was achieved for up to 3 months, the second longest survival period for a nonbiologic bladder alternative. BLSF was used for the first time to create an interface between synthetic material and biologic tissue by allowing ingrowth of urothelium onto the acellular alloplastic bladder.

Ureteral reconstruction with autologous tissue grafts is often limited by tissue availability and donor site morbidity. This study investigates the performance of acellular, bi-layer silk fibroin (BLSF) scaffolds in a porcine model of ureteroplasty. Tubular ureteroplasty with BLSF grafts in combination with transient stenting for 8 weeks was performed in adult female, Yucatan, mini-swine (N = 5). Animals were maintained for 12 weeks post-op with imaging of neoconduits using ultrasonography and retrograde ureteropyelography carried out at 2 and 4 weeks intervals. End-point analyses of ureteral neotissues and unoperated controls included histological, immunohistochemical (IHC), histomorphometric evaluations as well as ex vivo functional assessments of contraction/relaxation. All animals survived until scheduled euthanasia and displayed mild hydronephrosis (Grades 1-2) in reconstructed collecting systems during the 8 weeks stenting period with one animal presenting with a persistent subcutaneous fistula at 2 weeks post-op. By 12 weeks of scaffold implantation, unstented neoconduits led to severe hydronephrosis (Grade 4) and stricture formation in the interior of graft sites in 80% of swine. Bulk scaffold extrusion into the distal ureter was also apparent in 60% of swine contributing to ureteral obstruction. However, histological and IHC analyses revealed the formation of innervated, vascularized neotissues with a-smooth muscle actin+ and SM22α+ smooth muscle bundles as well as uroplakin 3A+ and pan-cytokeratin + urothelium. Ex vivo contractility and relaxation responses of neotissues were similar to unoperated control segments. BLSF biomaterials represent emerging platforms for tubular ureteroplasty, however further optimization is needed to improve in vivo degradation kinetics and mitigate stricture formation.

The newly reclaimed soil is an important reserve land resource, while it faces challenges such as poor water retention and low fertility. Therefore, it requires improvement through the use of soil amendments. Attapulgite (ATP) is abundant in northwest China with excellent properties and can be used as an amendment for newly reclaimed soil. The effects of ATP and its addition rate on infiltration and evaporation characteristics in newly reclaimed soil were studied by experiments and model simulation. Three addition gradients (2%, 4%, and 6%) were set in this study, and no ATP addition was used as a control (CK). The results show that ATP treatment prolonged the infiltration duration, reduced the wetting front migration distance, and reduced the accumulated evaporation. Both the Philip model and the Kostiakov model can accurately describe the infiltration process of newly reclaimed soil with ATP addition; the soil evaporation process can be fitted well with the Rose model. In this study, ATP addition affected both sorptivity and the stable infiltration rate of the reclaimed soil. During the evaporation, the soil evaporation effect was inversely proportional to the addition rates of ATP, and the ATP addition rate at 2% had the best effect on reducing soil evaporation. In summary, the ATP addition was beneficial top soil infiltration and evaporation, thus improving the poor water retention of newly reclaimed land and is a reasonable choice for efficient construction of new reclaimed land. [ABSTRACT FROM AUTHOR]

PurposeCoconut water has long been touted for its medicinal qualities including natural hydration. We sought to determine whether its consumption would induce changes to urinary lithogenic factors beyond changes in urine volume.Materials and methodsAfter Institutional Review Board approval, volunteers with no prior history of nephrolithiasis were recruited. Each participant was randomized initially to either the coconut water or the water phase of the study. Participants kept meticulous food and fluid intake logs during the first phase of the study and were asked to replicate that diet for the second phase. For each phase the participant consumed 2L of either Taste of Nirvana® pure coconut water or tap water daily for four days. Participants were not restricted to consume additional fluid of their choice during their assigned study phase. During days 3 and 4 of each phase the participant collected a 24-hour urine specimen. Coconut water citrate and malate content were measured and were used along with the beverage pH to calculate the total alkali content of the coconut water. Supersaturation levels were calculated using Equil2. Nonparametric paired analysis using the Wilcoxon test was performed for statistical analysis.ResultsThere were 4 adult male and 4 adult female participants. Each individual's 24-hour urine collection had a creatinine excretion within 20% of the mean for each subject's four samples corroborating that all samples were collected properly. The two samples from each phase for each individual were averaged. The coconut water itself was also analyzed and it was calculated to have a total alkali content of 13.8 mEq/L. Consumption of coconut water significantly increased urinary citrate (29%, p=0.02), urinary potassium (130%, p=0.01), and urinary chloride (37%, p=0.03), without affecting urine pH (p=0.16) or volume beyond that of tap water (p=1.00).ConclusionsCoconut water consumption increases urinary potassium, chloride, and citrate in nonstone forming individuals.

Purpose: Retrograde intrarenal surgery is the gold-standard treatment for most kidney stones. During ureteroscopy, ureteral access sheath insertion at forces greater than 8.0 Newtons (N) risks high-grade ureteral injury. To monitor force, our institution utilizes a unique, Bluetooth-equipped device (i.e., the University of California—Irvine Force Sensor). Given the unique nature of the force sensor, we sought to develop an inexpensive and accessible force sensor based on Boyle's law and the specific amount of force required to compress an occluded 1.0 mL syringe. Materials and Methods: We evaluated three brands of 1.0 mL syringes. After setting the plunger at 1.0 mL, the syringe was occluded, and the syringe plunger was compressed. The syringe volume was recorded when the applied force on the plunger reached 4.0 N, 6.0 N, and 8.0 N. Multiple trials were performed to assess reliability and reproducibility. A method for applying this clinically was also developed. Results: The precise force thresholds identified for a 1.0 mL Luer-Lok™ Syringe (Becton Dickinson, Franklin Lakes, NJ) were 0.30 mL for 4.00 N, 0.20 mL for 6.00 N, and 0.15 mL for 8.00 N. The 1.0 mL Tuberculin Syringe and 1.0 mL Luer Slip Syringe were less precise, but compression from 1.0 to 0.40 mL, 0.25 mL, and 0.20 mL corresponded to force sensor readings that did not exceed 4.00 N, 6.00 N, and 8.00 N, respectively. Conclusions: Based on volume changes, 4.00 N, 6.00 N, and 8.00 N of force can be reliably and reproducibly achieved using an occluded 1.0 mL syringe. [ABSTRACT FROM AUTHOR]

Introduction: Electromotive Drug Administration (EMDA) amplifies drug delivery deep into targeted tissues. We tested, for the first time, the ability of EMDA to deliver methylene blue into the urothelium of the renal pelvis. Materials and Methods: In an anesthetized female pig, both proximal ureters were transected two inches distal to the ureteropelvic junction. An 8F dual lumen catheter and a 5F fenestrated catheter with an indwelling silver wire were inserted into both renal pelvises following which methylene blue (0.1%) was infused at a rate of 5 mL/min for 20 minutes. In one pelvis, a 4 mA positive pulsed electrical current was applied to the silver wire. Results: In contrast to the control pelvis, the EMDA side macroscopically exhibited dense homogeneous staining; microscopy revealed penetration of methylene blue into the urothelium/lamina propria. Conclusion: In the porcine renal pelvis, application of EMDA increased the penetration of a charged molecule into the urothelium/lamina propria. [ABSTRACT FROM AUTHOR]