Search

Herein, this report uses Co3O4 nanoneedles to decorate Mo-Co3O4 nanosheets over Ni foam, which were fabricated by the hydrothermal route, in order to create a supercapacitor material which is compared with its counterparts. The surface morphology of the developed material was investigated through scanning electron microscopy and the structural properties were evaluated using XRD. The charging storage activities of the electrode materials were evaluated mainly by cyclic voltammetry and galvanostatic charge-discharge investigations. In comparison to binary metal oxides, the specific capacities for the composite Co3O4@Mo-Co3O4 nanosheets and Co3O4 nano-needles were calculated to be 814, and 615 C g−1 at a current density of 1 A g−1, respectively. The electrode of the composite Co3O4@Mo-Co3O4 nanosheets displayed superior stability during 4000 cycles, with a capacity of around 90%. The asymmetric Co3O4@Mo-Co3O4//AC device achieved a maximum specific energy of 51.35 Wh Kg−1 and power density of 790 W kg−1. The Co3O4@Mo-Co3O4//AC device capacity decreased by only 12.1% after 4000 long GCD cycles, which is considerably higher than that of similar electrodes. All these results reveal that the Co3O4@Mo-Co3O4 nanocomposite is a very promising electrode material and a stabled supercapacitor. [ABSTRACT FROM AUTHOR]

The influence of Ag doping on the SnO2 sensor operating at room temperature is reported in this work. The SnO2 and Ag-doped SnO2 films are deposited by the nebulizer spray pyrolysis method with different Ag (1, 2, 3, and 4 wt%) concentrations. The characterization of doped thin films was done using multiple advanced techniques to understand their crystallization, morphology, optical and electrical properties to find the optimized Ag concentration on the SnO2 surface. It was found that the doping of different concentrations into the SnO2 lattice increases the preferential orientation of the peak along (211) plane up to 3wt% Ag and starts decreasing at 4 wt%. The estimated crystallite size of the 3wt% Ag-doped SnO2 thin films shows larger value of 98 nm with improved thickness and decreased strain. The morphologies of all the prepared thin films exhibits small leafy flakes structure with change in the particle size and improved agglomeration with increased Ag concentration. The optical studies showed better transparency in the visible and near-IR regions with decreased transmittance and increase in bandgap with increasing Ag concentration in SnO2. The PL results suggest that the 3wt% Ag-doped SnO2 has high-intensity emission peaks over the visible regions indicating the presence of more oxygen vacancies which acts as recombination centers to trap large amount of target gas. Finally, the gas sensing properties of the samples at different concentration of ammonia gas (i.e., 50, 100, 150, 200, and 250 ppm) are studied, which revealed that the 3wt% Ag-doped SnO2 showed better sensitivity/response of 120% with maximum response and recovery times of 32 and 17 s at 250 ppm of ammonia gas. Thus, the undoped SnO2 has been optimized with different doping amounts of Ag ions to obtain the best ammonia sensor. [ABSTRACT FROM AUTHOR]

There is a growing interest in supercapacitors as energy storage systems due to their high specific power, fast charge/discharge rates, and long cycling stability. Researchers have focused recently on developing nanomaterials to enhance the capacitive performance of supercapacitors. The inclusion of electroactive components, such as transition metal oxides (TMOs), carbonbased materials, and conducting polymers (CPs), is believed to play an important role in improving the electrochemical behavior of the electrode materials. Nevertheless, supercapacitors containing TMOs, carbon-based materials, and CPs commonly suffer from inferior ion-transport kinetics and poor electronic conductivity, which can affect the rate capability and cycling stability of the electrodes. Therefore, the development of TMO/CP and TMO/carbon-based electrode materials has gained widespread attention because they synergistically combine the advantages of both materials, enabling revolutionary applications in the electrochemical field. In general, TMOs have given good performance as electrodes for supercapacitors by further increasing the performance of the electrode when two metal cations are introduced into a single crystal structure. This Review describes and highlights recent progress in the development of bimetallic oxides regarding their design approach, configurations, and electrochemical properties for supercapacitor applications, at the same time providing new opportunities for future energy storage technologies. [ABSTRACT FROM AUTHOR]