Search

We have investigated the interdependence of various factors (particle size, surface smoothness, carrier particle shape, inhalation flow rate) on the deposition of a model drug (salbutamol sulphate) after aerosolization from a model inhaler device (Rotahaler). Different batches of alpha-lactose monohydrate were prepared to have different particle size, particle shape and surface smoothness. Each batch of lactose was then mixed separately with salbutamol sulphate in a ratio of 67.5 : 1 (w/w), under similar conditions. Drug deposition from each formulation was investigated using a 4-stage liquid impinger after aerosolization at 28.3, 60.0 and 96.0 L min(-1) via a Rotahaler. At a flow rate of 28.3 L min(-1), a large portion of drug particles was not emitted from the inhaler, the % emission varying from 29.6% to 66.6% for all formulations investigated. Drug emission tended to increase with particle size of the carrier whilst fine particle fraction, fine particle dose and dispersibility appeared to increase with decreasing particle size but increasing elongation ratio of the carrier particles. Increasing the flow rate to 60.0 L min(-1) was shown to increase drug emission since > 75% total dose was found to be emitted from the inhaler. Again, smaller or more elongated lactose particles resulted in a higher fine particle dose or fine particle fraction of salbutamol sulphate than the coarser carrier, although they produced a similar (analysis of variance P > 0.05) drug emission. Increasing the flow rate to 96.0 L min(-1) did not increase drug emission. Increasing the flow rate resulted in an increase in the fine particle fraction and fine particle dose of salbutamol sulphate from all formulations. The flow rate of the airstream appeared to play the most important role, followed by particle size and elongation ratio of the carrier particles, with the surface smoothness relatively less significant in determining the deposition of salbutamol sulphate from the Rotahaler.

Purpose: To crystallize lactose under static conditions with a view to preparing crystals of well-defined morphology., Methods: et-Lactose monohydrate was crystallized from neutralized Carbopol 934 gels. When the majority of crystals had grown to maturity, the gels were acidified using diluted hydrochloric acid and the crystals were harvested by filtration or centrifugation and washed with ethanol-water mixtures., Results: Crystals prepared from the gel had a consistently narrower size distribution than control crystals, prepared from solution under constant stirring. If crystallization was effected in the gel without sedimentation of the crystals, then the resultant crystals had smooth surfaces without visually detectable surface roughness or asperities viewed by optical microscopy. The crystals from Carbopol gels also exhibited the uniform shape of an elongated tomahawk regardless of the crystallization conditions, in contrast to crystallization under constant stirring, where the crystal shape of lactose changed with crystallization conditions especially as a function of the initial concentration of lactose. All batches of lactose crystals prepared from Carbopol gels existed as alpha-lactose monohydrate, which showed better flowability than the controls of a similar particle size., Conclusions: Crystallization from Carbopol gel produces lactose crystals of uniform size, regular shape, smooth surface, and improved flowability.

Lactose has been widely used as a carrier for inhalation aerosols. The carrier morphology is believed to affect the delivery of the drug. The aim of this study was to investigate the effects of crystallization conditions on the morphology of alpha-lactose monohydrate intended for use as the carrier for dry powder aerosols. The crystallization of lactose was carried out from aqueous solutions at different supersaturations, temperatures, different stages of crystallization and in the presence of different water-miscible organic solvents. The majority of lactose crystals were found to be either tomahawk-shaped or pyramidal after crystallization at an initial lactose concentration between 33-43% w/w, but these became prismatic if the lactose concentration was increased to 50% w/w. A further increase in the lactose concentration to 60% w/w led to the preparation of elongated cuboidal crystals. Higher initial lactose concentrations tended to result in the crystallization of more elongated particles. Crystallization at 40 degrees C was shown to prepare lactose crystals with a more regular shape and a smoother surface than those crystallized at 0 degrees C. Lactose particles generated during the later stage of crystallization were found to be more regular in shape with a smoother surface than those prepared in the earlier stage. The addition of 10% (v/v) methanol or ethanol or acetone to the mother liquor increased the growth rate of lactose particles whereas addition of propanol or glycerine inhibited the rate of crystal growth. Lactose crystals prepared in the presence of glycerine were more regularly shaped with a smoother surface than those prepared in the presence of ethanol or acetone. All the resultant crystals were shown to comprise alpha-lactose monohydrate. Lactose crystals could be prepared with a precisely defined morphology by means of carefully controlling the crystallization conditions.

Five different grades of lactose namely, anhydrous lactose, medium lactose, regular lactose, lactose crystals and foremost lactose were fractionated under similar conditions to obtain a size range of 63-90 microm and were characterised using laser diffraction and time-of-flight particle sizing techniques, scanning electron microscopy, optical microscopy image analysis, thermal gravimetric analysis and differential scanning calorimetry. Each of these lactose fractions were then blended separately with micronised salbutamol sulphate in a ratio of 67.5:1 (w/w). The mixing uniformity and percentage recovery of salbutamol sulphate in the powder blends were analysed using a validated HPLC method. The deposition profiles of the drug were determined using a 5-stage liquid impinger after aerosolisation at 60 l min(-1) via a Rotahaler. Despite the identical processing conditions, the lactose fractions were shown to differ in particle size, size distribution and concentrations of fine particles. The particles from each fraction also exhibited different surface textures and dissimilar DSC thermograms. However, all the blends of the lactose with salbutamol sulphate were found to have a relatively high uniformity of salbutamol sulphate content, as suggested by a coefficient of variation of less than 3.2%. Anhydrous and medium lactose produced a more efficient delivery of salbutamol sulphate when aerosolised from the Rotahaler in comparison to other grades of lactose. For example, the fine particle fraction (FPF) and fine particle dose (FPD) of drug from formulations containing anhydrous lactose were 13.4+/-4.2% and 57.3+/-17.6 microg, respectively, which were approximately two times higher than the respective values of the formulation containing regular lactose. Medium lactose resulted in drug FPF (7. 9+/-2.7%) and FPD (32.4+/-11.8 microg), which were significantly (ANOVA P<0.05) higher than the same parameters obtained using lactose crystals, foremost lactose and regular lactose. More efficient drug delivery from anhydrous lactose may be partly attributed to the relatively higher concentration of fine lactose in this grade of carrier, although it showed a rougher surface than the other grades of lactose. However, the relatively high FPF of the drug from medium lactose may have been due to the relatively small mean particle size and smooth surface of the particles. Therefore, the source and grade of lactose may have a substantial effect on drug delivery from dry powder inhaler formulations and care should be taken in establishing appropriate quality control parameters when selecting an appropriate grade of carrier.

Ternary mixtures composed of coarse lactose (CL) (90.8 microm), salbutamol sulphate (SS) (5.8 microm) and either micronised lactose (ML) (5 microm) or intermediate sized lactose (IML) (15.9 microm) in a ratio of 66.5:1:1 w/w were prepared using different mixing sequences of the various components. In addition, a binary mixture composed of CL and SS (67.5:1 w/w) was also prepared as the control. The in vitro deposition of SS was measured using a twin stage impinger after aerosolisation at 60 and 90 l min-1 via a Rotahaler. The aerodynamic particle size distribution of both the aerosolised SS and lactose was further analysed using an Andersen cascade impactor at 60 l min-1. All ternary mixtures produced a significantly higher (analysis of variance, P<0.01) fine particle fraction (FPF) and fine particle dose (FPD) of SS than the control after aerosolisation at either 60 or 90 l min-1. Formulations containing the ML produced significantly (P<0.05) higher FPF and FPD of SS than those containing the IML at both aerosolisation flow rates. Different mixing sequences were also shown to result in different deposition profiles of both SS and lactose after aerosolisation of the ternary mixtures containing ML at 60 l min-1. The formulation prepared by first blending ML with CL before mixing with SS produced a higher FPF and FPD of SS but a lower FPF of lactose than the same formulation in terms of composition but prepared using different mixing orders of the three components. In contrast, the formulations containing IML produced a similar deposition profile to SS, regardless of the mixing sequences, and so did the formulations containing ML aerosolised at 90 l min-1. These results suggest that the effect of mixing sequences on drug deposition may become more prominent at lower aerosolisation flow rates and by reducing the size of any added fine lactose.

Nine tumor markers in serum including alpha-fetoprotein (AFP), r-glutamyltranspeptidase (GGT), lactate dehydrogenase (LDH), alpha 1-antitrypsin (alpha 1-AT), total sialic acid (TSA), ferritin (Ft), ceruloplasmin (CP), LDH isoenzymes and GGT isoenzymes were used for differential diagnosis of primary liver cancer. Of 5 measurement data tested by statistics, CP and TSA were close to normal distribution (P > 0.1), GGT, LDH and alpha 1-AT showed skewness distribution or to be close to normal distribution with in transformation (P > 0.1). The results indicated that the determination of the cut-off value should depend on the statistical distribution of data. Analysis of single and dual-combination tests as well as triple analysis with sequential progressive screening had been performed to evaluate the predictive value of clinical diagnosis, i.e. the sensitivity, the specificity and the correct diagnosis efficiency. Three predictive values of a single test were lower than what clinical diagnosis raqvest. The dual-combination tests had higher specificity but a lower sensitivity. For triple analysis with sequential progressive screening among the liver cancer group (n = 23), the related disease group (n = 44) and the healthy individuals group (n = 40), the correct diagnosis efficiency was 95%, 97.3% and 100%, respectively. This suggests that the method described here has potential value in clinical practice.

We detected the presence and distribution of HBcAg in the liver by immunohistochemistry (ABC method) and the presence of HBV-DNA in serum (spot hybridization) and anti-HBe in serum (ELISA) from 59 cases of hepatitis B hospitalized in our hospital, including 47 cases of CAH, 5 cases of CPH, and 7 cases of subacute fulminant hepatitis. 1. HBcAg in the liver was detected in 25 out of 47 cases (53%) of CAH, in 2 out of 5 cases of CPH and in 4 out of 7 cases of subacute fulminant hepatitis. The total percentage was 53% (31/59). 2. There was no positive correlation between HBV replication activity and liver disease activity (P greater than 0.05). Our results did not support the hypothesis that suggests a direct cytopathic effect of HBV. Oppositely, the fact was that the presence, the amount and the patterns of HBcAg in the liver, and the presence of HBV-DNA in serum were predominant in mild CAH compared with those in severe CAH, predominant in CAH without cirrhosis compared with those in CAH with cirrhosis. There was a tendency of inverse correlation between HBV replication activity and liver disease activity. The results above were in line with the concept that HBcAg expressed on the surface of infected hepatocytes may be relevant target for T lymphocyte cytotoxicity. The results have suggested that an immune response to HBV is present, leading to the destruction of most infected cells. 3. There was a positive correlation between HBV-DNA in serum and HBcAg in the liver (P less than 0.005), indicating that HBV-DNA in serum can represent HBV replication.(ABSTRACT TRUNCATED AT 250 WORDS)