Search

A method based on solid-phase microextraction (SPME) followed by on-fiber derivatization and gas chromatography-mass spectrometry detection (GC-MS) for determination of phenol in air was developed. Three different types of SPME fibers, polar and non-polar poly(dimethylsiloxane) (PDMS) and polyethylene glycol (PEG) were synthesized using sol-gel technology and their feasibility to the sampling of phenol were investigated. Different derivatization reagents for post on-fiber derivatization of phenol were studied. Important parameters influencing the extraction and derivatization process such as type of fiber coating, type and volume of derivatizing reagent, derivatization time and temperature, extraction time, and desorption conditions were investigated and optimized. The developed method is rapid, simple, easy and inexpensive and offers high sensitivity and reproducibility. Under the optimized conditions, the detection limit of the method was 5 ng L(-1) using selected ion monitoring (SIM) mode. The inter-day and intra-day precisions of the developed method under optimized conditions were below 10%, and the method shows linearity in the range of 20 ng L(-1) to 500 μg L(-1) with the correlation coefficient of >0.99. The optimized method was applied to the sampling of phenol from some biologics production areas. The compared results obtained using current and standard methods were shown to be satisfactory., (Copyright © 2012 Elsevier B.V. All rights reserved.)

Novel solid-phase microextraction fibers were prepared based on sol-gel technique. Commonly used fused silica substrate was replaced by titanium wire which provided high strength and longer fiber life cycle. Titanium isopropoxide was employed as the precursor which provides a sol solution containing Ti-OH groups and shows more tendencies to the molecularly similar group on the substrate. Three different polymers, poly (dimethylsiloxane) (PDMS), poly(ethylenepropyleneglycol)-monobutyl ether (Ucon) and polyethylene glycol (PEG) were employed as coating polymer in preparing three different fibers. The applicability of these fibers was assessed for the headspace SPME (HS-SPME) of benzene, toluene, ethylbenzene and xylenes (BTEX) from water sample followed by gas chromatography-mass spectrometry (GC-MS). Effects of different parameters such as fiber coating type, extraction condition, desorption condition were investigated and optimized. Under the optimized conditions, LODs and LOQs of 0.75-10 μg L(-1) (S/N=3) and 1-20 μg L(-1) (S/N=10) were respectively obtained. The method showed linearity in the range of 10-25,000 μg L(-1) with correlation coefficient of >0.99. The relative standard deviation was less than 8%., (Copyright © 2012 Elsevier B.V. All rights reserved.)

Chemical modification or mutation of proteins may bring about significant changes in the net charge or surface hydrophobicity of a protein structure. Such events may be of major physiological significance and may provide important insights into the genetics of amyloid diseases. In the present study, fibrillation potential of native and chemically-modified forms of bovine carbonic anhydrase II (BCA II) were investigated. Initially, various denaturing conditions including low pH and high temperatures were tested to induce fibrillation. At a low pH of around 2.4, where the protein is totally dissociated, the apo form was found to take up a pre-molten globular (PMG) conformation with the capacity for fibril formation. Upon increasing the pH to around 3.6, a molten globular (MG) form became abundant, forming amorphous aggregates. Charge neutralization and enhancement of hydrophobicity by methylation, acetylation and propionylation of lysine residues appeared very effective in promoting fibrillation of both the apo and holo forms under native conditions, the rates and extents of which were directly proportional to surface hydrophobicity, and influenced by salt concentration and temperature. These modified structures underwent more pronounced fibrillation under native conditions, than the PMG intermediate form, observed under denaturing conditions. The nature of the fibrillation products obtained from intermediate and modified structures were characterized and compared and their possible cytotoxicity determined. Results are discussed in terms of the importance of surface net charge and hydrophobicity in controlling protein aggregation. A discussion on the physiological significance of the observations is also presented., (Copyright © 2011 Elsevier B.V. All rights reserved.)