Search

On 22 October 2019, the Francolí River basin in Catalonia, north-eastern Spain, experienced a heavy precipitation event that resulted in a catastrophic flash flood, causing six fatalities. Few studies comprehensively address both the physical and human dimensions and their interrelations during extreme flash flooding. This research takes a step forward towards filling this gap in knowledge by examining the alignment among all these factors. The hydrometeorological factors are investigated using the new Triangle-based Regional Atmospheric Model, radar-derived precipitation estimates, post-flood field and gauge observations, and the Kinematic Local Excess Model. The social dimension is assessed by examining the relationship between catchment dynamics and warning response times and by quantifying human behaviour during the course of the flash flood through a post-event citizen science campaign. Results reveal that a persistent south-easterly airflow brought low-level moisture and established convective instability in the region, while local orography was instrumental to triggering deep moist convection. A convective train promoted intense, copious, and prolonged precipitation over the north-western catchment headwaters. Basin response was significantly modulated by the very dry initial soil moisture conditions. After the long-lasting rainfall, an acute burst of precipitation resulted in extreme flash flooding. Fast and abrupt increases in streamflow affect small spatial scales and leave limited time for the effective implementation of protective measures. The institutional organization–protection–prevention cycle unfolded at the spatial and temporal scales typically dominated by the meteorological rather than hydrological scales. Although the citizen science campaign reveals the effectiveness of the warnings in reaching the population living in the most affected areas, a significant proportion of the respondents expressed a lack of adequate information or were unfamiliar with the intended meaning. In addition, a majority of the interviewees did not perceive any significant threat to life or property. In view of these results, this study identifies potential areas for improving social preparedness for similar natural hazards in the future.

On 12 and 13 September 2019, a long-lasting heavy precipitation episode (HPE) affected the València, Murcia and Almería regions in eastern Spain. Observed rainfall amounts were close to 500 mm in 48 h, being the highest cumulative precipitation registered in some rain gauges for the last century. Subsequent widespread flash flooding caused seven fatalities and estimated economical losses above EUR 425 million. High-resolution precipitation estimates from weather radar observations and flood response from stream gauges are used in combination with a fully distributed hydrological model to examine the main hydrometeorological processes within the HyMeX programme. This HPE was characterized by successive, well-organized convective structures that impacted a spatial extent of 7500 km2, with rainfall amounts equal to or larger than 200 mm. The main factors driving the flood response were quasi-stationarity of heavy precipitation, very dry initial soil moisture conditions and large storage capacities. Most of the examined catchments exhibited a dampened and delayed hydrological response to cumulative precipitation: until runoff thresholds were exceeded, infiltration-excess runoff generation did not start. This threshold-based hydrological behaviour may impact the shape of flood peak distributions, hindering strict flood frequency statistical analysis due to the generally limited lengths of data records in arid and semi-arid catchments. As an alternative, a power-law relationship is analytically derived to specifically link flood magnitude to rainfall amount, with the parameters depending on basin and precipitation features. This power law could aid in developing empirical envelope curves so as to assess hydrologic risk in arid and semi-arid catchments with a threshold-based hydrological behaviour.

Study region: Francolí River (Catalonia, Iberian Peninsula). Study focus: The aim is the reconstruction of the October 2019 flash flood, that was documented through extensive field work: rainfall (300 mm in just a few hours), flood marks, times of flood passage and witnesses' snapshots and reports, channel changes, log drift (20,000 trees) and woody debris at bridges, as well as large damage and six fatalities. The methods are: hydrological model built for the rainfall-runoff in the basin and the flood routing in the river, use of hydraulic principles such as flow at waterfalls, flow against obstacles (trees), etc. and finally 1D/2D free surface numerical models. New hydrological insights: The uppermost 100 km2 produced discharges of 700 m3/s (up to 50 m3/s/km2, locally). Three bridges failed, but their cascading failure (when one failure triggers the next one downstream) was not proved. The main channel widened more than 10 times, dragging away soil and vegetation like a bulldozer. The resulting large wood debris that clogged two bridges worsened the inundation. An anomalous flow downstream, probably a surge of around 1090 m3/s, due to the failure of a woody jam at a narrow bridge, took two lives. Water Authority is now warning flood planners that vegetated, torrential basins may cause catastrophic floods in the valley towns, if their narrow bridges are sensitive to woody debris.

This study aims at evaluating the performances of flash-flood forecasts issued from deterministic and ensemble meteorological prognostic systems. The hydrometeorological modeling chain includes the Weather Research and Forecasting Model (WRF) forcing the rainfall-runoff model MARINE dedicated to flash floods. Two distinct ensemble prediction systems accounting for (i) perturbed initial and lateral boundary conditions of the meteorological state and (ii) mesoscale model physical parameterizations have been implemented on the Agly catchment of the eastern Pyrenees with three subcatchments exhibiting different rainfall regimes. Different evaluations of the performance of the hydrometeorological strategies have been performed: (i) verification of short-range ensemble prediction systems and corresponding streamflow forecasts, for a better understanding of how forecasts behave; (ii) usual measures derived from a contingency table approach, to test an alert threshold exceedance; and (iii) overall evaluation of the hydrometeorological chain using the continuous rank probability score, for a general quantification of the ensemble performances. Results show that the overall discharge forecast is improved by both ensemble strategies with respect to the deterministic forecast. Threshold exceedance detections for flood warning also benefit from large hydrometeorological ensemble spread. There are no substantial differences between both ensemble strategies on these test cases in terms of both the issuance of flood warnings and the overall performances, suggesting that both sources of external-scale uncertainty are important to take into account.

An extraordinary convective rainfall event, unforeseen by most numerical weather prediction models, generated a devastating flash flood (305 m3 s−1) in the town of Sant Llorenç des Cardassar, Mallorca, on 9 October 2018. Four people died inside this village, while casualties were up to 13 over the entire affected area. This extreme event has been reconstructed by implementing an integrated flash flood modelling approach in the Ses Planes catchment up to Sant Llorenç (23.4 km2), based on three components: (i) generation of radar-derived precipitation estimates, (ii) modelling of accurate discharge hydrographs yielded by the catchment (using FEST and KLEM models), and (iii) hydraulic simulation of the event and mapping of affected areas (using HEC-RAS). Radar-derived rainfall estimates show very high agreement with rain gauge data (R2=0.98). Modelled flooding extent is in close agreement with the observed extension by the Copernicus Emergency Management Service, based on Sentinel-1 imagery, and both far exceed the extension for a 500-year return period flood. Hydraulic simulation revealed that water reached a depth of 3 m at some points, and modelled water depths highly correlate (R2=0.91) with in situ after-event measurements. The 9 October flash flood eroded and transported woody and abundant sediment debris, changing channel geomorphology. Water velocity greatly increased at bridge locations crossing the river channel, especially at those closer to the Sant Llorenç town centre. This study highlights how the very low predictability of this type of extreme convective rainfall events and the very short hydrological response times typical of small Mediterranean catchments continue to challenge the implementation of early warning systems, which effectively reduce people's exposure to flash flood risk in the region.

During the hydrological year 2015–2016 (September to August) a severe drought affected the Balearic Islands, with substantial consequences (alleviated partially by desalination plants) on water availability for consumption from reservoirs and aquifers and also on the vegetation cover. In particular, a plague of Xylella fastidiosa reached an alarming level for almond and olive trees. The expansion of this infestation could be attributed to, or at least favored by, the extreme drought. In this paper we analyze this anomalous episode in terms of the corresponding water balance in comparison with the balance obtained from long-term climatological data. It is shown that the drought was the result of a lack of winter precipitation, the lowest in 43 years, which led to a shortage of water storage in the soil. In several meteorological stations analyzed, evaporation was greater than precipitation during all the months of the year. In terms of attribution, it is found that during the 2015–2016 winter the atmospheric circulation over the North Atlantic was largely westerly and intense, with high values of the NAO index that were reflected in high pressures over the Iberian Peninsula and the western Mediterranean.

Understanding the spatial distribution of extreme precipitations is of major interest in order to improve our knowledge of the climate of a region and its relationship with society. These analyses inevitably require the use of directly observed values to account for the actual extreme amounts rather than analyzed gridded values. A study of daily rainfall extremes observed over mainland Spain and the Balearic Islands is performed by using records from 8135 rain gauge stations from the Spanish Weather Agency (AEMET). Results show that the heaviest daily precipitations have been observed mainly on the coastal Mediterranean zone from Gibraltar to the Pyrenees. In particular, a record value of 817 mm was recorded in the Valencia region in 1987. The current map of daily records in Spain, which updates the pioneering work of the Spanish meteorologist Font, shows similar distribution of extreme events but with notably higher amounts. Generalized extreme values distributions fit the Mediterranean and Atlantic rain gauge measurements and shows the different characteristics of the extreme daily precipitations in both regions. We identify the most extreme events (above 500 mm per day) and provide a brief description of a typical meteorological situation in which these damaging events occur. An analysis of the low-level circulation patterns producing such extremes – by means of simple indices such as NAO, WeMOi and IBEI – confirms the relevance of local flows in the generation of either Mediterranean or Atlantic episodes. WeMOi, and even more IBEI, are good discriminants of the region affected by the record precipitation event.

The improvement of the short- and mid-range numerical runoff forecasts over the flood-prone Spanish Mediterranean area is a challenging issue. This work analyses four intense precipitation events which produced floods of different magnitude over the Llobregat river basin, a medium size catchment located in Catalonia, north-eastern Spain. One of them was a devasting flash flood – known as the "Montserrat" event – which produced 5 fatalities and material losses estimated at about 65 million euros. The characterization of the Llobregat basin's hydrological response to these floods is first assessed by using rain-gauge data and the Hydrologic Engineering Center's Hydrological Modeling System (HEC-HMS) runoff model. In second place, the non-hydrostatic fifth-generation Pennsylvania State University/NCAR mesoscale model (MM5) is nested within the ECMWF large-scale forecast fields in a set of 54 h period simulations to provide quantitative precipitation forecasts (QPFs) for each hydrometeorological episode. The hydrological model is forced with these QPFs to evaluate the reliability of the resulting discharge forecasts, while an ensemble prediction system (EPS) based on perturbed atmospheric initial and boundary conditions has been designed to test the value of a probabilistic strategy versus the previous deterministic approach. Specifically, a Potential Vorticity (PV) Inversion technique has been used to perturb the MM5 model initial and boundary states (i.e. ECMWF forecast fields). For that purpose, a PV error climatology has been previously derived in order to introduce realistic PV perturbations in the EPS. Results show the benefits of using a probabilistic approach in those cases where the deterministic QPF presents significant deficiencies over the Llobregat river basin in terms of the rainfall amounts, timing and localization. These deficiences in precipitation fields have a major impact on flood forecasts. Our ensemble strategy has been found useful to reduce the biases at different hydrometric sections along the watershed. Therefore, in an operational context, the devised methodology could be useful to expand the lead times associated with the prediction of similar future floods, helping to alleviate their possible hazardous consequences.

In the framework of AMPHORE, an INTERREG III B EU project devoted to the hydrometeorological modeling study of heavy precipitation episodes resulting in flood events and the improvement of the operational hydrometeorological forecasts for the prediction and prevention of flood risks in the Western Mediterranean area, a hydrometeorological model intercomparison has been carried out, in order to estimate the uncertainties associated with the discharge predictions. The analysis is performed for an intense precipitation event selected as a case study within the project, which affected northern Italy and caused a flood event in the upper Reno river basin, a medium size catchment in the Emilia-Romagna Region. Two different hydrological models have been implemented over the basin: HEC-HMS and TOPKAPI which are driven in two ways. Firstly, stream-flow simulations obtained by using precipitation observations as input data are evaluated, in order to be aware of the performance of the two hydrological models. Secondly, the rainfall-runoff models have been forced with rainfall forecast fields provided by mesoscale atmospheric model simulations in order to evaluate the reliability of the discharge forecasts resulting by the one-way coupling. The quantitative precipitation forecasts (QPFs) are provided by the numerical mesoscale models COSMO and MM5. Furthermore, different configurations of COSMO and MM5 have been adopted, trying to improve the description of the phenomena determining the precipitation amounts. In particular, the impacts of using different initial and boundary conditions, different mesoscale models and of increasing the horizontal model resolutions are investigated. The accuracy of QPFs is assessed in a threefold procedure. First, these are checked against the observed spatial rainfall accumulations over northern Italy. Second, the spatial and temporal simulated distributions are also examined over the catchment of interest. And finally, the discharge simulations resulting from the one-way coupling with HEC-HMS and TOPKAPI are evaluated against the rain-gauge driven simulated flows, thus employing the hydrological models as a validation tool. The different scenarios of the simulated river flows – provided by an independent implementation of the two hydrological models each one forced with both COSMO and MM5 – enable a quantification of the uncertainties of the precipitation outputs, and therefore, of the discharge simulations. Results permit to highlight some hydrological and meteorological modeling factors which could help to enhance the hydrometeorological modeling of such hazardous events. Main conclusions are: (1) deficiencies in precipitation forecasts have a major impact on flood forecasts; (2) large-scale shift errors in precipitation patterns are not improved by only enhancing the mesoscale model resolution; and (3) weak differences in flood forecasting performance are found by using either a distributed continuous or a semi-distributed event-based hydrological model for this catchment.

Purpose: To evaluate the feasibility of reversing a primary failure through therapeutic mechanical stimulation induced by transcutaneous application of acoustic waves (extracorporeal shockwave therapy [ESWT]) in the peri-implant tissues. Materials and Methods: This clinical report evaluates the outcome of a new protocol proposed to treat a primary failure (loosened oral implant): application of three cycles of ESWT (one session per week for 3 consecutive weeks) with an equivalent positive energy of 0.18 mJ/mm²(therapeutic dose: 2,000 pulses, 8 Hz, 4.0 bar). Standardized intraoral radiographs and CBCT scans were taken, the implant stability quotient (ISQ) was determined, and clinical evaluations were performed. Results: It was possible to verify a progressive increase in ISQ values after the ESWT protocol: 17 initially, 46 at 2 months, and 68 at 4 months. This led to successful implant prosthetic rehabilitation (35 Ncm). Follow-up evaluations at 6 years confirm that the new bone-implant interface is preserved and that ESWT is a safe, noninvasive treatment. Conclusions: In the context of the new dynamic model of osseointegration (the foreign body equilibrium), this represents the first report of a host-implant equilibrium reestablished after an early implant failure process. However, more studies are needed to determine both the medical device and the most effective therapeutic range for clinical applications of this technology in oral implantology. [ABSTRACT FROM AUTHOR]