Search

Screen printing has received significant attention for manufacturing energy storage devices. However, preparing high‐quality inks is still one of the main challenges. Herein, a homogenous and stable ink based on the monoclinic phase of VO2(M) microparticles has been synthesized by a simple hydrothermal process in only 6 h and through nontoxic solutions. The VO2 ink is printed on Kapton substrate in a single‐layer as well as in a double‐layer arrangement (1‐LP and 2‐LP). The printed 1‐LP VO2 electrode delivers a maximum areal capacitance of 20 mF cm−2 with a small equivalent series resistance of 4 Ω without conducting additives. The interdigitated full‐cell VO2 supercapacitor adequately employs the electric double‐layer and Faradic redox mechanisms in 1.4 V, which is the highest operating voltage reported for symmetric supercapacitors based on pure vanadium oxide electrodes in aqueous inorganic electrolytes. Moreover, the maximum areal energy of the 2‐LP supercapacitor is 0.8 μWh cm−2 at an areal power of 21.0 μW cm−2, which is larger than the 1‐LP (0.2 μWh cm−2 at 17.5 μW cm−2). This improvement is attributed to the homogenously printed double layer of the porous VO2 microparticles. Integrating such supercapacitors into thin‐film electronics could develop portable devices. [ABSTRACT FROM AUTHOR]

This paper presents an investigation of ultrathin Cu (In1−xGax) Se2 solar cell which was calibrated from the fabricated cell using Silvaco-TCAD tools. Carrier transport mechanism and conduction band alignment at the CdS/CIGS interface shows a large influence on PV parameters. The influence of the absorber trap density on the electrical characteristics of the single junction cell was investigated under AM 1.5G one-sun (100 mW/cm2) illumination. Further simulations quantify significant improvements in cell efficiency while using a thin Al2O3 material as a rear passivation layer. In addition, the impact of the backside pitch size, opening width, absorber layer doping, and thickness on cell performance is investigated to enhance the cell efficiency. To evaluate our work, the electrical characteristics of the optimized cell were compared to the fabricated cells. [ABSTRACT FROM AUTHOR]