Search

This study evaluated the combination of high-power ultrasound (HPU), micronized salt (MS), and low KCl levels as a strategy to produce reduced sodium Bologna-type sausages. Samples with 50% NaCl reduction were produced with regular salt (RS) or MS and 0.5% KCl. The sausages were sonicated for 0 or 27 min in an ultrasonic bath (25 kHz, 60% amplitude, normal mode, 20 °C) immediately after filling. The sodium reformulation strategy was effective in compensating for the defects in the emulsion stability and texture profile caused by the NaCl reduction. Besides, the combination of HPU, MS, and KCl did not cause major impacts on the evolution of pH, Eh, and TBARS values of the sausages during storage (21 days at 4 °C). The use of MS and KCl also allowed a reduction by 50% of the NaCl content (42% Na; Na/K ratio: 1.2 to 1.3) of the samples without affecting the salty taste, which was enhanced by the HPU treatment.

Microwave-assisted solid sampling analysis coupled to flame furnace atomic absorption spectrometry (MW-SS-FF-AAS) was used for Cd and Pb determination in food-contact polymer samples, with the aim of minimizing reagents and laboratory waste. Operational parameters, such as the FF tube design, the oxygen flow rate, the flame stoichiometry, the sample mass, among others, were evaluated and optimized. Calibration was performed using only reference solutions, and the limits of quantification were 1.7 and 4.6 µg g−1 for Cd and Pb, respectively. Accuracy was assessed by the analysis of certified reference materials (CRMs), and by comparison with the results obtained by inductively coupled plasma mass spectrometry after microwave-assisted wet digestion. The MW-SS-FF-AAS results for the CRMs showed no statistical difference with the certified values, and good agreement was observed with the results of the digestion method. The MW-SS-FF-AAS method was considered suitable for Cd and Pb determination in food-contact polymers. The concentrations of Cd and Pb in the analyzed samples varied from

In this study, two methods based on the use of diluted acids were developed: microwave-assisted wet digestion (MAWD) and microwave-assisted ultraviolet digestion (MAWD-UV). These methods are evaluated for the digestion of oral pharmaceutical drugs and further determination of elemental impurities from classes 1 (As, Cd, Hg and Pb) and 2A (Co, Ni and V) by inductively coupled plasma optical emission spectrometry (ICP-OES). Commercial drugs for the treatment of type 2 diabetes are used. No prior comminution is performed. For MAWD, the optimized conditions were 2 mol L−1 or 3 mol L−1 HNO3, 1 mL of 50% H2O2 and a 45 min or 55 min irradiation program. For MAWD-UV, the condition using 1 mol L−1 HNO3, 1.6 mL of 50% H2O2 and a 55 min irradiation program enabled the digestion of all samples. In this way, efficient methods are proposed for the digestion of commercial pharmaceutical tablets for further determination of class 1 and 2A elemental impurities (ICH Q3D guidelines).