Search

Theoretical calculations based on the Density Functional Theory (DFT) have been performed to investigate the interaction of H2S as well SO2 gaseous molecules at the surfaces of Be12O12 and Mg12O12 nano-cages. The results show that a Mg12O12 nano-cage is a better sorbent than a Be12O12 nano-cage for the considered gases. Moreover, the ability of SO2 gas to be adsorbed is higher than that of H2S gas. The HOMO–LUMO gap (Eg) of Be12O12 nano-cage is more sensitive to SO2 than H2S adsorption, while the Eg value of Mg12O12 nano-cage reveals higher sensitivity to H2S than SO2 adsorption. The molecular dynamic calculations show that the H2S molecule cannot be retained at the surface of a Be12O12 nano-cage within 300–700 K and cannot be retained on a Mg12O12 nano-cage at 700 K, while the SO2 molecule can be retained at the surfaces of Be12O12 and Mg12O12 nano-cages up to 700 K. Moreover, the thermodynamic calculations indicate that the reactions between H2S as well SO2 with Be12O12 and Mg12O12 nano-cages are exothermic. Our results suggest that we can use Be12O12 and Mg12O12 nano-cages as sorbents as well as sensors for H2S and SO2 gases. [ABSTRACT FROM AUTHOR]

The FA1:Cs+ and FA2:Li+ color centers at the low coordination (100) and (110) surfaces of AgCl and AgBr play important roles in laser light generation and color image formation. Double-well potentials at these surfaces are investigated by using ab initio calculations. Quantum clusters were embedded in the simulated Coulomb fields that closely approximate the Madelung fields of the host surfaces, and ions that are the nearest neighbors to the FA - defect site are allowed to relax to equilibrium. The calculated Stokes shifts suggest that laser light generation is sensitive to the simultaneous effects of the vibrational coupling mode, the impurity cation, the coordination number of the surface ion, the lattice anion, and the choice of the basis set centered on the anion vacancy. An attempt has been made to explain these effects in terms of Madelung potential, electron affinity, and optical–optical conversion efficiency. All relaxed excited states of the defect-containing surfaces are deep below the lower edges of the conduction bands of the ground-state defect-free surfaces, suggesting that the FA(I):Cs+ and FA(II):Li+ centers are suitable laser defects. The dependence of orientational destruction, recording sensitivity, and exciton (energy) transfer on the empty cation; the coordination number of the surface ion; and the lattice anion is clarified. The Glasner–Tompkins empirical rule was generalized to include the impurity cation and the coordination number of the surface ion. As far as color image formation is concerned, the supersensitizer was found to increase the sensitizing capabilities of two primary dyes in the excited states by increasing the relative yield of quantum efficiency. The (110) surfaces of AgBr and AgCl were more sensitive than the corresponding (100) surfaces, and AgBr thin film was found to be more sensitive than that of AgCl. On the basis of quasi-Fermi levels, the difference in the sensitizing capabilities between the examined dyes in the excited states is determined. © 2005 Wiley Periodicals, Inc. Int J Quantum Chem, 2005 [ABSTRACT FROM AUTHOR]

The structural, electronic and optical properties of transition metal doped porphyrin (TM@P; TM = Mn, Co, Fe, Cu, Ni, Zn) as well as the effect of CO adsorption on TM@P properties have been investigated using the density functional theory (DFT). The presented results include adsorption energies, bond lengths, electronic configurations, magnetic moments, density of states, frontier molecular orbitals, and UV-Vis. spectra. Our calculation results show that, the CO molecule favors to be adsorbed on TM-doped Porphyrin with its carbon head. The most energetically stable adsorption of CO is reported for Fe doped Porphyrin. The interaction between CO molecules with TM@P is attributed to donation-back donation as well as charge transfer mechanisms. Mn, Co and Fe-doped porphyrins have visible active nature which may be affected by CO adsorption, whereas, Ni, Cu and Zn-doped porphyrins have UV active nature which not affected by CO adsorption. These results may be meaningful for CO removal and detection., (© 2019 Published by Elsevier Ltd.)