Search

Orthodontic tooth movement in the alveolar bone is due to the mechanical response of periodontal ligament to applied forces. Definition of a proper constitutive model of the periodontal ligament to investigate its response to orthodontic loading is required. For this purpose, a three-dimensional finite element model of incisor tooth, periodontal ligament, and bone was built utilizing the hydro-mechanical coupling theory. Tooth displacement in response to orthodontic loading was then investigated, and the effect of different mechanical behaviors assigned to the solid phase of the periodontal ligament was compared. Results showed that where the periodontal ligament was placed in tension, pore volume was filled with fluid intake from the bone, but fluid flow direction was from the periodontal ligament toward the bone where the periodontal ligament was placed in compression. Because of the existence of interaction between solid and fluid phases of the periodontal ligament, considering biphasic material formulation was capable to address its microscopic behavior as well as time-dependent and large deformation behaviors. This article provides beneficial biomechanical data for future dental studies in determination of optimal orthodontic force. [ABSTRACT FROM AUTHOR]

Despite the high success rate achieved in current dental implantation, there are still important problems to solve like incomplete early osteointegration, bone damage, and long‐term implant loosening. Highly compliant stress absorbers are a possible solution to these problems. Although several works examined the stress‐strain distribution in bone without and with absorbers to show their favorable results, none of them analyzed their impact on long‐term remodeling. Here, we analyze this effect by comparing the evolution of stress and bone mass density without and with different designs of absorbers with those of the healthy tooth. Several finite element models with ABAQUS, corresponding to each design considered, were built to obtain the mechanical conditions in bone and implant. Then a mechanobiological bone remodeling model that considers damage accumulation and its repair during the remodeling process was used to compute the bone density redistribution. This approach allows assessing both the short‐term density loss and the relative micromovement between bone and implant. We analyze the stress distributions in both bone and implant as well as the relative micromovement of the implant. We also present the evolution of damage and bone volume fraction. These results show that the addition of absorbers can reduce the stress in the bone around the implant. The obtained results also show that using stress absorbers reduces damage in bone, while increasing the number of absorbers does not necessarily improves damage reduction. We conclude that using implants with a correct design of absorbers prevents damage and stress shielding, reducing implant loosening. [ABSTRACT FROM AUTHOR]