Search

Thermal plasma is a promising technology widely used in materials processing and waste treatment due to its unique properties including high temperature, high energy density, high chemical activity, and high quench rate. Air-plasma is preferentially used because air is of low price as plasma gas. The content of NOx in off-gas from air-plasma was determined using a gas analyzer, and a treatment unit was designed for the green air-plasma process. Results show that the concentration of NOx in off-gas from air-plasma was 2,489 and 9,112 ppm when the plasma input power was 50 and 150 kW, respectively. O2 in the off-gas would act as an oxidant to promote NOx absorption; thus, alkali absorption method was directly used for the treatment of the present off-gas from air-plasma. The absorption efficiency could be increased to 62.2% when additional O2 was provided into the off-gas to change its O2 content from 20% to 50%. The absorption rate was estimated based on the experimental data and a multistage absorption unit design, which could be reduced below 100 ppm and meet the emission standard. This article presents the feasibility of thermal plasma off-gas purification, so as to truly realize the green plasma process.

Ni and Cu are the two most promising alternatives to noble metals used in electrical conductive materials. However, Cu is susceptible to oxidation, while Ni exhibits poorer electrical conductivity. To solve this problem, Cu-Ni composite nanoparticles have been prepared in the present work by successive hydrazine reduction based on the different oxidation potential between Cu (II) and Ni (II). The as-prepared products were characterized by XRD, FE-SEM, EDS, and TG, and the electrical resistivity of which was measured by four-probe method. A formation process of the composite particles was proposed and demonstrated. The Cu-Ni composite nanoparticles have a uniform diameter of about 50nm, and exhibit higher oxidation temperature than Cu and lower electrical resistivity than Ni. This novel Ni-Cu structure and method might help solve the problems associated with the oxidation of Cu and the low electrical conductivity of Ni, which would further promote the application of base metal conductive powders.

Heterostructures are highly promising photocatalyst candidates for water splitting due to their advanced properties than those of pristine components. The ZnO/Sc2CF2 heterostructure was designed in this work, and its electronic structure was investigated to explore its potential for water splitting. The assessments of binding energy, phonon spectrum, ab initio molecular dynamics, and elastic constants provide strong evidence for its stability. The ZnO/Sc2CF2 heterostructure has an indirect band gap of 1.93 eV with a type-Ⅰ band alignment. The electronic structure can be modified with strain, leading to a transition in band alignment from type-Ⅰ to type-Ⅱ. The heterostructure is suitable for water splitting since its VBM and CBM stride over the redox potential. The energy barrier and built-in electric field, resulting from the charge transfer, facilitate the spatial separation of photogenerated carriers, enhancing their utilization efficiency for redox processes. The photogenerated carriers in the heterostructures with lattice compression greater than 6% follow the direct-Z transfer mechanism. The ZnO/Sc2CF2 heterostructure is confirmed with high photocatalytic activity by a Gibbs free energy change of HER, which is 0.89 eV and decreases to −0.52 eV under an 8% compressive strain. The heterostructure exhibits a remarkable enhancement in both absorption range and intensity, which can be further improved with strains. All these findings suggest that the ZnO/Sc2CF2 heterostructure is an appreciated catalyst for efficient photocatalytic water splitting. [ABSTRACT FROM AUTHOR]

The rapid development of new energy vehicles and Lithium-Ion Batteries (LIBs) has significantly mitigated urban air pollution. However, the disposal of spent LIBs presents a considerable threat to the environment. Recycling these waste LIBs not only addresses the environmental issues but also compensates for resource shortages and generates substantial economic benefits. Current recycling processes primarily focus on the extraction of valuable metals, often overlooking the treatment of residual waste post-extraction. This project targets the iron phosphate (FePO4) derived from waste lithium iron phosphate (LFP) battery materials, proposing a direct acid leaching purification process to obtain high-purity iron phosphate. This purified iron phosphate can then be used for the preparation of new LFP battery materials, aiming to establish a complete regeneration cycle that recovers lithium carbonate and iron phosphate from waste LFP materials for the production of LFP. The study investigates process parameters such as acid types and concentrations, leaching time, and the number of leaching cycles. The results demonstrate that, after purification, the levels of impurity metals decrease while the iron content increases correspondingly. Under optimized experimental conditions, the dilute sulfuric acid leaching rates of Al, Cu, Ca, and Ni reached 36.0%, 51.4%, 89.5%, and 90.9%, respectively. Furthermore, hydrothermal treatment in dilute phosphoric acid achieved leaching rates of 87.9%, 85.8%, 98.4%, and 99.1% for Al, Ca, Cu, and Ni, respectively. The microstructure characterization revealed significant changes in phase and grain morphology during the leaching process in dilute phosphoric acid, which are likely associated with the liberation of impurity atoms from the lattice. These findings indicate that acid leaching is highly effective in removing impurities from the iron phosphate recycled from waste LIBs. [ABSTRACT FROM AUTHOR]

Heterostructure catalysts are highly anticipated in the field of photocatalytic water splitting. AlN/Sc2CF2 and GaN/Sc2CF2 heterostructures are proposed in this work, and the electronic structures were revealed with the first-principles method to explore their photocatalytic properties for water splitting. The results found that the thermodynamically stable AlN/Sc2CF2 and GaN/Sc2CF2 heterostructures are indirect semiconductors with reduced band gaps of 1.75 eV and 1.84 eV, respectively. These two heterostructures have been confirmed to have type-Ⅰ band alignments, with both VBM and CBM contributed to by the Sc2CF2 layer. AlN/Sc2CF2 and GaN/Sc2CF2 heterostructures exhibit the potential for photocatalytic water splitting as their VBM and CBM stride over the redox potential of water. Gibbs free energy changes in HER occurring on AlN/Sc2CF2 and GaN/Sc2CF2 heterostructures are as low as −0.31 eV and −0.59 eV, respectively. The Gibbs free energy change in HER on the AlN (GaN) layer is much lower than that on the Sc2CF2 surface, owing to the stronger adsorption of H on AlN (GaN). The AlN/Sc2CF2 and GaN/Sc2CF2 heterostructures possess significant improvements in absorption range and intensity compared to monolayered AlN, GaN, and Sc2CF2. In addition, the band gaps, edge positions, and absorption properties of AlN/Sc2CF2 and GaN/Sc2CF2 heterostructures can be effectively tuned with strains. All the results indicate that AlN/Sc2CF2 and GaN/Sc2CF2 heterostructures are suitable catalysts for photocatalytic water splitting. [ABSTRACT FROM AUTHOR]