Search

We report on the grain size dependent morphological, physical and chemical properties of thick microwaveplasma assisted chemical vapor deposited (MPCVD) diamond films that are used as target materials for high energy density physics experiments at the Lawrence Livermore National Laboratory. Control over the grain size, ranging from several µm to a few nm, was achieved by adjusting the CH(4) content of the CH(4)/H(2) feed gas. The effect of grain size on surface roughness, morphology, texture, density, hydrogen and graphitic carbon content was systematically studied by a variety of techniques. For depositions performed at 35 to 45mbar and 3000W microwave power (power density ~10 W cm(-3)), an abrupt transition from micro-crystalline diamond to nanocrystalline diamond was observed at 3% CH(4). This transition is accompanied by a dramatic decrease in surface roughness, a six percent drop in density and an increasing content in hydrogen and graphitic carbon impurities. Guided by these results, layered nano-microhybrid diamond samples were prepared by periodically changing the growth conditions from nano- to microcrystalline.

A novel nanoporous carbon/electrolyte hybrid material is reported for use in actuation. The nanoporous carbon matrix provides a 3D network that combines mechanical strength, light weight, and low cost with an extremely high surface area. In contrast to lower dimensional nanomaterials, the nanoporous carbon matrix can be prepared in the form of macroscopic monolithic samples that can be loaded in compression. The hybrid material is formed by infiltrating the free internal pore volume of the carbon with an electrolyte. Actuation is prompted by polarizing the internal interfaces via an applied electric bias. It is found that the strain amplitude is proportional to the Brunauer-Emmett-Teller (BET) mass specific surface area, with reversible volume strain amplitudes up to the exceptionally high value of 6.6%. The mass-specific strain energy density compares favorably to reported values for piezoceramics and for nanoporous metal actuators.

The investigation of orientation dependent crystal growth and etch processes can provide deep insights into the underlying mechanisms and thus helps to validate theoretical models. Here, we report on homoepitaxial diamond growth and oxygen etch experiments on polished, polycrystalline CVD diamond wafers by use of electron backscatter diffraction (EBSD) and white-light interferometry (WLI). Atomic force microscopy (AFM) was applied to provide additional atomic scale surface morphology information. The main advantage of using polycrystalline diamond substrates with almost random grain orientation is that it allows determining the orientation dependent growth (etch) rate for different orientations within one experiment. Specifically, we studied the effect of methane concentration on the diamond growth rate, using a microwave plasma CVD process. At 1% methane concentration a maximum of the growth rate near and a minimum near is detected. Increasing the methane concentration up to 5% shifts the maximum towards while the minimum stays at . Etch rate measurements in a microwave powered oxygen plasma reveal a pronounced maximum at . We also made a first attempt to interpret our experimental data in terms of local micro-faceting of high-indexed planes.

The National Ignition Facility (NIF) will allow scientists to prove the feasibility of inertial confinement fusion (ICF). The success of ICF experiments at NIF will critically depend on the availability of robust targets. Guided by computer simulations, we generated a new target design that takes advantage of the extreme atomic density of synthetic diamond, and developed a process that allows us to produce large quantities of these ultrahigh precision diamond targets via a low-cost batch process. Computer simulations were used to assess the performance and the robustness of these diamond targets. The results demonstrate that diamond has the potential to outperform other target materials in terms of energy efficiency and implosion stability, thus making successful ignition more likely.