Search

Introduction: Muscles play a critical role in supporting joints during activities of daily living, owing, in part, to the phenomenon of short-range stiffness. Briefly, when an active muscle is lengthened, bound cross-bridges are stretched, yielding forces greater than what is predicted from the force length relationship. For this reason, short-range stiffness has been proposed as an attractive mechanism for providing joint stability. However, there has yet to be a forward dynamic simulation employing a cross-bridge model, that demonstrates this stabilizing role. Therefore, the purpose of this investigation was to test whether Huxley-type muscle elements, which exhibit short-range stiffness, can stabilize a joint while at constant activation. Methods: We analyzed the stability of an inverted pendulum (moment of inertia: 2.7 kg m2) supported by Huxley-type muscle models that reproduce the short-range stiffness phenomenon. We calculated the muscle forces that would provide sufficient short-range stiffness to stabilize the system based in minimizing the potential energy. Simulations consisted of a 50 ms long, 5 Nm square-wave perturbation, with numerical simulations carried out in ArtiSynth. Results: Despite the initial analysis predicting shared activity of antagonist and agonist muscles to maintain stable equilibrium, the inverted pendulum model was not stable, and did not maintain an upright posture even with fully activated muscles. Discussion & conclusion: Our simulations suggested that short-range stiffness cannot be solely responsible for joint stability, even for modest perturbations. We argue that short-range stiffness cannot achieve stability because its dynamics do not behave like a typical spring. Instead, an alternative conceptual model for short-range stiffness is that of a Maxwell element (spring and damper in series), which can be obtained as a first-order approximation to the Huxley model. We postulate that the damping that results from short-range stiffness slows down the mechanical response and allows the central nervous system time to react and stabilize the joint. We speculate that other mechanisms, like reflexes or residual force enhancement/depression, may also play a role in joint stability. Joint stability is due to a combination of factors, and further research is needed to fully understand this complex system. [ABSTRACT FROM AUTHOR]

Augmented tactile and performance feedback has been used to (re)train a modified lifting technique to reduce lumbar spine flexion, which has been associated with low back disorder development during occupational repetitive lifting tasks. However, it remains unknown if the presence of trunk extensor neuromuscular fatigue influences learning of this modified lifting technique. Therefore, we compared the effectiveness of using augmented tactile and performance feedback to reduce lumbar spine flexion during a repetitive lifting task, in both unfatigued and fatigued states. Participants completed repetitive lifting tests immediately before and after training, and 1-week later, with half of the participants completing training after fatiguing their trunk extensor muscles. Both groups demonstrated learning of the modified lifting technique as demonstrated by increased thorax-pelvis coordination variability and reduced lumbar range of motion variability; however, experiencing trunk extensor neuromuscular fatigue during lift (re)training may have slight negative influences on learning the modified lifting technique. Practitioner summary: An augmented lift (re)training paradigm using tactile cueing and performance feedback regarding key movement features (i.e. lumbar spine flexion) can effectively (re)train a modified lifting technique to reduce lumbar flexion and redistribute motion to the hips and knees. However, performing (re)training while fatigued could slightly hinder learning this lifting technique. [ABSTRACT FROM AUTHOR]

Lifting with a flexed spine, especially near the end range of motion, has been identified as a potential risk factor for low back injury/pain. Therefore, individuals who develop discomfort from repetitive, prolonged and/or loaded flexed or slouched postures may benefit from a greater awareness of how to control and/or modify their spinal posture to avoid irritating their backs in these situations. This study was therefore designed to test the ability of spine-oriented verbal instructions to reduce intersegmental spine flexion during three lifting tasks. The lifts were first performed without any instructions on lifting technique. An audio recording was then played with instructions to limit bending in the lower back before repeating the lifts. Following the verbal instructions, maximum spine flexion angles significantly (p < 0.05) decreased at intersegmental levels in the lower thoracic and upper lumbar (T8/T9 to L2/L3) regions, but no significant changes were observed at the lower lumbar levels (L3/L4 to L5/S1). Thus, it is concluded that spine-oriented verbal instructions can decrease spine flexion during lifting; however, other cues/instructions may be required to target lower lumbar levels which have been identified as the most prone to injury/pain. [ABSTRACT FROM AUTHOR]

Background Few studies have quantified dynamic balance in fencers despite previous suggestions that balance training may be beneficial for these athletes. Generally, asymmetry in dynamic balance performance between the left and right legs can be an indicator of lower extremity injury risk and used to monitor rehabilitation progress. Fencing is recognized as an asymmetric sport, therefore, differences in dynamic balance may exist among uninjured athletes. Hypothesis/Purpose The primary objective of this investigation was to evaluate whether asymmetry of dynamic balance is present in uninjured national-level fencers. It was hypothesized that elite uninjured fencers would demonstrate superior dynamic balance on the lead-leg of their fencing stance. A secondary objective was to compare dynamic balance performance of elite fencers to previously published data from high-level athletes participating in other sports. Study Design Descriptive Laboratory Study Methods Fourteen uninjured elite competitive fencers were recruited. Subjects self-reported the lead leg of their fencing stance. Each participant performed the Y-Balance test (YBT), which represented a measurement of dynamic balance control, on both legs. Reach distances were recorded directly from a commercially available YBT apparatus. Four reach distances were recorded: anterior, posteromedial, posterolateral, and a composite measure was calculated. Distances were leg length-normalized and expressed as a percentage. Sample averages and standard deviations were derived for the four YBT measurements. Results There were no significant differences in reaching distance between the lead and trail legs in any of the four YBT measures (p ≥ 0.65). Fencers appeared to demonstrate larger normalized reach distances in the posterolateral and posteromedial directions than other athletes. Conclusions The results of this study indicate that dynamic balance is not significantly different between the lead and trail legs in elite fencers, despite the asymmetrical nature of their sport. The apparent symmetry of dynamic balance control in uninjured fencers means that the YBT could be used in this population for monitoring progress during training and rehabilitation. Level of Evidence 2b [ABSTRACT FROM AUTHOR]

Inter-segmental coordination patterns and mechanical energy transfer were compared between vertical jumping tasks which possess different countermovement characteristics. Thirteen participants completed squat (SJ), countermovement (CMJ) and drop (DVJ) vertical jumps. Inter-segmental coordination patterns became more out-of-phase with increases in countermovement velocity (DVJ > CMJ > SJ), at the ankle, hip and lumbar spine (all p < 0.05), but not at the knee. With countermovements, more inter-segmental energy transfer occurred at all joints (p < 0.05), but increasing the countermovement velocity (DVJ compared to CMJ) did not always increase energy transfer (p < 0.001 for the hip and knee, p > 0.05 for the ankle and lumbar spine). The relationship between mechanical energy transfer and inter-segmental coordination patterns during vertical jumping is not straightforward since the responses to these varying countermovement demands were not consistent across all joints. [ABSTRACT FROM AUTHOR]

Evidence has shown that upper limb muscles peripheral to the cervical spine, such as the biceps brachii, can demonstrate functional deficits in the presence of chronic neck pain. However, few studies have examined how neck pain can affect the fatigability of upper limb muscles; therefore we were motivated to investigate the effects of acutely induced neuropathic neck pain on the fatigability of the biceps brachii muscle during isometric contraction to exhaustion. Topical capsaicin was used to induce neck pain in 11 healthy male participants. Surface EMG signals were recorded from the biceps brachii during an isometric elbow flexion fatigue task in which participants held a weight equivalent to 30% of their M VC until exhaustion. Two experimental sessions, one placebo and one capsaicin, were conducted separated by two days. EMG mean power frequency and average normalized activation values were calculated over the course of the fatigue task. In the presence of pain, there was no statistically significant effect on EMG parameters during fatigue of the biceps brachii. These results demonstrate that acutely induced neuropathic neck pain does not affect the fatigability, under the tested conditions, of the biceps brachii. [ABSTRACT FROM AUTHOR]

The ProFitter 3-D Cross Trainer is a labile surface device used in the clinic and claimed to train spine stability. The purpose of this study was to quantify the spine mechanics (compression and shear forces and stability), together with muscle activation mechanics (surface electromyography) of the torso and hip, during three ProFitter exercises. Trunk muscle activity was relatively low while exercising on the device (<25%MVC). Gluteus medius activity was phasic with the horizontal sliding position, especially for an experienced participant. Sufficient spinal stability was achieved in all three exercise conditions. Peak spinal compression values were below 3400 N (maximum 3188 N) and peak shear values were correspondingly low (under 500 N). The exercises challenge whole-body dynamic balance while producing very conservative spine loads. The motion simultaneously integrates hip and torso muscles in a way that appears to ensure stabilizing motor patterns in the spine. This information will assist with clinical decision making about the utility of the device and exercise technique in rehabilitation and training programs. [ABSTRACT FROM AUTHOR]