Search

Morphology transformation and crystal growth strategies of metal oxide semiconductors are still extensively studied in material science recently, because the morphology and crystallinity significantly affect the physicochemical characteristics of metal oxide nanomaterials. However, understanding the morphology changes of α-MoO3 induced by annealing is still a challenge. Herein, the nanostructure transition of α-MoO3 induced by the annealing temperature is carefully investigated via the XRD and SEM methods. It can be found that crystallization is highly dependent on the annealing temperature. Interestingly, the MoO3 nanoflowers can change into nanosheets at 500 °C. Afterward, the nanosheets turned into microrods with the increase in annealing temperature due to the continuous growth of MoO3 crystal. On the other hand, the sensing performances of various MoO3 nanostructures are studied toward ethanol gas. Compared to the MoO3 nanoflowers and microrods, the MoO3 nanosheets-based sensor exhibits superior sensing performance to ethanol, and the maximum response value is 8.06. [ABSTRACT FROM AUTHOR]

Using vanadium oxide (VOx) thin film as active layer, microbolometer with gold black absorber was fabricated due to the high mid-infrared (8-14μm) absorption property of gold black. This paper describes the design and fabrication of microbolometer with micromachining surface technology. The characteristics of the device are investigated. The detector performance exhibits maximum detectivity of 1.96 × 108cmHz1/2/W at 17 Hz with 8.8μA. [ABSTRACT FROM AUTHOR]

Metal oxide semiconductor sensors based on nanocrystalline In2O3 and its composites are found to be very sensitive in detecting low-concentration (~ 5 ppm) gases such as ozone, nitrogen dioxide, formaldehyde and butane. Here, we successfully obtained fiber-shaped In2O3 crystalline nanofibers via electrospun and calcination routes. The gas sensing properties of the In2O3 nanofibers were studied by exposing them to the acetic acid vapor with different concentrations from 500 ppb to 2000 ppm at the optimum operating temperature (250 °C). The device possesses ultra-high response of 66.7 toward 2000 ppm acetic acid vapor, low response and recovery times of 25 s and 37 s (100 ppm), respectively, and significant selectivity to acetic acid at 100 ppm. In particular, the sensor based on In2O3 nanofibers has very low detection limit and can reach 500 ppb. Therefore, the presented In2O3 nanofiber sensor can be used in practice in acetic acid detection area in the future. [ABSTRACT FROM AUTHOR]