Search

We report a systematic study on the structural and electronic properties of Bi2Te3-xSex topological insulator alloy grown by molecular beam epitaxy(MBE). A mixing ratio of Bi2Se3 to Bi2Te3 was controlled by varying the Bi:Te:Se flux ratio. X-ray diffraction and Raman spectroscopy measurements indicate the high crystalline quality for the as-grown Bi2Te3-xSex films. Substitution of Te by Se is also revealed from both analyses. The surfaces of the films exhibit terrace-like quintuple layers and their size of the characteristic triangular terraces decreases monotonically with increasing Se content. However, the triangular terrace structure gradually recovers as the Se content further increases. Most importantly, the angle-resolved photoemission spectroscopy results provide evidence of single-Dirac-cone like surface states in which Bi2Te3-xSex with Se/Te-substitution leads to tunable surface states. Our results demonstrate that by fine-tuned MBEgrowth conditions, Bi2Te3-xSex thin film alloys with tunable topological surface states can be obtained, providing an excellent platform for exploring the novel device applications based on this compound. [ABSTRACT FROM AUTHOR]

The interdigital transducer (IDT)/AlN/conducting layer/diamond structures are investigated in this study to design surface acoustic wave (SAW) devices in the super high frequency band. Simulation results using the finite element method show that a thin conducting layer can effectively increase the coupling coefficient and, thus, broaden the bandwidth of SAW devices. For the Sezawa mode, it is illustrated that using a Ti layer with a layer thickness-to-wavelength ratio of 0.02 the maximum coupling coefficient is 2.546% and the associated SAW phase velocity is 10657 m/s at the AlN films’ thickness-to-wavelength ratio of 0.14. This coupling coefficient is 105% higher than that in the IDT/AlN/diamond structure. The research results can be applied to design SAW devices using diamond based structures in the super high frequency band. [ABSTRACT FROM AUTHOR]

The field bioefficacy of a wettable granule (WG) formulation of Bacillus thuringiensis israelensis (Bti), VectoBac WG (Bti strain AM65-52) against dengue vectors, Aedes aegypti and Ae albopictus; was evaluated in a suburban residential area (TST) and in a temporary settlement site (KB) in the state of Selangor, Malaysia. Pre-control ovitrap surveillance of the trial sites indicated a high population of both types of Aedes mosquitoes. The populations were monitored continuously by weekly ovitrapping. Bti was sprayed biweekly at a dosage of 500 g/ha by using a mist-blower. The spray application was targeted into outdoor larval habitats. If required, Bti formulation was also applied directly into indoor water-holding containers at 8 g/1,000 l. Based on ovitrap surveillance, a significant reduction in Aedes populations was evident 4 weeks after initiating the first Bti treatment. The ovitrap index (OI) and the larvae density decreased drastically in both trial sites. In TST, the indoor OI was significantly reduced from 57.50 +/- 7.50% to 19.13 +/- 5.49% (p<0.05), while the outdoor OI decreased from 38.89 +/- 11.11% to 15.36 +/- 5.93%. In KB, similarly, the OI was significantly reduced by more than half, from 66.66 +/- 6.67% to 30.26 +/- 2.99% (p< 0.05). In all cases, the reduction in OI was paralleled by reduction in larval density.

The inhibitory activity of diflubenzuron, a chitin synthesis inhibitor, on the ecdysis of Aedes sp. larvae was evaluated in earthen jars and automobile tires. Two formulations of diflubenzuron were used in this study: Dimilin(R) WP (wettable powder), 25% and Dimilin GR (granular), 2%. The equivalent rate of 25 g/ha, 50 g/ha and 100 g/ha active ingredients for both WP and GR formulations were used in this study. Generally, at the higher dosage of 100 g/ha, both formulations were more effective against Aedes mosquitoes. On the whole, the WP formulation appeared to perform better than the GR formulation in terms of residual activity.

Ovitrap surveillance was conducted in four dengue endemic areas in Kuala Lumpur and Selangor, Malaysia to determine the distribution and percentage of mixed breeding of both Aedes aegypti and Aedes albopictus. The percentage of mixed breeding in all study sites both indoors and outdoors accounted for 10 to 32 % from the total ovitraps collected. Ae. aegypti was found at a higher frequency than Ae. albopictus in these ovitraps. This study again indicates that ovitrap is a sensitive tool to attract gravid females of more than one mosquito species to oviposit in the container.

The compatibility of the commercial aqueous Bacillus thuringiensis serovar israelensis (B.t.i.) formulation, Vectobac 12AS, with the chemical insecticides Actellic 50EC, Aqua Resigen, Resigen, and Fendona SC, for the simultaneous control of Aedes larvae and adults was studied by dispersing nine different formulations using a portable mist blower, in single story half-brick houses. The effectiveness of the treatment was evaluated by measuring the larval mortality, adult mortality, and droplet analysis at varying distances from the sprayer. Persistence of the larvicidal activity of the chemical insecticides and B.t.i was also determined by measuring the larval mortality in the test samples 7 days posttreatment. The sprayed particles in all the trials were 50-60 microns in size, indicating that the particles were those of mist spray. Test samples placed within 3 m from the sprayer gave the maximum larval and adult mortality. Chemical insecticides exhibited maximum larval mortality in the 1 h posttreatment test samples and it was comparable to the larvicidal activity of B.t.i. The larvicidal toxins of B.t.i were more stable and were able to affect sufficient larval mortality for 7 days posttreatment. The larvicidal activity of the mixtures, i.e., chemical insecticides with B.t.i, in the 1 h posttreatment test samples was not significantly different from the larvicidal activity of the chemical insecticides and it was comparable to the larvicidal activity of B.t.i alone. However, the larvicidal activity of the mixtures was significantly more than the chemical insecticides alone in the 7 days posttreatment test samples except for the Actellic 50EC and Vectobac 12AS mixture. In all the trials, with or without B.t.i, there was no significant difference in adult mortality, indicating that this B.t.i formulation, Vectobac 12AS, was not antagonistic to the adulticidal activity of the chemical insecticides. From this study, it can be concluded that chemical insecticides can be used effectively for both adult and larval control, but the chemical insecticides do not exhibit residual larvicidal activity. Hence, for an effective control of both Aedes larvae and adults, it is advisable to add B.t.i. to the chemical insecticides, as B.t.i is specifically larvicidal and is also able to effect extended residual larvicidal activity.

The combined adulticidal, larvicidal, and wall residual activity of ULV-applied bifenthrin, a synthetic pyrethroid, was evaluated in houses in Kuala Lumpur, Malaysia, against larvae and adults of lab-bred Aedes aegypti and Culex quinquefasciatus. A portable ULV sprayer was used to disperse a ULV formulation of bifenthrin at a discharge rate of 45 ml/min. The results indicated that bifenthrin sprayed at this rate exhibited all the three activities against the test mosquitoes. Complete adult mortalities were achieved, while very high larvicidal activity was also effected, which persisted for seven days. Wall bioassay with adults of Ae aegypti also resulted in very high mortality, which also persisted for one week. The combined mosquitocidal activities of bifenthrin is considered more effective especially in the control of dengue vectors.