Search

Ticks can be a major concern for humans and animals alike through the transmission of various viral and bacterial diseases. Ticks have also developed tolerance to several active compounds due to intensive insecticide treatments. The excess use of insecticides against ticks worldwide is mostly environmental contamination rather than effective control. Thus, information about the useful chemicals is essential. Dermacentor marginatus and Dermacentor reticulatus individuals were tested, being collected in Transylvania, near the city of Târgu-Mureş, Romania. The experiment was performed under laboratory conditions in two replicates, using a total of 420 ticks and 19 insecticides. The best results were achieved with alpha-cypermethrin and pyrethrin.

Abstract Ocular surface inflammation due to allergy and blepharitis can lead to corneal complications and visual impairment. The aim of this study is to evaluate the efficacy of a cyclosporin 0.1% topical treatment achieving steroid-sparing. Eighty pediatric patients with moderate and severe vernal and blepharitis-related keratoconjunctivitis were included. Symptoms (photosensitivity, itching, discharge, tearing), signs (corneal fluorescein staining, papillary hypertrophy) and patients’ subjective assessment were evaluated during a 6-month follow-up. At the follow-up, all patients treated with topical cyclosporin showed a significant improvement in all subjective symptoms and objective signs (p

Abstract In taxonomic works, the weight to be given to morphological, mitochondrial, or nuclear signals, and the assessment of differences as species or subspecies distinctions has also varied considerably over the past decades and is largely a subjective research decision. This apparent example of the “grey zone of taxonomy” underpins the need of critical studies of as many specimens as possible and of using both mitochondrial and nuclear genes in taxonomic-systematic studies, as phylogeny based on uniparentally inherited genes alone may not represent true evolutionary scenarios. Myotis sicarius, a species occurring thorough the Himalayan foothills was found for the first time out of South Asia, in North Vietnam. Analysis of topotypical and Vietnamese specimens revealed high mitochondrial heterogeneity – at the upper limit of the usual threshold of intraspecific difference – but only minute nuclear sequence and negligible morphological differences. Albeit the large geographic distance between the two records might suggest the existence of two putative reproductively isolated taxonomic units, based on the incongruent results we concluded that the split of geographic populations of M. sicarius into different taxa is unsupported. As a morphologically closely resembling species, we also reviewed the taxonomic status of the two morphological forms of M. annectans and synonymizing M. primula with M. annectans was also corroborated by our phylogenetic analyses.

Despite the rarity of abdominal or chest wall metastases in ovarian cancer patients, reports have described instances of isolated late recurrence at surgical incision sites. We report the case of an 85-year-old woman who present with a massive metastatic tumor on the right anterior abdominal wall 42 years after undergoing a total abdominal hysterectomy and bilateral salpingo-oophorectomy for primary ovarian cancer. The abdominal wall tumor was resected en bloc, and abdominal wall reconstruction was performed using a mesh. Histology revealed a low-grade serous carcinoma.This report highlights the possibility of abdominal wall metastases after prolonged survival following the treatment of ovarian cancer. Surgical excision combined with mesh reconstruction represents an adequate treatment approach for such cases. Caution should be exercised during laparotomy to ensure complete removal of malignant tissue and to prevent parietal dissemination. Long-term follow-up is crucial for ovarian cancer patients, as late recurrences, although rare, can occur even decades after initial treatment.

Lutein and zeaxanthin, prominent carotenoids with antioxidant properties, contribute notably to maintaining of ocular health. These substances reduce the harmful effect of oxidative stress and blue light and ensure the vision quality. Carotenoids-rich dietary could have ophthalmic benefits, such as enhanced contrast perception and reduced eye fatigue, while also show potential in mitigating the risk of age-related macular degeneration (AMD). Nonetheless, ocular administration of carotenoids could enhance the local ophthalmic bioavailability of these compounds. The aim of this study was to investigate ophthalmic applicability of lutein (LutD) and zeaxanthin disuccinates (ZeaD) in aqueous solutions applying cyclodextrins to improve their solubility and permeability. Among the tested cyclodextrins, randomly methylated beta-cyclodextrin (RAMEB) was identified as the most effective solubilizing agent, achieving solubility values of 572±55 μM and 1470±103 μM for LutD and ZeaD, respectively. In vitro corneal-PAMPA and ex vivo porcine eye models demonstrated that RAMEB-based formulations significantly improved the permeability of both carotenoid derivatives by increasing their solubility (corneal concentration at 15 mins), markedly surpassing those of the reference suspensions. The findings suggest that RAMEB may be essential for developing carotenoid-based aqueous eye drops, leveraging its antioxidant properties to improve ocular health and ameliorate various degenerative eye conditions.

Abstract The aluminum content of concentrated (27 wt%) sodium chloride solutions could be crucial for large‐scale chlor‐alkali‐based industries applying membrane cell electrolysis. Thus, a facile method which enables a fast and reliable protocol to determine the Al content of these solutions on ppb scale in industrial environments is fundamentally important. It was demonstrated that the increased sensitivity of colorful Al‐ECR (eriochrome cyanine R) complex by the use of a cationic surfactant and specific biological buffers could effectively indicate the Al content in an extended pH interval of a concentrated saline medium under industrial conditions. The dependence of the analytical protocol on pH, temperature, time, wavelength, and the salinity of the medium was investigated. It was shown that the absorbance‐based measurements of the solution should be performed at least 2–4 h after its preparation. By applying the selected two Good's buffers (HEPES: 4‐(2‐hydroxyethyl)‐1‐piperazineethanesulfonic acid, MOPS: 3‐(N‐morpholino)‐propanesulfonic acid) and Tris (tris(hydroxymethyl)aminomethane), 32.8–38.1 % increase in the sensitivity was achieved for saturated NaCl solutions. Moreover, the limits of detection and quantification (LOD, LOQ) were also lowered by 19.0–29.8 %, and the salinity dependence of the calibration was also reduced.

In this study, the effects of cutting speed and feed rate on the roughness parameters Ra, Rz, Rsk, Rku, Rpk, Rvk, and A2 were examined during machining with coated carbide tools in a dry environment. The authors introduced the Rvk/Rpk ratio, a coefficient that facilitates a simpler evaluation of surface wear resistance. Specifically, if this ratio is greater than 1, the surface is more wear-resistant, while values less than 1 indicate a higher tendency for surface wear. The Taguchi OA method was used to analyze and identify the significance of technological parameters on output characteristics. Based on the results, it was established that feed rate has the greatest impact on all output characteristics. The highest cutting force was measured at a cutting speed of 60 m/min and a feed rate of 0.15 mm/rev, attributed to the fact that at lower cutting speeds, the base material does not soften while the cross-sectional area of the chip increases. To achieve the lowest Ra and Rz surface roughness, a cutting speed of 100 m/min and a feed rate of 0.05 mm/rev are recommended. If the goal is to enhance surface wear resistance and improve oil retention capability, machining with a cutting speed of 80–100 m/min and a feed rate of 0.15 mm/rev is advisable, as the coarser machining increases both the Rvk/Rpk ratio and the oil-retaining pocket size, which together improve the wear resistance of the machined surface.

Attila Kerényi, Professor of Geography, was born in 1943 in Sátoraljaújhely. He earned a degree as a teacher of Geography and Biology in 1967. During the 1980s, he gained national and international scientific recognition for his research on soil erosion processes, and completed his candidate dissertation in 1984. In the 1990s, he became nationally acknowledged for his publications, textbooks and scientific books on landscape and environmental protection, and earned an academic doctorate title in the topic. His scientific work was recognized with numerous awards. In 2020, he was awarded the Officer’s Cross of the Hungarian Order of Merit in recognition of his several decades of research and teaching activities which have greatly contributed to the renewal of geography education at the University of Debrecen. On the occasion of his 80th birthday, his colleagues interviewed Professor Kerényi about his family, profession, achievements and the state of global environmental systems.

Routine soil chemical and physical laboratory analysis provides a better understanding of the soil by evaluating its quality and functions. Demands for the development of national Mid-infrared (MIR) spectral libraries for predicting soil attributes with high accuracy have risen substantially in the recent past. Such MIR spectral library is usually regarded as a fast, cheap and non-destructive technique for estimating soil properties compared to laboratory soil analysis. The main objective of this research was to assess the performance of the Hungarian MIR spectral library in estimating four soil properties namely: Cation Exchange Capacity (CEC), Exchangeable Mg and Ca and pH water at different scenarios. Archived soil samples were scanned and spectra data were saved in the Fourier transform infrared spectrometer OPUS software. Preprocessed filtering, outlier detection and calibration sample selection methods were applied to the spectral library. MIR calibration models were built for soil attributes using partial least square regression method and the models were validated with sample predictions. R2, RMSE and RPD were used to assess the goodness of calibration and validation models. MIR spectral library had the ability to estimate soil properties such as CEC and exchangeable Ca and Mg through various scale models (national, county and soil type). The findings showed that the Hungarian MIR spectral library for estimation of soil properties has the ability to provide good information on national, county and soil type scales at different levels of accuracy.

Updating soil information systems (SIS) requires advanced technologies to support the time and cost-effective and environment-friendly soil data. The use of mid- infrared (MIR) Spectroscopy as alternative to wet chemistry has been tested. The MIR spectral library is a useful technique for predicting soil attributes with high accuracy, efficiency, and low cost. The Hungarian MIR spectral library contained data on 2200 soil samples from 10 counties representing the first Soil Information and Mentoring System (SIMS) survey. Archived soil samples were prepared and scanned based on Diffuse Reflectance Infrared spectroscopy (DRIFT) technique and spectra data were saved in the fourier transform infrared (FTIR) spectrometer OPUS software. Preprocessed filtering methods, outlier detection methods and calibration sample selection methods were applied for spectral library. MIR calibration models were built for soil attributes using Partial Least Square Regression (PLSR) method. Coefficient determination (R2), The Root Mean Squared Error (RMSE) and Ratio of Performance to Deviation (RPD) were used to assess the goodness of calibration and validation models. MIR spectral library had the ability to significantly estimate soil properties such as SOC, CaCO3, sand, clay and silt through various scale models (national, county and soil type). The findings showed that our spectral library soil estimations are precise enough to provide information on national, county and soil type levels enabling a wide range of soil applications that demand huge amounts of data such as soil survey, precision agriculture and digital soil mapping.

Abstract Arabidopsis NODULIN HOMEOBOX (NDX) is a plant-specific transcriptional regulator whose role in small RNA biogenesis and heterochromatin homeostasis has recently been described. Here we extend our previous transcriptomic analysis to the flowering stage of development. We performed mRNA-seq and small RNA-seq measurements on inflorescence samples of wild-type and ndx1-4 mutant (WiscDsLox344A04) Arabidopsis plants. We identified specific groups of differentially expressed genes and noncoding heterochromatic siRNA (hetsiRNA) loci/regions whose transcriptional activity was significantly changed in the absence of NDX. In addition, data obtained from inflorescence were compared with seedling transcriptomics data, which revealed development-specific changes in gene expression profiles. Overall, we provide a comprehensive data source on the coding and noncoding transcriptomes of NDX-deficient Arabidopsis flowers to serve as a basis for further research on NDX function.