Search

The demand for high-performance grinding wheels is gradually increasing due to rapid industrial development. Vitrified bond diamond composite is a versatile material for grinding wheels used in the backside grinding step of Si wafer production. However, the properties of the vitrified bond diamond composite are controlled by the characteristics of the diamond particles, the vitrified bond, and pores and are very complicated. The main objective of this study was to investigate the effects of SiO2–Na2O–B2O3–Al2O3–Li2O–K2O–CaO–MgO–ZrO2–TiO2–Bi2O3 glass powder on the sintering, microstructure, and mechanical properties of the vitrified bond diamond composite. The elemental distributions of the composite were analyzed using electron probe micro-analysis (EPMA) to clarify the diffusion behaviors of various elements during sintering. The results showed that the relative density and transverse rupture strength of the composite sintered at 620 °C were 91.7% and 126 MPa, respectively. After sintering at 680 °C, the glass powder used in this study exhibited a superior forming ability without an additional pore foaming agent. The relative density and transverse rupture strength of the composite decreased to 48.2% and 49 MPa, respectively. Moreover, the low sintering temperature of this glass powder protected the diamond particles from graphitization during sintering, as determined by X-ray diffraction and Raman spectrum. Furthermore, the EPMA results indicate that Na diffused and segregated at the interface between the diamond particles and vitrified bond, contributing to the improved bonding. The diamond particles can remain effectively bonded by the vitrified bond even after fracture.

Powder metallurgy (PM) is a versatile process to manufacture nearly net-shaped metallic materials in industry. In this study, the PM process was used to fabricate two Fe-based laminated metal composites (LMCs), Fe-4Ni-3Cr-0.5Mo-0.5C/Fe and 410/304L. The results showed that after sintering, the LMCs were free of interfacial cracks and distortion, indicating that the PM process is a feasible means for producing these LMCs. In the Fe-4Ni-3Cr-0.5Mo-0.5C/Fe LMC, the diffusion of C resulted in the generation of a continuous pearlite layer between the Fe-4Ni-3Cr-0.5Mo-0.5C and Fe layers and a ferrite/pearlite mixture in the Fe layer. In the 410/304L LMC, the difference in the chemical potentials of C between the 304L and 410 layers led to the uphill diffusion of C from the 410 layer to the 304L layer. A continuous ferrite layer was thus formed near the interface of the 410 layer. Furthermore, a martensite layer of about 50 μm thickness was generated at the interface due to the high Cr and Ni content.