Search

Additive manufacturing of metal parts in the motorsport industry is becoming a decisive technology for producing lightweight and rigid parts, with increasing applications as the costs decrease. Among the available metal alloys, AlSi10Mg is one of the most widely used. In this paper, the corrosion resistance of additively manufactured AlSi10Mg is compared with that of other traditionally manufactured aluminium alloys widespread in the automotive industry. Several potentially corrosive agents, typical of vehicle applications, were used: salty water, motor oil, suspension oil, cooling fluid and gasoline. Corrosion tests were conducted at both room temperature and 90 °C. The effects of heat and surface treatments were evaluated separately. The samples were visually inspected and weighed to evaluate the corrosion rate with the aid of SEM and EDS analysis. Additively manufactured AlSi10Mg generally showed better corrosion resistance in the stress-relieved condition as compared to the T6-treated state, with slightly better results for the polished samples. Motor oil, suspension oil, cooling fluid and gasoline did not significantly corrode the specimens, except for the T6-treated AlSi10Mg samples at 90 °C. However, the corrosion rate was always higher than traditionally manufactured aluminium alloys tested for comparison. [ABSTRACT FROM AUTHOR]

The capability to design and manufacture metal lattice structures is today one of the most promising targets of powder bed fusion technologies. Not only additively manufactured lattices offer great lightweighting possibilities but they also open the way to tailored and graded mechanical response. To best capitalize on this opportunity, research effort is first needed to assess the feasibility of reticular structures and to quantify the expected deviations from the nominal geometry, as a function of the cell topology and dimensions. Notwithstanding the inherent suitability of additive processes to complex shapes, this paper proposes a more exact definition of the technological boundaries for body‐centered cubic lattices, showing to what extent specific dimensional ratios, as well as a self‐supporting cell structure, can be favorable to minimize the deviation from the nominal reticulum in terms of dimensions, density, and presence of defects. [ABSTRACT FROM AUTHOR]