Search

A simple and rapid capillary electrophoresis method was developed for the separation and determination of ephedrine (E) and pseudoephedrine (PE) in a buffer solution containing 80 mM of NaH2PO4 (pH 3.0), 15 mM of β-cyclodextrin and 0.3% of hydroxypropyl methylcellulose. The field-amplified sample injection (FASI) technique was applied to the online concentration of the alkaloids. With FASI in the presence of a low conductivity solvent plug (water), an approximately 1,000-fold improvement in sensitivity was achieved without any loss of separation efficiency when compared to conventional sample injection. Under these optimized conditions, a baseline separation of the two analytes was achieved within 16 min and the detection limits for E and PE were 0.7 and 0.6 µg/L, respectively. Without expensive instruments or labeling of the compounds, the limits of detection for E and PE obtained by the proposed method are comparable with (or even lower than) those obtained by capillary electrophoresis laser-induced fluorescence, liquid chromatography–tandem mass spectrometry and gas chromatography–mass spectrometry. The method was validated in terms of precision, linearity and accuracy, and successfully applied for the determination of the two alkaloids in Ephedra herbs. [ABSTRACT FROM AUTHOR]

Sodium fluoride and sodium monofluorophosphate are often used as fluoridizers in oral care products to prevent dental caries. By quantitative 19F-NMR, their contents in toothpaste were simultaneously determined. This is a simple, fast, interference-free, and green analytical method for the determination of sodium fluoride and sodium monofluorophosphate in toothpaste. [ABSTRACT FROM AUTHOR]

To realize efficient electrocatalytic degradation of organic compounds in alkaline wastewater, an Sb-doped SnO 2 /Ti electrode was fabricated and employed for the removal of Rhodamine B (RhB), and the electrocatalytic oxidation performance of this electrode was assessed in an alkaline medium. In an alkaline solution (pH 11), the complete fading of 50 mg·L -1 RhB could be achieved after 150 min of degradation, the removal efficiency of the chemical oxygen demand reached 56.1% at 300 min, and the degradation process of RhB followed the pseudo-first-order kinetic model very well. Under the attack of hydroxyl radicals, partial RhB was degraded to low-molecular-weight organic acids through N-demethylation and the destruction of the conjugated chromophore. Various techniques including scanning electron microscopy, X-ray diffraction, X-ray photoelectron spectroscopy, and cycle voltammetry were used to examine the changes in the morphology and structure, as well as the activity of the Sb-doped SnO 2 /Ti electrode before and after use. The Sb-doped SnO 2 /Ti electrode could be reproduced in batches, and each electrode was reused up to eight times without a significant decrease in degradation ability; the leaching amount of antimony was significantly lower than the national emission standard. The electrocatalytic oxidation of the dye wastewater sample was also performed with the desired results, indicating that electrochemical oxidation is a very promising technology for the treatment of alkaline dye wastewater using a Sb-doped SnO 2 /Ti electrode., Competing Interests: The authors declare no competing financial interest., (© 2023 The Authors. Published by American Chemical Society.)

A Ce-doped Ti/PbO 2 electrode was prepared in a deposition solution containing Ce 3+ and Pb 2+ ions by electrodeposition, and the surface morphology, crystal structure and elemental states were characterized by SEM, XRD and XPS. The electrode was used to investigate the simultaneous degradation of three phthalate esters (PAEs), i.e., dimethyl phthalate (DMP), diethyl phthalate (DEP) and dibutyl phthalate (DBP) in synthetic wastewaters. The results showed that the electrode exhibited excellent electrocatalytic activity and good reusability and stability, and the removal efficiencies of 5 mg L -1 DBP, DMP and DEP in 0.05 M Na 2 SO 4 (pH 7) reached 98.2%, 95.8% and 81.1% at current density of 25 mA cm -2 after 10 h degradation, respectively. The degradation processes followed pseudo first-order kinetic model very well, and the observed rate constants of DBP, DEP and DMP were 0.42, 0.40 and 0.29 h -1 , respectively. The energy consumption in three PAEs degradation was also assessed. The main degradation products of the three PAEs were identified by using liquid chromatography-tandem mass spectrometry, and the possible degradation pathways mainly included dealkylation, hydroxyl addition, decarboxylation and benzene ring cleavage. This work is a promising candidate for efficient treatment of multiple PAEs in wastewater and protection of the aquatic ecological environment., Competing Interests: Declaration of competing interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper., (Copyright © 2020 Elsevier Ltd. All rights reserved.)