Search

This study explored the typical features of flame from syngas/air premixed flame in a narrow gap disk burner based on diluted N2 and CO2. Four concentrations (i.e. 10%, 20%, 30%, and 40%) of CO2 and five concentrations (i.e. 10%, 20%, 30%, 40%, and 50%) of N2 were adopted in this study. The experiment was conducted in a narrow gap disk burner with a clearance of 2 mm. The results showed that the addition of N2 and CO2 significantly reduced the brightness of flame, the flame propagation velocity, and the pressure resulting from the explosion. When the CO2 concentration reached 40%, the maximum pressure was reduced to 60.78 kPa, which was 41.5% lower than that without diluent. When the N2 concentration was increased to 50%, the maximum pressure was reduced to 67.01 kPa, but at this point, the inhibition effect on the maximum pressure was not as good as 40% of CO2. Additionally, the dilution effect of CO2 was more obvious than of N2. An analysis on the dilution mechanism found that reduced moles of critical radicals H, O, and OH were an important reason for the inhibition effect. However, with the increase of N2 and CO2 concentrations, the unstable flame propagation behavior in a later stage was not inhibited, but enhanced. The unstable propagation behavior was related to the flow field disturbance caused by heat loss. [ABSTRACT FROM AUTHOR]

The propagation instability of a premixed H2/CO/air mixture flame in an open-ended vertical narrow channel was investigated in this paper. The mixture was ignited at five different ignition positions: IP-50, IP-250, IP-500, IP-750, and IP-950. This paper presents a new method for flame image processing. The flame front curve is generally an exponential outflow from the ignition to the top opening at any ignition. The oscillation frequency increases with the increase of flame front curvature. The flame front curvature fluctuates with time when the oscillation propagation occurs, and the flame decelerates and inverts when the curvature is larger. The dominant frequencies are different depending on ignition position, which has a certain effect on frequency. Five different ignition positions of dominant frequency are 78.00 Hz, 125.07 Hz, 170.5 Hz, 125.1 Hz, 170.7 Hz, respectively. Interestingly, IP-500, IP-750 and IP-950 have secondary frequency values of 356.9 Hz, 357.1 Hz and 331.8 Hz, respectively. The secondary frequency is about twice the dominant frequency, and it is caused by parametric instability. Flame oscillation propagation is affected by dimensionless temperature and Lewis value. The interaction between flame and overpressure wave promotes the deformation and oscillation of the flame front. The overpressure, flame front position, flame front curvature, and flame speed coupled oscillation. [ABSTRACT FROM AUTHOR]