Search

Worldwide studies have been published on the mortality of workers employed in asbestos-based materials for the production of clutches and brakes. However no one of these studies is related to Italian cases. Furthermore, not even surveys have been conducted in Italy to characterize the correlation between asbestos exposures and the possible occurring of asbestos-related disease. Our objectives are the following: i) to assess and quantify the asbestos exposure cases, ii) to describe the nature and the frequency of asbestos-related diseases among blue collar employees of an important factory producing brakes and clutches with chrysotile asbestos content from 1971 to 1993 and iii) to provide preliminary data on cumulative asbestos exposure estimated using lung fibre burden analysis. Critical appraisal of airborne asbestos fibre measurements and identification of cases of asbestos-related diseases between the blue collar employees, either notified to the local health authority or recovered from the Italian national Mesothelioma registry was investigated. Lung fibre burden analysis using the lung tissue samples from two deceased blue collar employees was also performed. Airborne asbestos fibre measurements (carried out in 1982) suggested asbestos fibres average concentrations of about 0.3 f/ml, while all 1992 measurements showed results below 0.1 f/ml. Furthermore, since 1988, we identified four cases of pleural plaques, three cases of asbestosis and seven cases of lung cancer. No case of malignant mesothelioma was found. In both lung cancer cases, analysed to measure the lung fibre burden, commercial amphiboles were absent or in limited concentration but chrysotile and, especially, tremolite asbestos were present in noticeable amount. In conclusion, since 1971 and up to early 1980s, exposure to chrysotile asbestos and talc, likely contaminated by tremolite, had been significant and comparable to levels causing asbestosis long-term risk. No case of malignant mesothelioma was found, that is consistent with the absence of amphiboles and with the lower risk of mesothelioma associated with the chrysotile asbestos. However a subset of the blue collar employees, the ones employed later on, could still have not reached the full risk condition, and so being still at risk of developing malignant mesothelioma. In the two lung cancer cases studied, the lung fibre burden was essentially made of chrysotile and tremolite. Lastly, lung cancer occurrence in the population of blue collar employees has been likely underestimated and the correct determination of lung cancer risk should be done through the mortality analysis of this population.Nella letteratura scientifica sono presenti studi epidemiologici di mortalità su coorti di lavoratori addetti alla produzione di materiali di attrito in amianto ma non in Italia, dove neppure sono disponibili indagini conoscitive per caratterizzare l’esposizione ad amianto e la possibile presenza di patologie asbesto-correlate. Per questa ragione si è ricostruita la natura e l’entità dell’esposizione ad amianto, la frequenza e la tipologia delle patologie asbesto-correlate in lavoratori di una importante industria di materiali di attrito in asbesto crisotilo utilizzato dal 1971 al 1993; si sono inoltre forniti iniziali elementi per una stima dell’esposizione cumulativa ad asbesto dei lavoratori attraverso l’analisi del carico polmonare di fibre di amianto. Si è operata una valutazione dei monitoraggi ambientali e una rilevazione dei casi di patologie asbesto-correlate diagnosticati tra lavoratori della fabbrica, oltre all’analisi di campioni di tessuto polmonare di due lavoratori per la determinazione del carico residuo di fibre di amianto. Monitoraggi ambientali eseguiti nel 1982 indicavano concentrazioni medie di 0,3 fibre/cc e nel 1992 inferiori a 0,1 fibre/cc per tutti i campioni. Dal 1988 sono stati osservati 4 casi di placche pleuriche, 3 casi di asbestosi, 7 casi di tumore polmonare, nessun caso di mesotelioma maligno. In ambedue i casi di tumore polmonare con analisi delle fibre di amianto gli anfiboli erano assenti o con valori modesti mentre per il crisotilo e soprattutto per la tremolite le concentrazioni rilevate erano consistenti. In conclusione, dagli anni ’70 ai primi anni ’80 l’esposizione ad amianto crisotilo e a talco, in parte contaminati da tremolite, è risultata consistente e compatibile con casi di asbestosi. Non sono stati osservati casi di mesotelioma maligno. Non essendo stati usati anfiboli questo può essere dovuto al più basso rischio di mesotelioma associato al crisotilo, ma parte dei lavoratori assunti in anni successivi potrebbero non essere ancora a pieno rischio. Il carico polmonare di fibre nei due casi di tumore polmonare è essenzialmente dato dal crisotilo e dalla tremolite. La frequenza di tumori polmonari incidenti in questa coorte è verosimilmente sottostimata; il rischio di questa neoplasia dovrebbe essere valutato attraverso uno studio della mortalità della coorte.

The institution of specific Occupational Health and Safety (OHS) training programs open to international trainees from developing countries in some European, American and Asian universities is now a well-established reality. Courses and seminars that focus particularly on this subject, widely varying in approach and duration, have been held for years at these universities; these academic institutions have combined their potential to attract students from developing countries with the scheduling of interesting lectures and training activities, depending on the availability of funds sufficient to cover travel and lodging costs. Interdisciplinarity is the key to the entire program and is its main strength, as the trainees have the opportunity to condense the technical notions and methodological aspects of different disciplines (occupational health, industrial hygiene, safety management, ergonomics) in one course. We firmly believe that these programs are a precious instrument for the training of occupational health professionals from low-income countries, as they are able to address their choices correctly, hopefully achieving the goal of reducing the human costs of development.

Nickel (Ni) compounds and metallic Ni have many industrial and commercial applications, including their use in the manufacturing of stainless steel. Due to the specific toxicological properties of the different Ni species, there is a growing interest about the availability of analytical methods that allow specific risk assessment, particularly related to exposure to the Ni species classified as carcinogenic. In this paper, we described a speciation method of inorganic Ni compounds in airborne particulate matter, based on selective sequential extractions. The analytical method described in this paper allows the determination of soluble, sulfidic, metallic, and oxide Ni by a simple sequential extraction procedure and determination by Atomic Absorption Spectroscopy using small volumes of solutions and without long evaporation phases. The method has been initially set up on standard laboratory mixtures of known concentrations of different Ni salts. Then it has then been tested on airborne particulate matter (powder and filters) collected in different workstations of a large stainless steel production facility. The method has occurred effectively in the comparison of the obtained results with occupational exposure limit values set by the main international scientific and regulatory agencies for occupational safety and health, in order to prevent both toxic and carcinogenic effects in humans.

Several studies have shown an increased mortality rate for different types of tumors, respiratory disease and cardiovascular morbidity associated with foundry work. Airborne particles were investigated in a steelmaking foundry using an electric low-pressure impactor (ELPI+&trade, ), a Philips Aerasense Nanotracer and traditional sampling equipment. Determination of metallic elements in the collected particles was carried out by inductively coupled plasma mass spectrometry. The median of ultrafine particle (UFP) concentration was between 4.91 &times, 103 and 2.33 &times, 105 part/cm3 (max. 9.48 &times, 106 part/cm3). Background levels ranged from 1.97 &times, 104 to 3.83 &times, 104 part/cm3. Alveolar and deposited tracheobronchial surface area doses ranged from 1.3 &times, 102 to 8.7 &times, 103 mm2, and 2.6 &times, 101 to 1.3 &times, 103 mm2, respectively. Resulting inhalable and respirable fraction and metallic elements were below limit values set by Italian legislation. A variable concentration of metallic elements was detected in the different fractions of UFPs in relation to the sampling site, the emission source and the size range. This data could be useful in order to increase the knowledge about occupational exposure to fine and ultrafine particles and to design studies aimed to investigate early biological effects associated with the exposure to particulate matter in the foundry industries.

Background Formaldehyde, a widely used chemical, is considered a human carcinogen. We report the results of a meta-analyses of studies on the relationship between occupational exposure to formaldehyde and risk of non-Hodgkin lymphoma (NHL). Methods We performed a systematic review and meta-analysis according to international guidelines and we identified 12 reports of occupational populations exposed to formaldehyde. We evaluated inter-study heterogeneity and we applied a random effects model. We conducted a cumulative meta-analysis and a meta-analysis according to estimated average exposure of each study population. Results The meta-analysis resulted in a summary relative risk (RR) for NHL of 0.93 (95% confidence interval 0.83–1.04). The cumulative meta-analysis suggests that higher RRs were detected in studies published before 1986, while studies available after 1986 did not show an association. No differences were found between different levels of occupational exposure. Conclusions Notwithstanding some limitations, the results of this meta-analysis do not support the hypothesis of an association between occupational exposure to formaldehyde and risk of NHL.

Objectives We performed a cross-sectional study with the main aim of evaluating occupational exposure to polycyclic aromatic hydrocarbons (PAHs) in workers involved in the pavement construction of a new highway in Northern Italy, where modified bitumen was used as binder for Hot Mix Asphalt. Methods We applied a combined approach of air and biological monitoring. Both the aerosol and vapour phases of bitumen were collected applying the NIOSH 5506 method. The 16 PAHs listed as high priority by EPA were determined by HPLC-UV. End-of-shift urine samples were collected from 144 workers to determine 1-hydroxypyrene (1-OHP) and 2-naphthol (2-NAP) concentrations after enzyme digestion and HPLC-UV analysis. Socio-demographic and lifestyle information was collected by a questionnaire. Results Paving workers were actually exposed to PAHs, including carcinogenic compounds, that were measurable only in the aerosol phase. Higher exposure as well as dose levels were measured for the paver group. Biological monitoring confirmed that 1-OHP was less affected by smoking habits as compared to 2-NAP and showed a higher association with occupational exposure. Conclusion Carcinogenic PAH compounds were detectable only in the aerosol phase and this must be taken into account in the adoption of preventive measures. Biomonitoring supported the superiority of 1-OHP as compared to 2-NAP in assessing the internal dose in such workers.