Search

In this work, were determined some radiation shielding and dosimetric parameters of three types of bricks for photons energy from 1 keV to 100 GeV photons using the Phy-X/PSD software, and for comparison also has been calculated the same parameters for NBS concrete. The parameters calculated are the linear attenuation coefficients (LAC), effective atomic numbers (Zeff), half value layers (HVL), the energy absorption buildup factors (EABF) and the exposure buildup factors (EBF), as well as the coefficients to use the geometric progression (G-P) fitting method. Obtained results show that the three types of bricks can be used safely for the design of medical facilities housing mammography units (less than 30 keV)., (Copyright © 2022 Elsevier Ltd. All rights reserved.)

INEGI reports that 81% of new constructions are built with durable materials, such as concrete blocks, including rooms where ionizing radiation is used, such as clinics and hospitals. The volume ratios used in the manufacture of concrete blocks have a 1: 5: 2 ratio of: portland cement, sand and crushed gravel. The percentage mass content of each atom in the sample is obtained with the energy-dispersed X-ray fluorescence, these results are used to calculate the characteristics such as shielding of the concrete blocks, which have been partially reported, in this work several characteristics are presented for photons from 1 keV to 100 GeV, such as linear attenuation coefficients, the hemireductive layer, the effective, atomic and electronic sections, the effective atomic number (Zef). The exposure of accumulation and energy absorption factors (EBF, EABF) of 0.5-40 mfp are reported, using the Photon Shielding and Dosimetry (PSD) software. These characteristics are compared to those of NBS concrete. The concrete blocks have an attenuation capacity for energies used in radiological equipment such as mammography, 20-35 keV; dental, 50-90 keV and for conventional radiography equipment, 70-150 keV, so the block and lightened concrete block must be considered in the calculations of primary and secondary shielding walls., (Copyright © 2022 Elsevier Ltd. All rights reserved.)

In the work reported in this article, were determined the shielding capabilities of three artisanal bricks used massively in the construction industry in Mexico. The linear attenuation coefficients for photons between 1 keV and 100 GeV are reported; and the half-value layers for energies used in the medical field, show that the three typical artisanal bricks have good shielding capabilities for photons below 50 keV. We compared the effective atomic numbers of one of our bricks against two widely used materials in the construction industry, and our results suggest that the greater the effective atomic number, the less material attenuation capacity. A comparison of the half-value layer of one of our bricks against the half-value layers of two clay bricks with different percentages of fly ash particles published in the literature, suggests that in the region between 0.001 and 2.8 MeV, all the three bricks have practically the same attenuation capacity and that from 2.8 MeV to 100 GeV the clay bricks with different percentages of fly ash particles, need less material to show the same attenuation capacity than our artisanal bricks. Energy Dispersed X-Ray Fluorescence suggests that regardless of the number of constituent elements in a sample, a critical mass per atom is required to have a positive impact on density; and as a consequence, in the capacity of attenuation of the materials. Normalized half-value layers suggest on the other hand, that the uncooked bricks have better shielding capabilities than cooked., Competing Interests: Declaration of competing interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper., (Copyright © 2020 Elsevier Ltd. All rights reserved.)