Liming is an effective method of correcting soil acidity, but the cost and other factors, such as sub-soil acidity, topography, and nutrient availability may limit its benefits. An alternative option is to grow acid tolerant plants. Pot experiments are an effective way of identifying plants with the genetic potential to grow in acidic soils. These experiments require a range of acidity levels. The soil used in this study was a sandy loam. Increments of aluminum sulfate [Al2(SO4)3.18H2O] and calcium carbonate (CaCO3) were added to derive dose-pH response relationships. The derived relationships were used to estimate the quantity of aluminum sulfate and lime required to change the pHCa (1:5, w:v, soil:10 mM CaCl2) of the soil from 4.4 to 3.89 and 4.4 to 5.2, respectively. The estimated quantities of aluminum sulfate (380 g) and calcium carbonate (48 g) were thoroughly mixed through 100 kg batches of the soil, which was potted (2 kg/pot). Then the acidified soils were leached to remove excess salts. The initial pHCa achieved was 3.86 and rose to 3.94 after leaching. A wide range of soluble aluminum (Al) concentrations (1:5, w:v, soil:10 mM CaCl2) was obtained from this study, e.g., 52 mg Al/kg soil in acidified soil and 1.8 mg Al/kg soil in limed soil. The variation in pH and EC between replicate pots was negligible (range 0.05 pH and 0.02 dS/m) and these remained relatively unchanged after six months. During the next six months some pots were held in the laboratory with 3 wetting/drying cycles; however, most were placed outdoors where they were sown with seed of Austrodanthonia spp. During this time, the pHCa of the acidified soils increased slightly to: 4.10 (laboratory), 4.18 (outdoors without plants), and 4.20 (outdoors with plants). A similar increasing trend was also observed in limed soils. It was concluded that adding aluminum sulfate and calcium carbonate followed by washing with water are quick and convenient methods for adjusting soil pH for pot experiments. [ABSTRACT FROM AUTHOR]