Search

Tannin-based foams have gained attention as a potential bio-based alternative to conventional synthetic foams. Traditionally, namely condensed tannins (CT) have been used, leaving the potential of hydrolysable tannins (HT) largely unexplored. This study compared the performance of chestnut (HT) and quebracho (CT) in tannin-protein-based foams at different tannin ratios. Using soy protein isolate (SPI) and hexamine under acidic conditions, a series of tannin foams were produced through a mechanical foaming method and analyzed for cell structure, compression strength, thermal conductivity, and chemical stability. Results show that chestnut tannin is viable in hexamine SPI formulations but is harder to process due to lower reactivity, further resulting in higher material densities compared to quebracho. Foams with higher quebracho content featured smaller, more interconnected cells, while increasing chestnut content led to larger, less interconnected cells. Compression strength decreased with higher chestnut content, while fire resistance and thermal conductivity were influenced by material density rather than tannin type. The 13 C-NMR analysis revealed covalent bonding of hexamine with both tannins, but potential covalent bonds with SPI were undetectable. Overall, chestnut tannin can substitute quebracho tannin in hexamine-SPI foams, though with compromises in terms of specific material properties and processability.

Vegetable tannins are environmentally friendly tanning agents. However, they generally impart a dark colour to the tanned leather and highly contribute to the organic load in wastewaters. In this study, we employed a purification protocol separately on chestnut tannin (CT) and sulfited quebracho tannin (QT) to obtain the purified fractions (PCT and PQT). These samples were characterised by GPC, 1 H NMR, 13 C NMR, FT-IR, and HPLC-DAD techniques and applied for tanning tests. Through the purification process, non-tannin components and smaller molecules such as gallic acid, glucopyranose, and catechin were effectively removed from CT and QT, which consequently led to the reduced moisture content, pH value, and lighter colour of purified fractions. The crust leathers processed with PCT and PQT showed desirable light shades. Moreover, the organic loads in PCT and PQT tanning wastewater were reduced by 13.5% and 19.1%, respectively, when compared to those in traditional CT and QT tanning wastewater. Additionally, the physical and mechanical characteristics of crust leathers processed with PCT and PQT were comparable to those processed with CT and QT. Thus, purification of vegetable tannins may serve as a feasible strategy for producing light-colored vegetable-tanned leather while minimizing organic pollutant discharge during the vegetable tanning process., Supplementary Information: The online version contains supplementary material available at 10.1186/s42825-024-00171-9., Competing Interests: Competing interestsValentina Beghetto is a member of the editorial board of Collagen and Leather, and was not involved in the editorial review, or the decision to publish this article. All authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper., (© The Author(s) 2024.)

Six food-grade tannins obtained from different woods were used as a source of polyphenolic compounds at two concentrations (0.5% and 1% w / w ) in yogurt formulations and monitored during 3 weeks of storage. Yogurt containing tannins showed significantly higher total phenolic content (+200%), antioxidant activity (+400%), and syneresis (+100%) than control. These changes were higher with fortification at 1%. Tannin origin also significantly influenced the yogurt composition and yogurt obtained from a Turkish gall showed higher values of total phenolic content (4 mg GAE/g) and antioxidant activity (17 μM Trolox/g). Yogurt color was evaluated by CIELab parameters, and their values were influenced by tannin origin and concentration. The addition of tannins did not significantly affect the number of lactic acid bacteria. Yogurt with a lower amount of tannins (0.5% w / w ) received higher consumer acceptability but significant differences in preferences were due to tannin origin. In particular, yogurt added with tannin obtained from Quebracho wood at 1% w / w showed higher consumer preference. The obtained results would provide an opportunity for dairy producers to develop a novel dairy food with high nutritional quality.

Ellagic acid (EA) has long been recognized as a very active antioxidant, anti-inflammatory, and antimicrobial agent. However, its low bioavailability has often hampered its applications in health-related fields. Here, we report a phospholipid vesicle-based controlled release system for EA, involving the exploitation of chestnut wood mud (CWM), an industrial by-product from chestnut tannin production, as a largely available and low-cost source of this compound. Two kinds of CWM with different particle size distributions, indicated as CWM-A and CWM-B (<100 and 32 µm, respectively), containing 5 ± 1% w/w EA, were incorporated into transfersomes. The latter were small in size (~100 nm), homogeneously dispersed, and negatively charged. 2,2-Diphenyl-1-picrylhydrazyl (DPPH) and ferric reducing/antioxidant power (FRAP) assays indicated up to three-fold improvement in the antioxidant properties of CWM upon incorporation into transfersomes. The kinetics of EA released under simulated physiological conditions were evaluated by UV-Vis spectroscopy and HPLC analysis. The best results were obtained with CWM-B (100% of EA gradually released after 37 days at pH 7.4). A stepwise increase in the antioxidant properties of the released material was also observed. Cell-based experiments confirmed the efficacy of CWM-B transfersomes as antioxidant agents in contrasting photodamage.

Tannins have always been the subject of great interest for their countless properties, first of all their ability to produce functional coatings on a variety of materials. We report herein a comparative evaluation of the antioxidant properties of wood tannin-based coated substrates. In particular, nylon membrane filters were functionalized with chestnut (hydrolyzable) or quebracho (condensed) tannins by dip coating under different conditions. The efficiency of functionalization was evaluated by the 2,2-diphenyl-1-picrylhydrazyl (DPPH) and ferric reducing/antioxidant power (FRAP) assays, which invariably highlighted the superior ability of condensed tannins to induce the formation of a functional and robust coating. The results of the antioxidant assays revealed also the deleterious effects of aerial or enzymatic oxidation conditions on substrate functionalization, being more significant in the case of hydrolyzable tannins. On the other hand, the use of oxidizing conditions allowed to obtain more stable coatings, still exhibiting good antioxidant properties, in the case of condensed tannins. The presence of iron ions did not lead to a significant improvement of the coating efficiency for either tannins. The systematic approach used in this work provides novel and useful information for the optimal exploitation of tannins in antioxidant functional coatings.

Largely produced agri-food byproducts represent a sustainable and easily available source of phenolic compounds, such as lignins and tannins, endowed with potent antioxidant properties. We report herein the characterization of the antioxidant properties of nine plant-derived byproducts. 2,2-Diphenyl-1-picrylhydrazyl (DPPH) and ferric reducing/antioxidant power (FRAP) assays indicated the superior activity of pomegranate peels and seeds, grape pomace and pecan nut shell. An increase in the antioxidant potency was observed for most of the waste materials following a hydrolytic treatment, with the exception of the condensed tannin-rich pecan nut shell and grape pomace. UV-Vis and HPLC investigation of the soluble fractions coupled with the results from IR analysis and chemical degradation approaches on the whole materials allowed to conclude that the improvement of the antioxidant properties was due not only to removal of non-active components (mainly carbohydrates), but also to structural modifications of the phenolic compounds. Parallel experiments run on natural and bioinspired model phenolic polymers suggested that these structural modifications positively impacted on the antioxidant properties of lignins and hydrolyzable tannins, whereas significant degradation of condensed tannin moieties occurred, likely responsible for the lowering of the reducing power observed for grape pomace and pecan nut shell. These results open new perspectives toward the exploitation and manipulation of agri-food byproducts for application as antioxidant additives in functional materials., Competing Interests: The authors declare no conflict of interest.

The authors wish to make the following corrections to their paper [...].

Exhausted woods represent a byproduct of tannin industrial production processes and their possible exploitation as a source of antioxidant compounds has remained virtually unexplored. We herein report the characterization of the antioxidant and other properties of practical interest of exhausted chestnut wood and quebracho wood, together with those of a chestnut wood fiber, produced from steamed exhausted chestnut wood. 2,2-Diphenyl-1-picrylhydrazyl (DPPH) and ferric reducing/antioxidant power (FRAP) assays indicated good antioxidant properties for all the materials investigated, with exhausted chestnut wood, and, even more, chestnut wood fiber exhibiting the highest activity. High efficiency was observed also in the superoxide scavenging assay. An increase of the antioxidant potency was observed for both exhausted woods and chestnut wood fiber following activation by hydrolytic treatment, with an up to three-fold lowering of the EC 50 values in the DPPH assay. On the other hand, exhausted quebracho wood was particularly effective as a nitrogen oxides (NO x ) scavenger. The three materials proved able to adsorb methylene blue chosen as a model of organic pollutant and to remove highly toxic heavy metal ions like cadmium from aqueous solutions, with increase of the activity following the hydrolytic activation. These results open new perspectives toward the exploitation of exhausted woods as antioxidants, e.g., for active packaging, or as components of filtering membranes for remediation of polluted waters., Competing Interests: The authors declare no conflict of interest.

Tannins are secondary metabolites that are widely distributed in the plant kingdom. They act as growth inhibitors for many microorganisms: they are released upon microbial attack, helping to fight infection in plant tissues. Extraction of tannins from plants is an active industrial sector with several applications, including oenology, animal feeding, mining, the chemical industry, and, in particular, the tanning industry. However, tannins are also considered very recalcitrant pollutants in wastewater of diverse origin. The ability to grow on plant substrates rich in tannins and on industrial tannin preparations is usually considered typical of some species of fungi. These organisms are able to tolerate the toxicity of tannins thanks to the production of enzymes that transform or degrade these substrates, mainly through hydrolysis and oxidation. Filamentous fungi capable of degrading tannins could have a strong environmental impact as bioremediation agents, in particular in the treatment of tanning wastewaters.

The ethanol extract of the commercial tannin Tan'Activ C, (from Castanea sativa wood), employed in oenology, was subjected to chromatography on XAD-16 affording fractions X1-X5, evaluated for total phenols content (GAE), antioxidant activity (DPPH, ORAC), and hypoglycemic activity (α-glucosidase inhibition). Fraction X3 showed GAE, radical scavenging activity, and α-glucosidase inhibition higher than those of the Castanea sativa extract, and was subjected to chromatography on Sephadex LH-20 to obtain fractions S1-S7, analyzed by HPLC/ESI-MS/MS and 1 H NMR to identify the main active constituents. In fractions with higher antioxidant activity, gallic acid (4), grandinin (5), valoneic acid dilactone (9), 1,2,3-tri-O-galloyl-β-glucose (14), 3,4,6-tri-O-galloyl-β-glucose (15) and galloyl derivative of valoneic acid dilactone (21) were identified as the major constituents. The highest hypoglycemic activity was found in fractions S6 and especially S7; the major constituents of these fractions are valoneic acid dilactone (9), three tetragalloyl glucose isomers (16-18) and 1,2,3,4,6-penta-O-galloyl-β-glucose (23), previously reported as α-glucosidase inhibitors., (Copyright © 2018 Elsevier Ltd. All rights reserved.)

Tannins are a complex family of polyphenolic compounds, widely distributed in the plant kingdom where they act as growth inhibitors towards many microorganisms including bacteria, yeasts, and fungi. Tannins are one of the major components of tannery wastewaters and may cause serious environmental pollution. In the present study, four different tannins (the hydrolysable chestnut ellagitannin and tara gallotannin and the condensed quebracho and wattle tannins) were characterized from a mycological point of view with the aim of selecting fungal strains capable of growing in the presence of high tannin concentration and thus potentially useful in industrial biotransformations of these compounds or in the bioremediation of tannery wastewaters. A total of 125 isolates of filamentous fungi belonging to 10 species and four genera (Aspergillus, Paecilomyces, Penicillium, and Talaromyces) were isolated from the tannin industrial preparations. Miniaturized biotransformation tests were set up with 10 fungal strains and the high-performance liquid chromatography (HPLC) analysis pointed out a strong activity of all the tested fungi on both chestnut and tara tannins. Two strains (Aspergillus tubingensis MUT 990 and Paecilomyces variotii MUT 1125), tested against a real tannery wastewater, were particularly efficient in chemical oxygen demand (COD) and tannin removal (> 60%), with a detoxification above 74%. These results indicate that these fungi are potentially exploitable in the treatment of tannery wastewaters.