Search

The SA516 Gr.70 steel possessing excellent toughness and plasticity has been widely used in the cryogenic field. However, the appearance of coarse bainite in the heat affected zone (HAZ) of the fusion welded joint deteriorates the toughness and ductility. In this work, 4.5 mm thick SA516 Gr.70 steel was joined using shielded metal arc welding (SMAW) and friction stir welding (FSW), respectively, and the microstructure and mechanical properties of joints were investigated in detail. The Charpy energy in the HAZ in the FSW joint was 80 J/cm2, which was higher than that of the HAZ in the SMAW joint (60 J/cm2) and due to microstructure refinement. In addition, the total elongation (TE) of the SMAW joint was 17.5%, which was higher than that of the FSW joint (12.1%) and caused by a wider nugget zone with high hardness. The post-welding annealing was used to improve the toughness and ductility of the SMAW and FSW joints, and the microstructure and mechanical properties of the joints after annealing were analyzed. The toughness in the HAZ of the SMAW and FSW joints were 80 and 103 J/cm2, and the TE of the SMAW and FSW joints were 18.6% and 25.2%, respectively. Finally, the as-annealed FSW joints exhibited excellent toughness and ductility. The abovementioned excellent mechanical properties were primarily attributed to the appearance of tempering martensite, decrease in dislocation density, and fine grain. [ABSTRACT FROM AUTHOR]

In this paper, 5083 aluminum alloy and T2 copper were selected for the friction stir lap welding test. The effect of intermetallic compounds on the microstructure and properties of Al/Cu dissimilar metal lap joints was studied. The results showed that the circulating Al/Cu composite structure was formed on the advancing side of the lap joint, and the Al/Cu staggered hook-like structure and copper-rich region were generated on the retreating side. There was no typical 'onion ring' structure in the joint. Element diffusion occurred at the interface of the joint, forming a thin and uniform interfacial layer of Al/Cu intermetallic compounds, thus achieving a well-metallurgical bond at the Al/Cu interface. There were the intermetallic compounds Al2Cu and Al4Cu9, without AlCu, in the lap joint. In addition, dynamic recrystallization occurred in the nugget zone, and higher dislocation density and dislocation entanglement were generated, which enhanced the deformation resistance in the nugget zone and increased the joint strength. The tensile test showed that the ductile–brittle mixed fracture occurred in the heat-affected zone on the advancing side of the aluminum plate, and the fracture had necking. The failure load of the lap joint was 4350 ± 30 N, about 80% of the aluminum base metal. The elongation of the Al/Cu dissimilar lap joint tensile specimen was 2.5%. [ABSTRACT FROM AUTHOR]