Search

Plate tectonics describes oceanic transform faults as conservative strike-slip boundaries, where lithosphere is neither created nor destroyed. Therefore, seafloor accreted at ridge-transform intersections should follow a similar subsidence trend with age as lithosphere that forms away from ridge-transform intersections. Yet, recent compilations of high-resolution bathymetry show that the seafloor is significantly deeper along transform faults than at the adjacent fracture zones. We present residual mantle Bouguer anomalies, a proxy for crustal thickness, for 11 transform fault systems across the full range of spreading rates. Our results indicate that the crust is thinner in the transform deformation zone than in either the adjacent fracture zones or the inside corner regions. Consequently, oceanic transform faulting appears not only to thin the transform valley crust but also leads to a secondary phase of magmatic addition at the transition to the passive fracture zones. These observations challenge the concept of transform faults being conservative plate boundaries.

Among the recently evolving transform faults, the Blancotransform fault system (BTFS) in the northwest off the coast of Oregon,is strongly segmented and resembles other segmented oceanic transform systems, such as the Siqueiros in the East Pacific Rise, which developed from a pre-existing transform fault that was subjected to several extensional events due to a known shift in spreading direction. However,plate tectonic reconstructions suggested that the BTFS developed from at least two large ridge offsets rather than a single transform fault, emerging from a series of ridge propagation events after the plate reorientation at ~5 Ma.We investigated the seismotectonic behavior and tectonic evolution of the BTFS using ocean-bottom seismometer data from the Blanco Transform OBS Experiment (2012–2013) as well as high-resolution multibeam bathymetry, aeromagnetic, and gravity datasets. Interestingly, we observed no evidence for the existence of either transform faults or fracture zones around the BTFS before 2 Ma, indicating that there were no pre-existing transform faults before the formation of the BTFS. Therefore, we propose that the BTFS developed from two broad transfer zones rather than pre-existing transform faults. Moreover, local seismicity shows significant along-strike variations, revealing different modes of slip in the eastern and western BTFS.Seismic slip vectors suggest that the western BTFS is an immature transform fault system since its reorganization is still taking place, but the eastern BTFS accommodating the plate motion ismature. The BTFS acts as a natural laboratory to understand the mechanisms controlling the development of oceanic transform plate boundaries., The 28th IUGG General Assembly (IUGG2023) (Berlin 2023)

Until now, few offshore seismic studies have acquired simultaneously P- and S- wave data to derive in detail the seismic structure of the oceanic crust. We present 2-D Vp and Vs models using wide-angle seismic data at the Indian basin adjacent to the NinetyEast Ridge. Here, an outcrop basement located at the middle of the seismic line presents uppermost crustal Poisson's ratios (ν) of 0.28–0.29 (Vp ∼ 4.2 km/s and Vs ∼ 2.3 km/s). At the flanks of the outcrop basement, the sediment cover is 200–300 m thick and ν values are similar (0.28–0.3), but Vp and Vs values are higher (4.5–4.8 and 2.4–2.6 km/s, respectively). We interpret the relatively lower Vp and Vs around the basement outcrop in terms of hydrothermal alteration, while at the flanks of the basement outcrop, hydrothermal alteration has most likely ceased by sedimentation and compaction processes. Across the seismic layer 2, the Vp–Vs trend is linear and follows a ν value of 0.28–0.29, however, at the seismic layer 2/3 transition, the Vp–Vs trend abruptly changes following a ν value of 0.25–0.26. These reduced observed ν values at the layer 2/3 transition are lower than those reported by laboratory measurements for gabbro (ν ∼ 0.293) and are interpreted in terms of epidotization at the dike-gabbro contact and/or crack-change properties around the lower part of the intrusive sheeted dike section. Key Points We obtain 2-D Vp and Vs models from active seismic data for the Indian oceanic crust The seismic models suggest hydrothermal alteration near a basement outcrop Poisson's ratios change at the layer 2/3 transition from 0.28–0.29 to 0.25–0.26

The VP/VS ratio is an important property for understanding magmatic and tectonic processes at passive continental margins as it is an indicator of the crustal composition. To classify the dominant lithologies in the Zhongsha Block, South China Sea (SCS), we present a detailed VP/VS crustal model based on the independent tomographic inversion of P wave and S wave data. The average VP/VS in the crust of the Zhongsha Block is ∼1.77, indicating an overall felsic to intermediate composition lacking remnant magmatic intrusive rocks. The VP-density relationship from gravity modeling suggests that the lower crust of the extended continental domain contains more greenschist and hence may have experienced metamorphism resulting from an elevated geotherm in the Northwest Sub-basin either during the syn-spreading or postspreading stage. The variability of the VP/VS ratio in the continental block is larger than that in the oceanic basin, showing distinct crustal properties. Several low VP/VS ratio anomalies (VP/VS < 1.7) were found near tectonic boundaries and are interpreted to either result from felsic metamorphism during an interval of rifting, or during the migration of magma along faults and cracks in the postrift period. VP/VS ratios occurring in concert with high VP anomalies in the continent-ocean transition zone support a mafic composition of metapelitic granulite, which was either formed by magmatic intrusions or contact with mantle melting that stem from the upwelling of the asthenospheric mantle during the initial break-up and onset of the seafloor spreading stage in the SCS.

The Liguro-Provençal basin was formed as a back-arc basin of the retreating Calabrian-Apennines subduction zone during the Oligocene and Miocene. The resulting rotation of the Corsica-Sardinia block is associated with rifting, shaping the Ligurian Sea. It is still debated whether oceanic or atypical oceanic crust was formed or if the crust is continental and experienced extreme thinning during the opening of the basin. We invert velocity models using an amphibious network of seismic stations, including 22 broadband Ocean Bottom Seismometers (OBS) to investigate the lithospheric structure of the Ligurian sea. The instruments were installed in the Ligurian Sea for eight months between June 2017 and February 2018 as part of the AlpArray seismic network. Because of additional noise sources in the ocean, OBS data are rarely used for ambient noise studies. However, we attentively pre-process the data, including corrections for instrument tilt and seafloor compliance. We took extra care to exclude higher modes of the ambient-noise Rayleigh waves. We calculate daily cross-correlation functions for the LOBSTER array and surrounding land stations. Additionally, we correlate short time windows that include teleseismic earthquakes that allow us to derive surface wave group velocities for longer periods than using ambient noise only. Group velocity maps are obtained by inverting Green’s functions derived from the cross-correlation of ambient noise and teleseismic events, respectively. We then used the resulting 3D group velocity information to calculate 1D depth inversions for S-wave velocities. The shear-wave velocity results show a deepening of the Moho from 12 km at the southwestern basin centre to 20–25 km at the Ligurian coast in the northeast and over 30 km at the Provençal coast. We find no hint on mantle serpentinisation and no evidence for an Alpine slab, at least down to depths of 25 km. However, we see a separation of the southwestern and northeastern Ligurian Basin that coincides with the promoted prolongation of the Alpine front.

The northern margin of the Ligurian Basin shows notable seismicity at the Alpine front, including frequent magnitude 4 events. Seismicity decreases offshore towards the Basin centre and Corsica, revealing a diffuse distribution of low-magnitude earthquakes. We analyse data of the amphibious AlpArray seismic network with focus on the offshore component, the AlpArray ocean bottom seismometer (OBS) network, consisting of 24 broadband OBSs deployed for 8 months, to reveal the seismicity and depth distribution of micro-earthquakes beneath the Ligurian Sea. Two clusters occurred between ∼ 10 km to ∼ 16 km depth below the sea surface, within the lower crust and uppermost mantle. Thrust faulting focal mechanisms indicate compression and an inversion of the Ligurian Basin, which is an abandoned Oligocene–Miocene rift basin. The basin inversion is suggested to be related to the Africa–Europe plate convergence. The locations and focal mechanisms of seismicity suggest reactivation of pre-existing rift-related structures. Slightly different striking directions of presumed rift-related faults in the basin centre compared to faults further east and hence away from the rift basin may reflect the counter-clockwise rotation of the Corsica–Sardinia block. High mantle S-wave velocities and a low Vp/Vs ratio support the hypothesis of strengthening of crust and uppermost mantle during the Oligocene–Miocene rifting-related extension and thinning of continental crust.

The northern margin of the Ligurian Basin shows notable seismicity at the Alpine front, including frequent magnitude 4 events. Seismicity decreases offshore towards the Basin centre and Corsica, revealing a diffuse distribution of low magnitude earthquakes. We analyse data of the amphibious AlpArray seismic network with focus on the offshore component, the AlpArray OBS network, consisting of 24 broadband ocean bottom seismometers deployed for eight months, to reveal the seismicity and depth distribution of micro-earthquakes beneath the Ligurian Sea. Two clusters occurred between ~10 km to ~16 km depth below sea surface, within the lower crust and uppermost mantle. Thrust faulting focal mechanisms indicate compression and an inversion of the Ligurian Basin, which is an abandoned Oligocene rift basin. The Basin inversion is suggested to be related to the Africa-Europe plate convergence. The locations and focal mechanisms of seismicity suggest reactivation of pre-existing rift structures. Slightly different striking directions of faults in the basin centre compared to faults further east and hence away from the abandoned rift may mimic the counter-clockwise rotation of the Corsica-Sardinia block during ~20–16 Ma. The observed cluster events support the hypothesis of strengthening of crust and uppermost mantle during rifting related extension and thinning of continental crust.

International audience; The Alpine orogen and the Apennine system are part of the complex tectonic setting in the Mediterranean Sea caused by the convergence between Africa and Eurasia. Between 30 Ma and 15 Ma the Calabrian subduction retreated in a southeast direction pulling Corsica and Sardinia away from the Eurasian landmass. In this extensional setting, the Ligurian Sea was formed as a back-arc basin. The rifting jumped 15 Ma ago in the Tyrrhenian Sea leaving Corsica and Sardinia in a stable position relative to Eurasia.Within the framework of the AlpArray research initiative a long-term seismological experiment was conducted in the Ligurian Sea to investigate the lithospheric structure and the seismicity in the Ligurian basin. The passive seismic network consisted of 29 broad-band ocean bottom stations from Germany and France. It was in operation between June 2017 and February 2018.Two seismicity clusters occurred in the centre of the Ligurian Basin. The 18 earthquakes are located in the lower crust and in the upper-most mantle at depths between 10 km and 16 km. Re-location was performed only using picks from the OBS in the centre of the Ligurian Sea to avoid artifacts from the complex 3D velocity structure of the basin. Mantle refractions Pn and Sn have apparent velocities of 8.2 km/s and 4.7 km/s. The low Vp-Vs-ratio of 1.72 indicates a more brittle behaviour of the mantle material.Fault plane solutions were determined for four events using also the data of land stations in southern France, Corsica, Sardinia and northern Italy. The focal mechanisms are thrust faulting. Fault planes strike in a NE-SW direction, coinciding with the alignment of the events and the direction of the basin axis.We interprete the two earthquake clusters related to the inversion of the Ligurian Basin where the basin"s centre is under compression and stresses are taken up by reactivated faults in the crust and uppermost mantle. The compressional forces could be caused by the convergence of Africa and Europe. In general, observations of earthquakes in continental mantle lithosphere are rare and they reveal on the one hand a strengthening of the crust and uppermost mantle during rifting and on the other hand they support the interpretation that rifting failed in the northern Ligurian Basin.

TRANSFORMERS ; Emden, Deutschland (11.01.2021) – Emden, Deutschland (14.02.2021)