Search

We evaluate the heat transfer from radiant ceilings that have suspended acoustical panels present for noise reduction. An upward-directed ceiling fan is added to offset the reduction of heat exchange due to the acoustical panels. We systematically simulate the indoor thermal environment and the changes to heat transfer coefficients caused by the interaction between radiant ceiling panels, acoustical panels, and ceiling fan under four influencing factors: (1) coverage ratio of acoustical panels, (2) fan rotational speed, (3) radiation panel temperature and (4) room height. The simulation method is validated with experimental data. Numerical results show that the augmented air speed increases convective and total heat transfer for radiant panel. Simulated temperature non-uniformity, air and operative temperature in the occupied part of the room is reduced with increased fan speed, and with decreased acoustical panel coverage ratio. The PMV increased with increased acoustical panel coverage ratio and radiant surface temperature, and also with reduced fan speed. When using fans, the radiant surface temperature can be raised 2 ℃ while maintaining equivalent thermal comfort, allowing higher water supply temperatures. The radiation heat transfer coefficient of the bare ceiling is decreased 25% by adding 63% acoustical panel coverage. The total heat transfer coefficient of radiant ceiling increases with fan speed up to 106.2% over a no-fan base case, and decreases with increased acoustical panel coverage ratio. The study indicates that an upward-directed ceiling fan is a worthwhile method to enable raised radiant surface temperatures, save cooling energy, and reduce surface condensation risk.

Developing high activity, low-cost and long durability catalysts for oxygen reduction reaction is of great significance for the practical application of microbial fuel cells. The full exposure of active sites in catalysts can enhance catalytic activity dramatically. Here, novel Fe-N-doped graphene is successfully synthesized via a one-step in situ ball milling method. Pristine graphite, ball milling graphene, N-doped graphene and Fe-N-doped graphene are applied in air cathodes, and enhanced performance is observed in microbial fuel cells with graphene-based catalysts. Particularly, Fe-N-doped graphene achieves the highest oxygen reduction reaction activity, with a maximum power density of 1380±20 mW/m2 in microbial fuel cells and a current density of 23.8 A/m2 at −0.16 V in electrochemical tests, which are comparable to commercial Pt and 390% and 640% of those of pristine graphite. An investigation of the material characteristics reveals that the superior performance of Fe-N-doped graphene results from the full exposure of Fe2O3 nanoparticles, pyrrolic N, pyridinic N and excellent Fe-N-G active sites on the graphene matrix. This work not only suggests the strategy of maximally exposing active sites to optimize the potential of catalysts but also provides promising catalysts for the use of microbial fuel cells in sustainable energy generation. [ABSTRACT FROM AUTHOR]

Mn/Ce/Ti and Mn/Ce/Nb/Ti catalysts were synthesized using a precipitation method and their catalytic activities for NO selective reduction with NH 3 at low temperatures were evaluated. Nb doping not only improved the activity of the catalyst over a wide temperature range but also restricted the generation of NO 2 and N 2 O. The Mn/Ce/Nb/Ti catalyst displayed 100% NO conversion from 150 to 250 °C and >90% N 2 selectivity below 250 °C. The specific surface area of the catalyst was increased and its surface acidity was strengthened after Nb doping. Moreover, Nb doping increased the NO oxidation ability and lowered the NH 3 oxidation activity of the catalyst. All the above factors contributed to enhancing the overall NH 3 -SCR performance of the Mn/Ce/Nb/Ti catalyst compared with that of the Mn/Ce/Ti one. The long-term stability and resistance to H 2 O and SO 2 of the Mn/Ce/Nb/Ti catalyst were also evaluated. [ABSTRACT FROM AUTHOR]