Search

Alloys made of CoCrMo are well established as implants materials since decades in orthopedic surgery. The good mechanical properties, biocompatibility and especially the corrosion resistance are important rationales for the use of these alloys. Nevertheless, retrieved implants from revision surgery showed the occurrence of abrasion and corrosion. The wear mechanisms and the occurring corrosion processes might be reduced with a functionalization of the surface. The hexagonal phase of the cobalt chromium matrix plays an important role in the surface functionalization. It can be specifically transformed and set during the manufacturing process. One possibility for the induction of the transformation is the use of a deep rolling process in combination with a novel "sub‐zero" cooling strategy during machining. The influence of force and temperature during the deep rolling process on the formation of the hexagonal Co‐phase is examined in this study. The results from the targeted setting of the hexagonal Co‐phase in the subsurface are shown. For this purpose, EBSD studies have been carried out to detect and quantify the proportion of Co‐hex phase in the subsurface of the modified alloys. To analyze the mechanical properties, we measured the residual stress and hardness in the near surface layer under conditions close to the application. Furthermore, we performed biological tests to show a potential influence of the modification on the biocompatibility when using the sub‐zero cooling approach. We observed no negative effect on the osteoblastic cell line which attached similarly to all tested surfaces. The investigations provide first insights into the potential use of "sub‐zero" cooling in modifying orthopedic implant materials, but also the respective limits with regard to the surface functionalization. Deep rolling in combination with an innovative cooling strategy has a great potential to improve the mechanical properties of CoCr28Mo6 wrought alloy, by subsurface hardening and phase transformation. [ABSTRACT FROM AUTHOR]

Wear and corrosion at taper junctions of orthopaedic endoprostheses remain of great concern and are associated with adverse clinical reactions. Whereas tribocorrosion of hip tapers was extensively investigated, there is only little knowledge regarding the clinical performance of modular total shoulder prostheses. This retrieval study evaluated 35 modular taper junctions of anatomical shoulder explants using stereomicroscopy, confocal microscopy, as well as optical and scanning electron microscopy to determine the damage modes as well as the effects of taper topography and alloy microstructure. Among all humeral head tapers, 89% exhibited material degradation. Different overlapping wear mechanisms were identified such as plastic deformation, adhesive material transfer, microploughing, and fretting damage. Only CoCrMo cast alloy heads showed a susceptibility to electrochemically dominated fretting in comparison to CoCrMo wrought alloy. Moreover, corundum blasted stem tapers show a significantly increased incidence rate for microploughing. To date, this is the most comprehensive study on the damage types of modular taper junctions of anatomical shoulder arthroplasty proving the existence of fretting even on less weight‐bearing implants. This study revealed critical fretting factors, such as the surface finish and the alloy type that are essential for the development of countermeasures that avoid any taper corrosion. [ABSTRACT FROM AUTHOR]