Search

We realize tunable coupling between two superconducting transmission line resonators. The coupling is mediated by a non-hysteretic rf SQUID acting as a flux-tunable mutual inductance between the resonators. From the mode distance observed in spectroscopy experiments, we derive a coupling strength ranging between -320MHz and 37 MHz. In the case where the coupling strength is about zero, the microwave power cross transmission between the two resonators can be reduced by almost four orders of magnitude compared to the case where the coupling is switched on. In addition, we observe parametric amplification by applying a suitable additional drive tone., Comment: 6 pages 5 figures

We report on ultrastrong coupling between a superconducting flux qubit and a resonant mode of a system comprised of two superconducting coplanar stripline resonators coupled galvanically to the qubit. With a coupling strength as high as 17% of the mode frequency, exceeding that of previous circuit quantum electrodynamics experiments, we observe a pronounced Bloch-Siegert shift. The spectroscopic response of our multimode system reveals a clear breakdown of the Jaynes-Cummings model. In contrast to earlier experiments, the high coupling strength is achieved without making use of an additional inductance provided by a Josephson junction.

We realize a device allowing for tunable and switchable coupling between two superconducting resonators mediated by an artificial atom. For the latter, we utilize a persistent current flux qubit. We characterize the tunable and switchable coupling in frequency and time domain and find that the coupling between the relevant modes can be varied in a controlled way. Specifically, the coupling can be tuned by adjusting the flux through the qubit loop or by saturating the qubit. Our time domain measurements allow us to find parameter regimes for optimal switch performance with respect to qubit drive power and the dynamic range of the resonator input power.

Josephson parametric amplifiers (JPA) are promising devices for applications in circuit quantum electrodynamics (QED) and for studies on propagating quantum microwaves because of their good noise performance. In this work, we present a systematic characterization of a flux-driven JPA at millikelvin temperatures. In particular, we study in detail its squeezing properties by two different detection techniques. With the homodyne setup, we observe squeezing of vacuum fluctuations by superposing signal and idler bands. For a quantitative analysis we apply dual-path cross-correlation techniques to reconstruct the Wigner functions of various squeezed vacuum and thermal states. At 10 dB signal gain, we find 4.9+-0.2 dB squeezing below vacuum. In addition, we discuss the physics behind squeezed coherent microwave fields. Finally, we analyze the JPA noise temperature in the degenerate mode and find a value smaller than the standard quantum limit for phase-insensitive amplifiers., Comment: 24 pages, 18 PDF figures

Coupled superconducting transmission line resonators have applications in quantum information processing and fundamental quantum mechanics. A particular example is the realization of fast beam splitters, which however is hampered by two-mode squeezer terms. Here, we experimentally study superconducting microstrip resonators which are coupled over one third of their length. By varying the position of this coupling region we can tune the strength of the two-mode squeezer coupling from 2.4% to 12.9% of the resonance frequency of 5.44GHz. Nevertheless, the beam splitter coupling rate for maximally suppressed two-mode squeezing is 810MHz, enabling the construction of a fast and pure beam splitter.

Path entanglement constitutes an essential resource in quantum information and communication protocols. Here, we demonstrate frequency-degenerate entanglement between continuous-variable quantum microwaves propagating along two spatially separated paths. We combine a squeezed and a vacuum state using a microwave beam splitter. Via correlation measurements, we detect and quantify the path entanglement contained in the beam splitter output state. Our experiments open the avenue to quantum teleportation, quantum communication, or quantum radar with continuous variables at microwave frequencies., Comment: 16 pages, 14 figures

Quantum dots are an important model system for thermoelectric phenomena, and may be used to enhance the thermal-to-electric energy conversion efficiency in functional materials. It is therefore important to obtain a detailed understanding of a quantum-dot's thermopower as a function of the Fermi energy. However, so far it has proven difficult to take effects of co-tunnelling into account in the interpretation of experimental data. Here we show that a single-electron tunnelling model, using knowledge of the dot's electrical conductance which in fact includes all-order co-tunneling effects, predicts the thermopower of quantum dots as a function of the relevant energy scales, in very good agreement with experiment., Comment: 10 pages, 5 figures

Quantitative thermoelectric measurements in the mesoscopic regime require accurate knowledge of temperature, thermovoltage, and device energy scales. We consider the effect of a finite load resistance on thermovoltage measurements of InAs/InP heterostructure nanowires. Load resistance and ac attenuation distort the measured thermovoltage therefore complicating the evaluation of device performance. Understanding these effects improves experimental design and data interpretation., Comment: 2 pages, 3 figures

Superconducting qubits acting as artificial two-level atoms allow for controlled variation of the symmetry properties which govern the selection rules for single and multiphoton excitation. We spectroscopically analyze a superconducting qubit-resonator system in the strong coupling regime under one- and two-photon driving. Our results provide clear experimental evidence for the controlled transition from an operating point governed by dipolar selection rules to a regime where one- and two-photon excitations of the artificial atom coexist. We find that the vacuum coupling between qubit and resonator can be straightforwardly extracted from the two-photon spectra where the detuned two-photon drive does not populate the relevant resonator mode significantly., Comment: 8 pages, 5 figures

Superconducting circuit quantum electrodynamics experiments with propagating microwaves require devices acting as beam splitters. Using niobium thin films on silicon and sapphire substrates, we fabricated superconducting 180{\deg} microstrip hybrid ring couplers, acting as beam splitters with center frequencies of about 6GHz. For the magnitude of the coupling and isolation we find -3.5+/-0.5dB and at least -15dB, respectively, in a bandwidth of 2GHz. We also investigate the effect of reflections at the superconductor-normal conductor contact by means of low temperature laser scanning microscopy. Our measurements show that our hybrid rings are well suited for on-chip applications in circuit quantum electrodynamics experiments.

We use a correlation function analysis of the field quadratures to characterize both the black body radiation emitted by a 50 Ohm load resistor and the quantum properties of two types of beam splitters in the microwave regime. To this end, we first study vacuum fluctuations as a function of frequency in a Planck spectroscopy experiment and then measure the covariance matrix of weak thermal states. Our results provide direct experimental evidence that vacuum fluctuations represent the fundamental minimum quantum noise added by a beam splitter to any given input signal., Comment: 5 pages, 4 figures

Quantum state reconstruction involves measurement devices that are usually described by idealized models, but not known in full detail in experiments. For weak propagating microwaves, the detection process requires linear amplifiers which obscure the signal with random noise. Here, we introduce a theory which nevertheless allows one to use these devices for measuring all quadrature moments of propagating quantum microwaves based on cross-correlations from a dual-path amplification setup. Simultaneously, the detector noise properties are determined, allowing for tomography. We demonstrate the feasibility of our novel concept by proof-of-principle experiments with classical mixtures of weak coherent microwaves., Comment: 11 pages, 3 figures

Superconducting quantum circuits are promising systems for experiments testing fundamental quantum mechanics on a macroscopic scale and for applications in quantum information processing. We report on the fabrication and characterization of superconducting flux qubits, readout dc SQUIDs, on-chip shunting capacitors, and high-quality coplanar waveguide resonators. Furthermore, we discuss the tunability and fundamental symmetry aspects inherent to all superconducting qubits, which can be regarded as artificial solid-state atoms. Comparing them to their natural counterparts, we discuss first and second-order energy shifts due to static control fields. Additionally, we present an intuitive derivation of the first- and second-order matrix elements for level transitions in the presence of a coherent microwave driving., Comment: 20 pages, 7 figures, accepted for publication in Supercond. Sci. Technol

When a quantum dot is subjected to a thermal gradient, the temperature of electrons entering the dot can be determined from the dot's thermocurrent if the conductance spectrum and background temperature are known. We demonstrate this technique by measuring the temperature difference across a 15 nm quantum dot embedded in a nanowire. This technique can be used when the dot's energy states are separated by many kT and will enable future quantitative investigations of electron-phonon interaction, nonlinear thermoelectric effects, and the effciency of thermoelectric energy conversion in quantum dots., Comment: 6 pages, 5 figures

We present a method for the measurement of a temperature differential across a single quantum dot that has transmission resonances that are separated in energy by much more than the thermal energy. We determine numerically that the method is accurate to within a few percent across a wide range of parameters. The proposed method measures the temperature of the electrons that enter the quantum dot and will be useful in experiments that aim to test theory which predicts quantum dots are highly-efficient thermoelectrics., Comment: 3 pages, 4 Figures

Based on ab initio total energy calculations we show that two magnetic states of rhodium atoms together with competing ferromagnetic and antiferromagnetic exchange interactions are responsible for a temperature induced metamagnetic phase transition, which experimentally is observed for stoichiometric alpha-FeRh. A first-principle spin-based model allows to reproduce this first-order metamagnetic transition by means of Monte Carlo simulations. Further inclusion of spacial variation of exchange parameters leads to a realistic description of the experimental magneto-volume effects in alpha-FeRh., Comment: 10 pages, 13 figures, accepted for publication in Phys. Rev. B