Search

A novel method for controlling the rebound behavior of small balls made of Al2O3 with a radius of 2.381 mm is presented. It uses different types of micro-structured surfaces of soft magnetoactive elastomers. These surfaces were fabricated via laser micromachining and include fully ablated surfaces as well as micrometer-sized lamellas with a fixed width of 90 µ m, height of 250 µ m and three different gap sizes (15, 60 and 105 µ m). The lamellas can change their orientation from edge-on to face-on configuration according to the direction of the external magnetic field from a permanent magnet. The orientation of the external magnetic field significantly influences the rebound behavior of the balls, from a coefficient of restitution e of ≈ 0.5 to < 0.1. The highest relative change in the coefficient of restitution between zero field and face-on configuration of ≈ 80 % is observed for lamellas with a gap of 60 µ m. Other characteristics of the ball rebound such as the penetration depth into an Magnetoactive elastomer and the maximum deceleration are investigated as well. The proposed method does not require a constant power supply due to the use of permanent magnets. It may find novel applications in the field of impact engineering. [ABSTRACT FROM AUTHOR]

A simple method for structuring of the surface of a magnetoactive elastomer (MAE) on the tens of micrometers scale, which capabilities extend beyond conventional mold‐based polymer casting, is reported. The method relies on the ablation of the material by absorption of nanosecond infrared pulses from a commercial laser. It is shown that it is possible to fabricate parallel lamellar structures with a high aspect ratio (up to 6:1) as well as structures with complex scanning trajectories. The method is fast (fabrication time for the 7 × 7 mm2 is about 60 s), and the results are highly reproducible. To illustrate the capabilities of the fabrication method, both orthogonal to the MAE surface and tilted lamellar structures are fabricated. These magnetosensitive lamellae can be easily bent by ±45° using an external magnetic field of about 230 mT. It is demonstrated that this bending allows one to control the sliding angle of water droplets in a great range between a sticky (>90°) and a sliding state (<20°). Perspectives on employing this fabrication technology for magnetosensitive smart surfaces in microfluidic devices and soft robotics are discussed. [ABSTRACT FROM AUTHOR]