Search

A hybrid energy-efficient, area-efficient, low-complexity switching scheme in SAR ADC for biosensor applications is proposed. This scheme is a combination of the monotonic technique, the MSB capacitor-splitting technique, and a new switching method. The MSB capacitor-splitting technique, as well as the reference voltage Vaq allow for more options for reference voltage conversion, resulting in higher area savings and higher energy efficiency. In a capacitor array, the circuit performs unilateral switching during all comparisons except for the second and last two comparisons, reducing the difficulty in designing the drive circuit. The proposed switching scheme saves 98.4% of the switching energy and reduces the number of unit capacitors by 87.5% compared to a conventional scheme. Furthermore, the SAR ADC employs low-noise and low-power dynamic comparators utilizing multi-clock control, low-sampling error-sampling switches based on the bootstrap technique, and dynamic SAR logic. The simulation results demonstrated that the proposed SAR ADC achieves 61.51 dB SNDR, 79.21 dB SFDR and consumes 0.278 μW of power in a 180 nm process with a 1 V power supply, a full swing input signal frequency of 23.33 kHz, and a sampling rate of 100 kS/s. [ABSTRACT FROM AUTHOR]

A low-power SAR ADC with capacitor-splitting energy-efficient switching scheme is proposed for wearable biosensor applications. Based on capacitor-splitting, additional reference voltage Vcm, and common-mode techniques, the proposed switching scheme achieves 93.76% less switching energy compared to the conventional scheme with common-mode voltage shift in one LSB. With the switching scheme, the proposed SAR ADC can lower the dependency on the accuracy of Vcm and the complexity of digital control logic and DAC driver circuits. Furthermore, the SAR ADC employs low-noise and low-power dynamic comparators utilizing multi-clock control, low sampling error sampling switches based on the bootstrap technique, and dynamic SAR logic. The simulation results demonstrate that the ADC achieves a 61.77 dB SNDR and a 78.06 dB SFDR and consumes 4.45 μW of power in a 180 nm process with a 1 V power supply, a full-swing input signal frequency of 93.33 kHz, and a sampling rate of 200 kS/s. [ABSTRACT FROM AUTHOR]

In recent years, due to the rise of the Internet of Things (IoT), various sensors have come to be in great demand for IoT devices. Analog-to-digital converters (ADCs) act as an important part of receivers in sensors. To improve the uptime of IoT devices, a bridged-switch energy-efficient switching scheme for successive approximation register (SAR) ADCs with a low-complexity capacitor drive circuit is proposed. The technique of top-plate sampling and closed-loop charge recycling is used in the proposed switching scheme so that neither the first nor the second comparison consumes switching energy. The third comparison uses bridge switches to connect the subarray to the main array, effectively reducing switching's energy consumption. Only the least significant bit (LSB) is dependent on the accuracy of Vcm; thus, the last comparison consumes little switching energy. The proposed switching scheme achieves an average switching energy value of 47.5 CV2ref, which is 96.52% lower than that of the conventional capacitor switching scheme and reduces the area by 75%. The other major circuit modules employed are bootstrapped switches, a fully dynamic comparator, and dynamic SAR logic. The proposed ADC was simulated under the conditions of 180 nm CMOS process and 1 MS/s, resulting in a 9.8-bit effective number of bits (ENOB), a signal-to-noise and distortion ratio (SNDR) of 60.76 dB, a spurious-free dynamic range (SFDR) of 69.85 dB, a power consumption of 14.7 μW, and a figure of merit (FoM) of 16.55 fJ/conv.-step. [ABSTRACT FROM AUTHOR]