Search

To extend the lifetime, improve the power density and reduce the system cost, the film capacitor is applied to replace the large-volume electrolytic capacitor in motor drives. As the dc-link voltage fluctuates periodically, the rotor position estimation error and operation stability are necessary to be concerned in the position sensorless control methods. A cross-decoupling complex filtering-based position estimation method is investigated for the reduced capacitance interior permanent magnet synchronous motor drive system. Harmonic components of the extended back electromotive force (EEMF) caused by the dc-link voltage fluctuation are analyzed to evaluate the additional rotor position error. A cross-decoupling complex filter realized by the multiple first-order complex filters with different center frequencies is designed to improve the position estimation precision. Harmonics of the EEMF are suppressed and the position error can be eliminated. The estimation precision and operation ability are improved. Experimental results are performed to verify the effectiveness of the proposed method. [ABSTRACT FROM AUTHOR]

The power density can be improved and the system cost can be saved in the reduced dc-link capacitance motor drive system. The line inductance can also be diminished to reduce the system volume further. In previous research works, the active damping control methods mainly concentrated on the drive system equipped with a larger line inductor. In this article, a dc-link voltage estimation feedback-based active damping method is proposed to suppress the grid current harmonics and improve the drive system stability with low line inductance. The dc-link voltage ripple caused by the LC resonance is analyzed to evaluate the direct dc-link voltage feedback-based active damping control method. To improve the damping performance, the resonant component of the dc-link voltage caused by the LC resonance could be obtained through the grid current to establish the feedback control loop. The sampling delay should be compensated to improve the control performance. The stability of the drive system is evaluated by the Nyquist plots of the impedance model, and the grid current is also analyzed, which could satisfy the harmonic requirements of IEC-61000-3-2. Experimental results are performed to verify the effectiveness of the proposed method. [ABSTRACT FROM AUTHOR]

DC-link electrolytic capacitor critically affects the lifetime of the motor drive system. This paper proposes an inverter power control strategy based on dc-link voltage regulation for the electrolytic capacitor-less interior permanent magnet synchronous motor drive system. The dc-link electrolytic capacitor is replaced by a small film capacitor and the power factor correction circuit is also eliminated. Hence, the inverter power should be regulated effectively to achieve high input power factor and low grid current harmonics. The inverter power control loop based on proportional resonant (PR) controller is established to regulate the inverter power into sinusoidal wave. The PR controller can be designed to achieve a high gain at the desired frequency and the parameters are easy to design due to the simple structure. In addition, a power compensation method based on the dc-link voltage regulation is used to diminish the error of inverter power control, which does not depend on the precise calculation and is easy to realize. The effectiveness of the proposed method is demonstrated by the experimental results on an air conditioner. The input power factor can reach 0.992 and the harmonics of grid current are considerably lower than the requirement of EN61000-3-2 standard. [ABSTRACT FROM PUBLISHER]