Search

The generation of biomaterials via 3D printing is an emerging biotechnology with novel methods that seeks to enhance bone regeneration. Alginate and collagen are two commonly used biomaterials for bone tissue engineering and have demonstrated biocompatibility. Strontium (Sr) and Calcium phosphate (CaP) are vital elements of bone and their incorporation in composite materials has shown promising results for skeletal repair. In this study, we investigated strontium calcium polyphosphate (SCPP) doped 3D printed alginate/collagen hydrogels loaded with MC3T3-E1 osteoblasts. These cell-laden scaffolds were crosslinked with different concentrations of 1% SCPP to evaluate the effect of strontium ions on cell behavior and the biomaterial properties of the scaffolds. Through scanning electron microscopy and Raman spectroscopy, we showed that the scaffolds had a granular surface topography with the banding pattern of alginate around 1100 cm−1 and of collagen around 1430 cm−1. Our results revealed that 2 mg/mL of SCPP induced the greatest scaffold degradation after 7 days and least amount of swelling after 24 h. Exposure of osteoblasts to SCPP induced severe cytotoxic effects after 1 mg/mL. pH analysis demonstrated acidity in the presence of SCPP at a pH between 2 and 4 at 0.1, 0.3, 0.5, and 1 mg/mL, which can be buffered with cell culture medium. However, when the SCPP was added to the scaffolds, the overall pH increased indicating intrinsic activity of the scaffold to buffer the SCPP. Moreover, cell viability was observed for up to 21 days in scaffolds with early mineralization at 0.3, 0.5, and 1 mg/mL of SCPP. Overall, low doses of SCPP proved to be a potential additive in biomaterial approaches for bone tissue engineering; however, the cytotoxic effects due to its pH must be monitored closely. [ABSTRACT FROM AUTHOR]

Plants and photosynthetic bacteria hold protein molecular complexes that can efficiently harvest photons. This article presents fundamental studies to harness photochemical activities of photosynthetically active protoplast extracted from Arabidopsis plants. The conversion of photonic energy into electrical energy was characterized in the presence and absence of light. The photoinduced reactions of photosynthesis were measured using a patch clamp measurement system at a constant voltage. The optical characterization was also performed on the extracted protoplast. It showed absorption bands at a number of wavelengths. The current-voltage measurements done on protoplast extracts showed two orders of magnitude increase in current from dark to light conditions. The absorbance measurements showed very large bandwidth for extracted protoplasts. The analysis of the optical data measurements showed that protein complexes obtained from photosynthetic cells overcame the limitation of traditional organic solar cells that cannot absorb light in the visible-near infrared spectrum. The demonstration of electrical power scavenging from the protoplast of the plant can open avenues for bio-- inspired and bio-derived power with better quantum electrical efficiency. [ABSTRACT FROM AUTHOR]

Treatment for critical size defects (CSDs) in bone often use bone grafts to act as a scaffold to help complete healing. Biological scaffolds require bone extraction from the individual or an outside donor while synthetic grafts mostly suffer from poor degradation kinetics and decreased bioactivity. In this study, we investigated a 3D printed scaffold derived from a novel composite bioink composed of alginate and collagen augmented with varying doses from 2 m g/ m L to 20 m g/ m L of 1% strontium-calcium polyphosphate (SCPP) to control biodegradability and fluid uptake. Scaffolds with increased SCPP concentrations showed higher particle density, lesser swelling ratio and greater biodegradability indicating that these critically important properties for bone healing are fine-tunable and highly dependent on SCPP dosing. Clinical Relevance- The dosing of 1% SCPP into porous alginate/collagen scaffolds provides adjustable long-term degradation and material properties suitable for potential in vivo CSD applications.